1960~2011年中国日降水集中程度的时空变化特征

利用1960~2011 年的日降水资料,计算降水集中指数（Concentration Index,CI）,分析中国区域降水集中程度的空间分布及时间变化特征,得到以下主要结论：CI 指数可有效描述我国日降水集中程度;我国CI 指数介于0.575 与0.750 之间,平均为0.652,总体呈现出东部大、西部小,夏季大、冬季小的特征;44.17%站点的CI 指数表现出增加趋势,55.83%的站点表现出减少趋势,其中10.36%站点的变化趋势通过95%信度水平的显著性检验,CI 指数显著增大的站点主要分布在西北、华中和西南地区,显著减小的站点主要分布在东北、华北、东南沿海及青藏高原东部等地区;3~5 年是各子区域CI 指数变化的主要周期,与对应区域降水量的变化周期较一致;1970 年左右和2000 年左右是显著周期性变化出现较集中的时间段。     

采油平台淘空防护措施的试验研究

通过室内试验,研究了采油平台的冲淘机理和防护措施,对仿生海底、仿生林、抛石块、抛石子袋等防冲淘措施进行了方案设计和试验,完成了导管架式、桶形基础式、沉垫式3种采油平台的冲淘及防护措施试验研究,提出和完善了多层次抛石防护技术,并将研究成果成功应用于海上防护工程.提出的研究思路以及得到的研究成果,对解决胜利油田海区粉土地基的防冲淘难题具有重要指导意义.     

日照帆船港工程泥沙运移物模试验研究

通过动床波浪输沙模型试验,研究了日照帆船港3种设计方案的泥沙运移情况.通过分析试验结果,预报了常浪和大浪作用下工程区的冲淤分布.结果表明,日照帆船港工程的建设不会对邻近海岸产生大的影响,航道和港池均不会出现大的淤积.但是,为防止堤脚冲刷,应在挡沙坝堤脚处设置护脚结构.     

单元畸变对动力有限元方法计算精度的影响

在有限元分析中,由于求解区域或边界的不规则,有限单元的划分会产生畸变单元。本文通过数值试验分析了有限单元畸变对动力有限元计算精度的影响,结果表明:长宽比畸变对动力有限元计算精度没有影响;当斜交角不小于30°时,斜交角对动力有限元计算精度的影响可忽略;锥度对动力有限元计算精度有影响,锥度越大,锥度对动力有限元计算精度的影响越大。     

ICT切片重构模型的剖切及应用

在ICT切片重构模型的可视化中,为了分析重构模型的任意截面形状,并且观察该截面的内部结构,需要对重构模型进行剖切.本文针对剖切提出一种简单方法,该方法利用剖切面对重构模型所在的立方体图像空间进行剖切,生成交点集合,然后将空间剖切平面映射到二维图像平面上,最后计算空间剖切平面图像的灰度值,得到剖面图像.通过剖面图像,可以直观地看到内部结构形状,为后续无损检测奠定基础.     

高压喷射注浆技术在白龟山水库顺河坝防渗墙围井试验中的应用

本次围井高喷试验,选用三重管摆喷法处理方案,施工采用两序施工方法.砼墙体连续均匀,孔与孔之间连接较好,其防渗、强度、厚度均能满足设计要求.     

Stability Study of a Tide Embankment Subjected to Sea Level Variations Using Centrifugal Model Tests

To investigate the behavior of dredged-sea-sand fill compacted inside tide embankments with a damaged geosynthetic mat, centrifugal model tests and numerical simulation were conducted, both considering variations in sea level. The results from the three centrifugal model tests demonstrate that the subsidence of the dredged-sea-sand fill inside tide embankments with a damaged geosynthetic mat was strongly affected by the loss of dredged-sea-sand into the filter layers with large particles and a decrease in the bearing capacity of the filter layers with small particles. In addition, a comparison of the test and simulation results confirms that the loss of sand into the filter layer and the subsidence of the dredged-sea-sand fill were well reproduced by the numerical simulation.     

Evaluation of Liquefaction Potential Index Along Western Coast of South Korea Using SPT and CPT

For South Korea, liquefaction potential along the western coast has not been widely assessed because South Korea is considered to be a low seismic hazard. However, recent earthquake events and historical records indicate that the seismic hazard of South Korea should not be ignored. Moreover, as artificial fills are extensively used along the western coast for development, liquefaction evaluation of the soils in this area is necessary. In this paper, we present: (1) the seismic characteristics of the study area; (2) procedures for evaluating liquefaction potential, focusing on the liquefaction potential index (LPI) approach; and (3) LPI distributions at several representative locations along the western coast of South Korea under various seismic scenarios. The liquefaction potential index represents the liquefaction potential over the upper 20 m of a boring or sounding. Using cone penetration test (CPT) and standard penetration test (SPT) data from two coastal sites, we compare and discuss CPT-based and SPT-based LPI values, particularly values computed in nonplastic, silt-rich soils. In these soils, it appears that the CPT yields lower liquefaction resistance, resulting in large LPI values. Finally, discussion and suggestions are provided for CPT- and SPT-based liquefaction assessment of low plasticity and high fines content soils.     

Comparison of vane shear and fall cone strengths of soft marine clay

A total of 1,014 measures of sediment shear strengths were measured by means of miniature vane shear and fall cone tests on five gravity cores collected in Eckernfo‐erde Bay, Baltic Sea. Paired t test was used to compare the shear strengths measured by the two methods. It was found that fall cone strength calculated with Wood's K₆₀value (0.29) overestimates the vane shear strength by 0.15 kPa (a = 0.001) and the sample mean of the fall cone strength is 4.1% higher than the mean of the vane shear strength. However, fall cone strength calculated with Hansbo's K₆₀ value (0.24) underestimates the vane shear strength by 0.88 kPa (a = 0.001), and the sample mean of the fall cone strength is 13.8% less than the mean of the vane shear strength. Both calculated fall cone strengths are significantly different from the vane shear strength, with a p value of less than 0.001. Regression analysis of the Echernfoerde Bay data indicates that a new K₆₀ value is 0.275 with a confidence interval (a = 0.01) from 0.2704 to 0.2786. Paired t test shows that there is no significant difference between miniature vane shear and fall cone tests for these samples if the fall cone strength is calculated with K₆₀ = 0.275.     

烟台海域海岛自动站大风对比试验

烟台北部面临黄、渤海,海岛自动站分布众多.我们发现,在同一大风过程中,各海岛自动站的风速、风向因为海拔高度、周围地形影响、下垫面摩擦的不同造成明显差异.本文主要以长岛作为渤海海峡大风的代表站,以崆峒岛和芝罘岛作为烟台北部沿海海域大风的代表站,利用便携自动站的观测数据近似代表海面大风的实况,与代表站进行大风的对比试验,对比试验的数据均采用指数廓线公式订正到海面10m高度.分析了三个海岛自动站的不同风向下的海面大风的实际代表性,并给出不同风向下的大风订正值.