Contribution of storms to groundwater recharge in the semi‐arid region of Karnataka,India

This paper describes the application of environmental isotopes and injected tracer techniques in estimating the contribution of storms as well as annual precipitation to groundwater recharge and its circulation, in the semi‐arid region of Bagepalli, Kolar district, Karnataka. Environmental isotopes ²H, ¹⁸O and ³H were used to study the effect of storms on the hydrological system, and an isotope balance was used to compute the contribution of a storm component to the groundwater. Some of the groundwater samples collected during the post‐storm periods were highly depleted in stable isotope content with higher deuterium excess relative to groundwater from the pre‐storm periods. Significant variation in deuterium excess in groundwater from the same area, collected in two different periods, indicates the different origin of air masses. The estimated recharge component of a storm event of 600 mm to the groundwater was found to be in the range of 117–165 mm. There was no significant variation in environmental tritium content of post‐storm and pre‐storm groundwater, indicating the fast circulation of groundwater in the system. After completion of the environmental isotope work, an injected radiotracer ³H technique was applied to estimate the direct recharge of total precipitation to the groundwater. The estimated recharge to the groundwater is 33 mm of the 550 mm annual precipitation during 1992. Copyright © 2003 John Wiley & Sons, Ltd.     

Short-term Climate Characteristics at Ny-(A)lesund over the Arctic Tundra Area

Based on the Germany Koldwey Station's 1994-2003 conventional observation hourly data, this paper conducts a statistical analysis on the short-term climate characteristics for an arctic tundra region (Ny-(A)lesund island) where our first arctic expedition station (Huanghe Station) was located. Affected by the North Atlantic warming current, this area has a humid temperate climate, and the air temperature at Ny-(A)lesund rose above 0 ℃ even during deep winter season during our research period. The wind speed in this area was low and appeared most at southeast direction. We find that the temperature at Ny-(A)lesund rose in the faster rate (0.68 ℃/10 a) than those at the whole Arctic area. Compared with the floating ices where our expedition conducted in the Arctic, Ny-(A)lesund was warmer and more humid and had lower wind speed. Comparison of the near surface air temperature derived by NCEP/NCAR reanalysis to the conventional measurements conducted at the Koldwey site in Ny-(A)lesund area shows a good agreement for winter season and a significant difference for summer season.     

Isobaric cooling and anti-clockwise P–T paths in the Variscan Odenwald Crystalline Complex, Germany

Mineral assemblages in Al₂O₃‐rich, SiO₂‐ and K₂O‐poor metapelitic rocks from the western Odenwald Crystalline Complex (Variscan Mid‐German Crystalline Rise, southern Germany) include corundum, spinel, cordierite, sillimanite, garnet and staurolite. Quartz is absent from almost all samples. Therefore, the applicability of conventional geothermobarometry is very limited or even impossible. Detailed petrographic investigation on selected samples permits inference of the sequence of appearance and disappearance of several mineral assemblages. The recognition of such partial re‐equilibration stages and their associated mineral assemblages, together with mineral stabilities predicted from KFMASH pseudosections, enables the determination of the pressure‐temperature (P–T) trajectories experienced by these rocks during the Variscan metamorphism. The rocks were metamorphosed under low‐P/high‐T conditions and underwent an anti‐clockwise P–T evolution. A pressure increase from about 2 kbar to 4 ± 0.5 kbar was accompanied by heating. Peak metamorphic conditions were reached at pressures of 4 ± 0.5 kbar and temperatures of at least 640 °C, probably even higher. The retrograde evolution is characterised by near‐isobaric cooling from ≥ 640 °C to approximately 550 °C. The rocks underwent the anti‐clockwise evolution in a subduction‐related magmatic arc setting. The close spatial association of the low‐P/high‐T rocks with recently discovered metabasic eclogites in the eastern part of the Odenwald Crystalline Complex may indicate a fossil paired metamorphic belt in the Central European Variscides.     

A new stereo‐analytical method for determination of removal blocks in discontinuous rock masses

The paper provides a new stereo‐analytical method, which is a combination of the stereographic method and analytical methods, to separate finite removable blocks from the infinite and tapered blocks in discontinuous rock masses. The methodology has applicability to both convex and concave blocks. Application of the methodology is illustrated through examples. Addition of this method to the existing block theory procedures available in the literature improves the capability of block theory in solving practical problems in rock engineering. Copyright © 2003 John Wiley & Sons, Ltd.     

Hysteresis‐based analysis of overland metal transport

Introducing a concept of equivalent mass depth of flow, this study describes the phenomenon of non‐point source pollutant (metal) transport for pavement (or overland) flow in analogy with wave propagation in wide open channels. Hysteretic and normal mass rating curves are developed for runoff rate and mass of 12 dissolved and particulate‐bound metal elements (pollutants) using the rainfall‐runoff and water quality data of the 15 × 20 m² instrumented pavement in Cincinnati, USA. Normal mass rating curves developed for easy computation of pollutant load are found to be of a form similar to Manning's, which is valid for open channel flows. Based on the hysteresis analysis, wave types for dissolution and mixing of particulate‐bound metals are identified. The analysis finds that the second‐order partial‐differential equation normally used for metal transport does not have the efficacy to describe fully the strong non‐linear phenomena such as is described for various metal elements by dynamic waves. In addition, the proportionality concept of the popular SCS‐CN concept is extended for determining the potential maximum metal mass M_p of all the 12 elements transported by a rain storm and related to the antecedent dry period (ADP). For the primary metal zinc element, M_p is found to increase with the ADP and vice versa. Copyright © 2003 John Wiley & Sons, Ltd.     

The possiblity of detection of ultracool dwarfs with the UKIRT Infrared Deep Sky Survey

We present predictions for the numbers of ultracool dwarfs in the Galactic disc population that could be detected by the WFCAM/UKIDSS Large Area Survey and Ultra Deep Survey. Simulated samples of objects are created with masses and ages drawn from different mass functions and birthrates. Each object is then given absolute magnitudes in different passbands based on empirically derived bolometric correction versus effective temperature relationships (or model predictions for Y dwarfs). These are then combined with simulated space positions, velocities and photometric errors to yield observables such as apparent magnitudes and proper motions. Such observables are then passed through the survey selection mechanism to yield histograms in colour. This technique also produces predictions for the proper motion histograms for ultracool dwarfs and estimated numbers for the as yet undetected Y dwarfs. Finally, it is shown that these techniques could be used to constrain the ultra-low-mass mass function and birthrate of the Galactic disc population.     

Dissolved organic carbon dynamics in two streams draining forested catchments at loch ard,Scotland

Dissolved organic carbon (DOC) was measured at four or eight hour intervals between mid-1989 and mid-1991 in two catchments in west central Scotland. The experimental catchment had been recently clear-felled and the control remained under forest. The amount of DOC varied during individual storm events following the stream hydro-graph. Maximum variations were found in the summer half-year and in the clear-felled catchment. There was also evidence of the exhaustion of DOC in the later events of a sequence. Differences between the catchments were related to catchment characteristics and to land-use change. The reduced magnitude of variation in DOC with discharge in the control stream was due to the influence of a wetland area through which the stream flowed. The mean DOC concentrations were similar in the two streams and annual exports were 15 g m^?2 from the control and 16g m^?2 from the felled catchment. The stream draining the clear-felled catchment had greater high flow DOC concentrations in the summer half-year, probably due to the effect of greater mean summer temperatures on DOC release and of the greater supply of organic debris in the stream channel.     

Detailed <Superscript>40</Superscript>Ar/<Superscript>39</Superscript>Ar dating of geologic events associated with the Mantos Blancos copper deposit,northern Chile

The ⁴⁰Ar/³⁹Ar geochronological method was applied to date magmatic and hydrothermal alteration events in the Mantos Blancos mining district in the Coastal Cordillera of northern Chile, allowing the distinction of two separate mineralization events. The Late Jurassic Mantos Blancos orebody, hosted in Jurassic volcanic rocks, is a magmatic-hydrothermal breccia-style Cu deposit. Two superimposed mineralization events have been recently proposed. The first event is accompanied by a phyllic hydrothermal alteration affecting a rhyolitic dome. The second mineralization event is related to the intrusion of bimodal stocks and sills inside the deposit. Because of the superposition of several magmatic and hydrothermal events, the obtained ⁴⁰Ar/³⁹Ar age data are complex; however, with a careful interpretation of the age spectra, it is possible to detect complex histories of successive emplacement, alteration, mineralization, and thermal resetting. The extrusion of Jurassic basic to intermediate volcanic rocks of the La Negra Formation is dated at 156.3 ± 1.4 Ma (2σ) using plagioclase from an andesitic lava flow. The first mineralization event and associated phyllic alteration affecting the rhyolitic dome occurred around 155–156 Ma. A younger bimodal intrusive event, supposed to be equivalent to the bimodal stock and sill system inside the deposit, is probably responsible for the second mineralization event dated at ca. 142 Ma. Other low-temperature alteration events have been dated on sericitized plagioclase at ca. 145–146, 125, and 101 Ma. This is the first time that two distinct mineralization events have been documented from radiometric data for a copper deposit in the metallogenic belt of the Coastal Cordillera of northern Chile. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Possible chemical structures and biological precursors of different vitrinites in coal measure in Northwest China

Chemical structure of Jurassic vitrinites isolated from the coals in basins in NW China have been checked using solid state ¹³C NMR and flash pyrolysis-GC/MS. Study shows some Jurassic collodetrinites are rich in aliphatic products in pyrolysates, consisting with the high amount of methylene carbon in ¹³C NMR spectra. In contrast, pyrolysates of Jurassic collotelinites are rich in phenols and alkylbenzenes. Also one Pennsylvanian and one Permian vitrinite selected from the Ordos basin, NW China have been checked for comparison. The proportion of aliphatics is low in pyrolysates, and aliphatic carbon peak in ¹³C NMR spectrum of Permian vitrinite is mostly composed of gas-prone carbons compared with collodetrinites in those Jurassic basins. But both pyrolysis and ¹³C NMR data shows the Pennsylvanian vitrinite is not only gas-prone but also oil-prone. Relatively high proportion of long chain aliphatic structure of some Jurassic vitrinite in Junggar, Turpan-Hami basins may be due to the contribution of liptodetrinites, which may be included during the formation of vitrinites. And it seems that suberinite is the most possible precursor of long chain aliphatics in the structure of Jurassic collodetrinite.     

Sulfur isotope measurement of sulfate and sulfide by high-resolution MC-ICP-MS

We have developed a technique for the accurate and precise determination of ³⁴S/³²S isotope ratios (δ³⁴S) in sulfur-bearing minerals using solution and laser ablation multiple-collector inductively coupled plasma mass spectrometry (MC-ICP-MS). We have examined and determined rigorous corrections for analytical difficulties such as instrumental mass bias, unresolved isobaric interferences, blanks, and laser ablation- and matrix-induced isotopic fractionation. Use of high resolution sector-field mass spectrometry removes major isobaric interferences from O₂⁺. Standard-sample bracketing is used to correct for the instrumental mass bias of unknown samples. Background on sulfur masses arising from memory effects and residual oxygen-tailing are typically minor (< 0.2‰, within analytical error), and are mathematically removed by on-peak zero subtraction and by bracketing of samples with standards determined at the same signal intensity (within 20%). Matrix effects are significant (up to 0.7‰) for matrix compositions relevant to many natural sulfur-bearing minerals. For solution analysis, sulfur isotope compositions are best determined using purified (matrix-clean) sulfur standards and sample solutions using the chemical purification protocol we present. For in situ analysis, where the complex matrix cannot be removed prior to analysis, appropriately matrix-matching standards and samples removes matrix artifacts and yields sulfur isotope ratios consistent with conventional techniques using matrix-clean analytes. Our method enables solid samples to be calibrated against aqueous standards; a consideration that is important when certified, isotopically-homogeneous and appropriately matrix-matched solid standards do not exist. Further, bulk and in situ analyses can be performed interchangeably in a single analytical session because the instrumental setup is identical for both. We validated the robustness of our analytical method through multiple isotope analyses of a range of reference materials and have compared these with isotope ratios determined using independent techniques. Long-term reproducibility of S isotope compositions is typically 0.20‰ and 0.45‰ (2σ) for solution and laser analysis, respectively. Our method affords the opportunity to make accurate and relatively precise S isotope measurement for a wide range of sulfur-bearing materials, and is particularly appropriate for geologic samples with complex matrix and for which high-resolution in situ analysis is critical.