基于蒙特卡罗法的多级黄土滑坡可靠性分析

滑坡稳定性分析目前工程中一般采用极限平衡算法。为了确定滑坡的稳定性系数,在计算过程中要将岩土体、计算模型简化,忽略一些影响滑坡稳定的次要因素,把影响滑坡稳定的各种主要因素作为确定参数。由于滑坡岩土体本身的非均质性及其参数确定具有随机性和变异性,用唯一的稳定系数不能客观地反映整个滑坡的真实安全程度。以陕西省夏呀河滑坡为例,通过野外详细调查、工程勘探和室内土工试验,初步确定该滑坡存在四级滑动面,难以用简单的单一滑动面计算其稳定性。因此,先采用推力传递系数法对滑坡体上的四级滑坡分别进行滑坡稳定性计算,得到该滑坡体上的四级滑坡稳定系数。再采用蒙特卡罗法对该四级滑坡进行可靠性分析,得到其可靠度,定量地表达夏呀河四级滑坡的安全程度。同时对比分析夏呀河四级滑坡的稳定系数和失稳概率,综合评价该滑坡体上的四级滑坡的稳定性及其风险概率,为滑坡的工程治理及预测预警、灾害危险性评价提供依据。     

人工边坡潜在滑动面研究——以广州科学城某人工高边坡为例

运用强度参数的改变对边坡破坏面形迹影响不明显这一特点,在数值模拟过程中通过改变岩体强度参数,有效地获取潜在滑动面的位置和形态,较好地解决了滑动面搜索的难题。将该法应用于广州科学城某人工高边坡稳定性的研究,在三维数值模拟过程中,将强度参数大幅度折减,计算后获得各剖面的剪应变增量图,从这些图中可获得潜在滑动面。这与人们通常将此类边坡的中风化面作为滑动面存在较大差别。将该滑动面运用极限平衡法进行计算,计算结果显示各剖面的安全系数基本都大于1.2,边坡稳定但仍需要加固处理,与三维数值模拟结果相一致。由此认为用这种分析法确定出的潜在滑动面合理、计算结果可靠,可作为搜索边坡潜在滑动面并计算安全系数的方法之一。     

努力提高三维地震勘探精度，为西部煤炭工业做出新贡献

以国家重大产业技术开发专项“西部煤炭资源高精度三维地震勘探技术”项目的由来、意义和总体研究目标为引,概括的介绍了项目依托工程中各个专项技术研究完成情况,并对非均匀介质成像技术、高精度三维地震静校正技术、高密度采集技术、特观技术、岩性反演技术、属性体解释技术等六项重大关键技术取得的突破性进展进行了重点说明。指出随着我国煤炭生产重点的逐步西移,应加强诸如叠前、叠后深度偏移技术的研究,以解决复杂山区三维地震面元内地震反射波散射问题,提高其三维地震勘探精度,为西部煤炭工业做出新贡献!     

Multi-Scale Texture Modeling

Patterns of crystallographic preferred orientation are referred to as texture. The specific subject of texture analysis is the experimental determination and interpretation of the statistical distribution of orientations of crystals within a specimen of polycrystalline material, which could be metals or rocks. The objective is to relate an observed pattern of preferred orientation to its generating processes and vice versa. In geosciences, texture of minerals in rocks is used to infer constraints on their tectono-metamorphic history. Since most physical properties of crystals, such as elastic moduli, the coefficients of thermal expansion, or chemical resistance to etching depends on crystal symmetry and orientation, the presence of texture imparts directional properties to the polycrystalline material. A major issue of mathematical texture analysis is the resolution of the inverse problem to determine a reasonable orientation density function on SO(3) from measured pole intensities on , which relates to the inverse of the totally geodesic Radon transform. This communication introduces a wavelet approach into mathematical texture analysis. Wavelets on the two-dimensional sphere and on the rotational group SO(3) are discussed, and an algorithms for a wavelet decomposition on both domains following the ideas of Ta-Hsin Li is given. The relationship of these wavelets on both domains with respect to the totally geodesic Radon transform is investigated. In particular, it is shown that the Radon transform of these wavelets on SO(3) are again wavelets on . A novel algorithm for the inversion of experimental pole intensities to an orientation density function based on this relationship is developed.     

浅谈（TCP）射孔技术在松辽地区应用与发展

油管传佃式射孔是近几年来射孔新技术,应用于石油、天燃气勘探、开发井中。的使用,大大提高了油气井的射孔效率,增加油气产量,降低了作业成本,从而能获得较好的经济效益,解决了正压射孔存在的不足,是一项新的负压射孔方式。通过几年来在松辽地区的应用,效果很佳。大部分的高产油气流都是采用这种射孔方法进行的。     

Surface renewal analysis for sensible and latent heat flux density

High frequency temperature measurements were recorded at five heights and surface renewal (SR) analysis was used to estimate sensible heat flux density (H) over 0.1 m tall grass. Traces of the temperature data showed ramp-like structures, and the mean amplitude and duration of these ramps were used to calculate H using structure functions. Data were compared with H values measured with a sonic anemometer. Latent heat flux density (E) was calculated using an energy balance and the results were compared with E computed from the sonic anemometer data. SR analysis provided good estimates of H for data recorded at all heights but the canopy top and at the highest measurement level, which was above the fully adjusted boundary layer.     

Densities of Huanghe River estuary and Bohai Bay waters

The densities of 36 water samples from the Huanghe River estuary and Bohai Bay were determinedby a magnetic float densimcter under three temperatures from 15℃ to 25℃.All the measured densities ofsamples were greater than that of the values calculated from the International Equation of State of Seawater.The differences between the measured and calculated densities increased with the decrease of salinities.The dif-ferences appeared exponentially correlated with[Ca~(2+)]/s,[Mg~(2+)]/s and[SO_4~(2-)]/s,and had"s"type curverelationship with the alkalinity in all salinity range.But in the salinity ranging from 25.72 to 31.57,therelationships were all linear.The density difference can be estimated from the equation △ρ（10~3kg·m~(-3)）=（-2.79+236.5([Ca~(2+)]/s)/(-9.7464×10~（-3）+[Ca~(2+)]/s).It was the high alkalinity and[Ca~(2+)]/s that resulted in the measured densi-ties of seawaters being higher than the calculated densities in the Huanghe estuary and Bohai Bay.     

勘查油气田化探新方法——土壤相态烃测量法

烃气测量是油气化探最主要的方法。目前应用的烃气测量方法有两类:一类是测量土壤中游离烃气如K—V指纹法、吸附丝法、物上气法及直接取土壤气测量法等。此类方法由于需特殊设备及壤气测量方法本身固有的缺陷,目前还未得到普遍应用,另一类为土壤吸附烃气法即国内外目前普遍使用的酸解烃气法、此法在多数油气田上取得好效果,但也有相当多的地区如黄土、荒漠及水网发育等特殊景观区效果不好或不显著。本文介绍一种新的烃气测量法──土壤相态烃测量法。这是用一种特殊的技术,只选择性提取由油气藏渗漏过程中保存在运移通道围岩及近地表土壤各种次生矿物结构中以"穴居"态存在的轻烃组分。"穴居"态烃为累积性的指标,不受外界温度、修水等的影响,保存较牢固,测定结果稳定。相态烃法避免了酸解烃法存在的生物成因烃、矿物同生烃及碳酸盐的干扰影响,提高了测量指标的信噪比,突出了应有的异常。本方法已在黄土厚覆盖区两个已知油气田和一个风成沙覆盖的断裂发育油田上试验获得成功,结果表明相态烃法优于酸解烃法。     

The deposit size frequency method for estimating undiscovered uranium deposits

The deposit size frequency (DSF) method has been developed as a generalization of the method that was used in the National Uranium Resource Evaluation (NURE) program to estimate the uranium endowment of the United States. The DSF method overcomes difficulties encountered during the NURE program when geologists were asked to provide subjective estimates of (1) the endowed fraction of an area judged favorable (factorF) for the occurrence of undiscovered uranium deposits and (2) the tons of endowed rock per unit area (factorT) within the endowed fraction of the favorable area. Because the magnitudes of factorsF andT were unfamiliar to nearly all of the geologists, most geologists responded by estimating the number of undiscovered deposits likely to occur within the favorable area and the average size of these deposits. The DSF method combines factorsF andT into a single factor (F·T) that represents the tons of endowed rock per unit area of the undiscovered deposits within the favorable area. FactorF·T, provided by the geologist, is the estimated number of undiscovered deposits per unit area in each of a number of specified deposit-size classes. The number of deposit-size classes and the size interval of each class are based on the data collected from the deposits in known (control) areas. The DSF method affords greater latitude in making subjective estimates than the NURE method and emphasizes more of the everyday experience of exploration geologists. Using the DSF method, new assessments have been made for the young, organic-rich surficial uranium deposits in Washington and idaho and for the solution-collapse breccia pipe uranium deposits in the Grand Canyon region in Arizona and adjacent Utah.     

山东省日照市蓝色经济区工程建设适宜性评价

本文以山东省日照市蓝色经济区为研究区, 通过野外地质调查和室内综合分析, 选取场地稳定性、工程地质条件、地下水条件, 地形排水条件、地质灾害及其他因素6个一级评价因子, 构造活动、场地土类型、建筑场地类别等13个二级评价因子, 利用专家-层次分析定权法进行区内工程建设适宜性评价, 得到了相应工程建设评价分区图。评价结果表明, 日照市场地工程建设适宜性总体较好, 大部分地区适宜进行高层建筑工程建设, 占84.50%; 地下空间开发利用条件优越, 全区多数地区属于城市地下空间建设适宜区, 适宜性差及不适宜区主要分布在付疃河两岸附近和海岸附近、大型高速公路和铁路沿线一带区域及城区; 轨道交通建设适宜性良好, 小部分不适宜区主要集中在付疃河下游夹仓和小古镇一带及其沿海地区。评价结果可有效地服务于该地区规划布局、建设发展和工程选址, 具有重要的理论和实践指导意义。