多接收器电感耦合等离子体质谱法测定镉标准溶液中镉的同位素组成

建立了多接收器电感耦合等离子体质谱仪对Cd标准溶液同位素组成进行分析的实验方法。仪器的质量分馏校正采用Standard-Sample Bracketing法。实验结果用δ114/110Cd来表达。在此研究基础上,以SPEX Cd标准溶液为参考标准,对国外4种Cd标准溶液进行了测定。结果表明,实验测定的精度在0.07‰~0.13‰(δ114/110Cd),与目前文献报道的结果具有相似的精度。以最新SPEX Cd标准样品(δ114/110Cd=0)为基准,计算的δ114/110CdJMC、δ114/110CdSPEX-1、δ114/110CdBAM1012和δ114/110CdM櫣nster的值分别为0.55‰、0.56‰、-0.65‰和5.14‰,说明不同批次SPEX标准溶液的Cd同位素组成是明显不同的,最新的SPEX Cd标准溶液与SPEX-1 Cd的δ114/110Cd值存在着0.56‰的差别。将以SPEX Cd为参考标准的δ114/110CdBAM1012和δ114/110CdM櫣nster转化为以SPEX-1或JMC为参考标准后,得到的结果与文献报道的结果在误差范围内一致。     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Artificial Upwelling of Deep Seawater Using the Perpetual Salt Fountain for Cultivation of Ocean Desert

Deep seawater in the ocean contains a great deal of nutrients. Stommel et al. have proposed the notion of a “perpetual salt fountain” (Stommel et al., 1956). They noted the possibility of a permanent upwelling of deep seawater with no additional external energy source. If we can cause deep seawater to upwell extensively, we can achieve an ocean farm. We have succeeded in measuring the upwelling velocity by an experiment in the Mariana Trench area using a special measurement system. A 0.3 m diameter, 280 m long soft pipe made of PVC sheet was used in the experiment. The measured data, a verification experiment, and numerical simulation results, gave an estimate of upwelling velocity of 212 m/day. This revised version was published online in July 2006 with corrections to the Cover Date.     

基于规则波波形的超声波非接触测量有关问题探讨

波浪波形的非接触测量近年来获得广泛的应用。本文以规则波为讨论对象，针对介质为空气的超声波测量方式进行波形测量误差分析，并结合实验室和实船试验进行对比分析。理论分析表明：在规则波取为坦谷波和ＳＴＯＫＥＳ波的前提下，超声波技术几乎产生相同的最大误差。定量分析表明，在对测量精度限制的条件下，对文中提及的各项参数应作有效的控制     

耗氧速率(OUR)测量方法的实验研究

目前多采用分批实验法和呼吸测量仪测量耗氧速率,而耗氧速率的测量对于研究活性污泥数学模型中的动力学参数及废水特性鉴定具有重要意义。本文根据OUR测量方法的基本原理设计了1种简易的OUR测量装置,为检验测量装置的有效性,设计了相关实验进行验证。在内源呼吸实验中,测定了所用活性污泥的内源呼吸速率是5.1mgO2/L·h,污泥的衰减系数是0.0137h-1,比文献值略高。基质降解实验对人工配水(葡萄糖和淀粉)的耗氧速率进行了测定,实验结果显示有3个显著不同的耗氧速率,分别为35mg/L·h,13mg/L·h,6mg/L·h,它们各代表葡萄糖降解、淀粉降解和内源呼吸的速率。内源呼吸速率高于前1个实验是由于基质降解过程中污泥量增加所致。并计算出异养菌产率系数Kd为0.63mgVSS/mgCOD,Kd略低于文献值。实验结果证明,该装置能很好的实现测量目的。     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.     

动态基准实时测量系统的开发与应用

介绍了动态基准实时测量系统的硬件组成、站点上全站仪棱镜组合安装与检测方法、系统软件的开发及特点，最后对系统在广州地铁某地铁站结构变形自动监测中的应用情况进行了阐述。通过实际应用表明该系统能应用在自动化、高精度的变形监测领域。     

南沙群岛海域水体漫衰减系数Kd(490)的特性研究

对南沙群岛海区水体Kd(490）的特性进行了深入分析和探讨,研究结果表明：Kd（490）的垂直分布与同步测量的海水叶绿素a浓度的垂直分布有很强的相关性;Kd（490）的垂直分布反映出该区域海水存在较强的分层现象,研究中还发现上行辐亮度漫衰减系数KL（490）与Kd（490）垂直变化趋势相当一致,但是以二者达到最大值的深度为界,上层水体的KL（490）值稍大于Kd(490）值,在这一深度以下则相反。     

Experimental investigation on a two-part underwater towed system

An experimental set-up is developed and proved to be effective for laboratory study of an underwater towed system. The experimental technique gives a practical method for monitoring the kinematic and dynamic performance of an underwater towed system in a ship towing tank. Both the theoretical and experimental results in the investigation indicate that the hydrodynamic response of a towed vehicle to the wave induced motion of a towing ship can be significantly reduced by applying a two-part tow method. A comparison of the numerical and experimental results in the investigation demonstrates that the numerical simulation results are close to the experimental data, overall agreement between experimental and theoretical results is satisfactory. The results qualitatively verify the mathematical model of a two-part underwater towed system proposed by Wu and Chwang [Wu, J., Chwang, A.T., 2000. A hydrodynamic model of a two-part underwater towed system. Ocean Engineering 27 (5), 455–472].     

GPS数据采集技术及其在海洋调查中的应用

本文应用VB6．0开发了智能化的GPS数据采集软件．对该软件的功能进行了简单的介绍，同时对一些关键技术作了较详细的描述。利用该软件、GPS接收机及PC机的组合，可对走航式测量仪器(或移动设备)进行实时定位并保存定位记录，且大大减少一些不必要的数据，使得软件更为实用。