Air-sea carbon-dioxide flux estimated by eddy covariance method from a buoy observation

Precise measurements of the CO2 gas transfer across the air-sea interface provide a better understanding of the global carbon cycle.The air-sea CO2 fluxes are obtained by the eddy covariance method and the bulk method from a buoy observation in the northern Huanghai sea.The effects of buoy motion on flux calculated by the eddy covariance method are demonstrated.The research shows that a motion correction can improve the correlation coefficient between the CO2 fluxes estimated from two different levels.Without the CO2-H2 O cross-correlation correction which is termed as PKT correction,the air-sea CO2 fluxes estimated by eddy covariance method using the motion corrected data are nearly an order of magnitude larger than those estimated by the bulk method.After the CO2-H2 O cross-correlation correction,some eddy covariance CO2 fluxes indeed become closer to the bulk CO2 flux,whereas some are overcorrected which are in response to small water vapor flux.     

一种适合海洋环境温度测量的新方法

介绍了一种崭新的海洋环境温度测量方法,也可以说是一种崭新的温度测量传感器。它直接输出温度数字量,连接PC机极为方便。文中介绍了该方法的测量原理和特点;介绍了室内和海上的试验情况,给出了试验数据和曲线;展望了广阔的应用前景。     

金属电极在含油模拟海水中电化学行为的研究

采用电化学阻抗和恒电位阶跃技术研究了金属铂和镍电极在含油氯化钠溶液中的电化学行为特征,测量了不同含油量体系中电化学信号的变化,并建立了相应的等效电路.实验结果表明,同样条件下多孔电极比平面电极的电化学信号响应显著,泡沫镍电极与铂黑电极相比对含油量的响应则更为明显.     

落球法测量高频振动对淤泥的液化效果

为了提高疏浚工程中管道输送淤泥的效率,对淤泥预处理技术——高频微幅振动液化技术进行了初步研究。主要介绍了落球法测量淤泥粘滞系数的实验,对不同性质的淤泥分别进行实验,根据距离振动棒不同位置的小球的沉降速度求出相应位置的粘滞系数,并将其进行比较,获得液化影响范围。实验结果表明,高频振动对于粉砂质淤泥具有良好的液化效果。     

极限波浪运动特性的非线性数值模拟

利用时域高阶边界元方法建立了模拟极限波浪运动的完全非线性数值模型,其中自由水面满足完全非线性自由水面条件.采用半混合欧拉-拉格朗日方法追踪流体瞬时水面,运用四阶Runge-Kutta方法更新下一时间步的波面和速度势,同时应用镜像格林函数消除水槽两个侧面和底面上的积分.研究中利用波浪聚焦的方法产生极限波浪,并且在水槽中开展了物理模型实验,将测点试验数据与数值结果进行了对比,两者吻合得很好.对极限波浪运动的非线性和流域内速度分布进行了研究.     

黄河水下三角洲海底管道沉降量确定方法研究

提出一种海底管道沉降计算方法——递推法,应用到胜利油田埕岛海域海底管道沉降计算中,并将计算结果与目前常用的日本规范法和极限法进行比较。研究发现在粉土与粉质粘土为主的强度较高的海床上,递推法与日本规范法计算结果比较接近,极限法的最小;在淤泥质土组成的强度较低的海床上,日本规范法的计算值最大,递推法的居中,极限法的最小。逆推法可计算裸置和埋设两种形式的管道沉降量,而另外两者只能计算裸置管道的沉降。文中进一步讨论了引起管道沉降的影响因素,土体强度和压缩性对管道沉降影响较大。且管道埋深越大,沉降也越大。最后分析了黄河水下三角洲埕岛海域4个区的管道沉降量,Ⅰ区争Ⅱ区管道沉降较小,可以忽略,Ⅳ区沉降较大,在淤泥质软土上的管道,可能会完全陷入土中。     

Microbial photosynthesis in coral reef sediments (Heron Reef, Australia)

We investigated microphytobenthic photosynthesis at four stations in the coral reef sediments at Heron Reef, Australia. The microphytobenthos was dominated by diatoms, dinoflagellates and cyanobacteria, as indicated by biomarker pigment analysis. Conspicuous algae firmly attached to the sand grains (ca. 100 μm in diameter, surrounded by a hard transparent wall) were rich in peridinin, a marker pigment for dinoflagellates, but also showed a high diversity based on cyanobacterial 16S rDNA gene sequence analysis. Specimens of these algae that were buried below the photic zone exhibited an unexpected stimulation of respiration by light, resulting in an increase of local oxygen concentrations upon darkening. Net photosynthesis of the sediments varied between 1.9 and 8.5 mmol O₂ m⁻² h⁻¹ and was strongly correlated with Chl a content, which lay between 31 and 84 mg m⁻². An estimate based on our spatially limited dataset indicates that the microphytobenthic production for the entire reef is in the order of magnitude of the production estimated for corals. Photosynthesis stimulated calcification at all investigated sites (0.2–1.0 mmol Ca²⁺ m⁻² h⁻¹). The sediments of at least three stations were net calcifying. Sedimentary N₂-fixation rates (measured by acetylene reduction assays at two sites) ranged between 0.9 to 3.9 mmol N₂ m⁻² h⁻¹ and were highest in the light, indicating the importance of heterocystous cyanobacteria. In coral fingers no N₂-fixation was measurable, which stresses the importance of the sediment compartment for reef nitrogen cycling.     

Assessment of boundary-element method for modelling a free-floating sloped wave energy device. Part 1: Numerical modelling

The boundary-element method has been widely used as a design tool in the offshore and ship building industry for more than 30 years. Its application to wave energy conversion is, however, more recent. This paper deals with the numerical modelling of a free-floating sloped wave energy device. The power take-off mechanism of the device consists of an immersed tube with a piston sliding inside. The modelling is done using the boundary-element method package WAMIT. The model is first worked out for the case where the axis of the tube is vertical. It is then derived for the tube inclined and successfully verified against numerical benchmark data. A companion paper presents results of a detailed comparison with a physical model study.     

Numerical calculation of free-surface potential flow around a ship using the modified Rankine source panel method

A modified Rankine source panel method is presented for solving a linearized free-surface flow problem with respect to the double-body potential. The method of solution is based on the distribution of Rankine sources on the hull as well as its image and on the free surface. An iterative algorithm is used for determining the free surface and wave resistance using upstream finite difference operator. A verification of numerical modeling is made using the Wigley hull and the validity of the computer program is examined by comparing the details of wave profiles and wave making resistance with Series 60 model.     

Solution of the propagation of the waves in open channels by the transfer matrix method

Many problems in mechanics can be solved by the use of the transfer matrix method. The use of this method in hydraulics engineering is not widespread and only limited studies are available. In this study, linearized St. Venant equations were used and the use of transfer matrix in ocean engineering was investigated for long waves in open channels, and numerical application was carried out. The results obtained through the transfer matrix method, which is quite easy to use, program and comprehend, showed similar results obtained from the characteristics method and finite differences method.