Holocene-emerged notches and tectonic uplift along the Jalisco coast, Southwest Mexico

This paper presents the preliminary results from a study of Holocene-emerged shorelines, marine notches, and their tectonic implications along the Jalisco coast. The Pacific coast of Jalisco, SW Mexico, is an active tectonic margin. This coast has been the site of two of the largest earthquakes to occur in Mexico this century: the 1932 (Mw 8.2) Jalisco earthquake and the 1995 (Mw 8.0) Colima earthquake. Measurement and preliminary radiocarbon dating of emergent paleoshorelines along the Jalisco coast provide the first constraints upon the timing for tectonic uplift. Along this coastline, uplifted Holocene marine notches and wave-cut platforms occur at elevations ranging from ca. 1 to 4.5 m amsl. In situ intertidal organisms dated with radiocarbon, the first ever reported for the Jalisco area, provide preliminary results that record tectonic uplift during at least the past 1300 years BP at an average rate of about 3 mm/year. We propose a model in which coseismic subsidence produced by offshore earthquakes is rapidly recovered during the postseismic and interseismic periods. The long-term period is characterized by slow tectonic uplift of the Jalisco coast. We found no evidence of coastal interseismic and long-term subsidence along the Jalisco coast.     

Wood storage in a wide mountain river: case study of the Czarny Dunajec,Polish Carpathians

Storage of large woody debris in the wide, mountain, Czarny Dunajec River, southern Poland, was investigated following two floods of June and July 2001 with a seven‐year frequency. Within a reach, to which wood was delivered only by bank erosion and transport from upstream, wood quantities were estimated for eighty‐nine, 100 m long, channel segments grouped into nine sections of similar morphology. Results from regression analysis indicated the quantity of stored wood to be directly related to the length of eroded, wooded banks and river width, and inversely related to unit stream power at the flood peak. The largest quantities of wood (up to 33 t ha^?1) were stored in wide, multi‐thread river sections. Here, the relatively low transporting ability of the river facilitated deposition of transported wood while a considerable length of eroded channel and island banks resulted in a large number of trees delivered from the local riparian forest. In these sections, a few morphological and ecological situations led to the accumulation of especially large quantities of wood within a small river area. Very low amounts of wood were stored in narrow, single‐thread sections of regulated or bedrock channel. High stream power facilitated transport of wood through these sections while the high strength of the banks and low channel sinuosity prevented bank retreat and delivery of trees to the channel. Considerable differences in the character of deposited wood existed between wide, multi‐thread channel sections located at different distances below a narrow, 7 km long, channellized reach of the river. Wood deposited close to the downstream end of the channellized reach was highly disintegrated and structured into jams, whereas further downstream well preserved shrubs and trees prevailed. This apparently reflects differences in the distance of wood transport and shows that in a mountain river wider than the height of trees growing on its banks, wood can be transported long distances along relatively narrow, single‐thread reaches but is preferentially deposited in wide, multi‐thread reaches. Copyright © 2005 John Wiley & Sons, Ltd.     

Post-Collisional Transition from Subduction- to Intraplate-type Magmatism in the Westernmost Mediterranean: Evidence for Continental-Edge Delamination of Subcontinental Lithosphere

Post-collisional magmatism in the southern Iberian and northwesternAfrican continental margins contains important clues for theunderstanding of a possible causal connection between movementsin the Earth's upper mantle, the uplift of continental lithosphereand the origin of circum-Mediterranean igneous activity. Systematicgeochemical and geochronological studies (major and trace element,Sr–Nd–Pb-isotope analysis and laser ⁴⁰Ar/³⁹Ar-agedating) on igneous rocks provide constraints for understandingthe post-collisional history of the southern Iberian and northwesternAfrican continental margins. Two groups of magmatic rocks canbe distinguished: (1) an Upper Miocene to Lower Pliocene (8·2–4·8Ma), Si–K-rich group including high-K (calc-alkaline)and shoshonitic series rocks; (2) an Upper Miocene to Pleistocene(6·3–0·65 Ma), Si-poor, Na-rich group includingbasanites and alkali basalts to hawaiites and tephrites. Maficsamples from the Si–K-rich group generally show geochemicalaffinities with volcanic rocks from active subduction zones(e.g. Izu–Bonin and Aeolian island arcs), whereas maficsamples from the Si-poor, Na-rich group are geochemically similarto lavas found in intraplate volcanic settings derived fromsub-lithospheric mantle sources (e.g. Canary Islands). The transitionfrom Si-rich (subduction-related) to Si-poor (intraplate-type)magmatism between 6·3 Ma (first alkali basalt) and 4·8Ma (latest shoshonite) can be observed both on a regional scaleand in individual volcanic systems. Si–K-rich and Si-poorigneous rocks from the continental margins of southern Iberiaand northwestern Africa are, respectively, proposed to havebeen derived from metasomatized subcontinental lithosphere andsub-lithospheric mantle that was contaminated with plume material.A three-dimensional geodynamic model for the westernmost Mediterraneanis presented in which subduction of oceanic lithosphere is inferredto have caused continental-edge delamination of subcontinentallithosphere associated with upwelling of plume-contaminatedsub-lithospheric mantle and lithospheric uplift. This processmay operate worldwide in areas where subduction-related andintraplate-type magmatism are spatially and temporally associated. KEY WORDS: post-collisional magmatism; Mediterranean-style back-arc basins; subduction; delamination; uplift of marine gateways     

Snow model sensitivity analysis to understand spatial and temporal snow dynamics in a high‐elevation catchment

In this paper, we addressed a sensitivity analysis of the snow module of the GEOtop2.0 model at point and catchment scale in a small high‐elevation catchment in the Eastern Italian Alps (catchment size: 61 km²). Simulated snow depth and snow water equivalent at the point scale were compared with measured data at four locations from 2009 to 2013. At the catchment scale, simulated snow‐covered area (SCA) was compared with binary snow cover maps derived from moderate‐resolution imaging spectroradiometer (MODIS) and Landsat satellite imagery. Sensitivity analyses were used to assess the effect of different model parameterizations on model performance at both scales and the effect of different thresholds of simulated snow depth on the agreement with MODIS data. Our results at point scale indicated that modifying only the “snow correction factor” resulted in substantial improvements of the snow model and effectively compensated inaccurate winter precipitation by enhancing snow accumulation. SCA inaccuracies at catchment scale during accumulation and melt period were affected little by different snow depth thresholds when using calibrated winter precipitation from point scale. However, inaccuracies were strongly controlled by topographic characteristics and model parameterizations driving snow albedo (“snow ageing coefficient” and “extinction of snow albedo”) during accumulation and melt period. Although highest accuracies (overall accuracy = 1 in 86% of the catchment area) were observed during winter, lower accuracies (overall accuracy < 0.7) occurred during the early accumulation and melt period (in 29% and 23%, respectively), mostly present in areas with grassland and forest, slopes of 20–40°, areas exposed NW or areas with a topographic roughness index of ?0.25 to 0 m. These findings may give recommendations for defining more effective model parameterization strategies and guide future work, in which simulated and MODIS SCA may be combined to generate improved products for SCA monitoring in Alpine catchments.     

Unraveling complex hydrogeological processes in Andean basins in south‐central Chile: An integrated assessment to understand hydrological dissimilarity

Groundwater storage, drainage, and interbasin water exchange are common hydrological processes but often difficult to quantify due to a lack of local observations. We present a study of three volcanic mountainous watersheds located in south‐central Chile (~36.9 ° S) in the Chillán volcanic complex (Chillán, Renegado, and Diguillín river basins). These are neighboring basins that are similar with respect to the metrics normally available for characterization everywhere (e.g., precipitation, temperature, and land cover). In a hydrological sense, similar (proportional) behavior would be expected if these catchments would be characterized with this general information. However, these watersheds show dissimilar behavior when analyzed in detail. The surface water balance does not fit for any of these watersheds individually; however, the water balance of the whole system can be explained by likely interbasin water exchanges. The Renegado river basin has an average annual runoff per unit of area on the order of 60–65% less than those of the Diguillín and Chillán rivers, which is contradictory to the hydrological similarity among the basins. To understand the main processes that control streamflow generation, two analyses were performed: (a) basin metrics (land cover, geologic, topographic, and climatological maps) and hydro‐meteorological data analyses and (b) a water balance model approach. The analyses contribute to a plausible explanation for the hydrogeological processes in the system. The soils, topography, and geology of the Chillán–Renegado–Diguillín system favor the infiltration and groundwater movements from the Renegado river basin, mainly to the neighboring Diguillín basin. The interbasin water exchanges affect hydrological similarity and explain the differences observed in the hydrological processes of these three apparently similar volcanic basins. The results highlight the complexity of hydrological processes in volcanic mountainous systems and suggest that a simple watershed classification approach based on widely available data is insufficient. Simple local analyses such as specific flow analysis with a review of the geology and morphology can contribute to a better understanding of the hydrology of volcanic mountainous areas.     

基于CIPS软件探讨高山地DOM数据的生产方式

在DOM数据生产中,山地、高山地数据一直以来都是重点和难点。本文分析了高山地影像数据的特点,提出一种与山地、高山地数据相适应的处理方式。最后基于CIPS软件,按需求设计对应的软件处理流程,并使用满足实验要求的高山地影像数据,对这种方式加以实现和验证。     

迁移学习支持下的高分影像山地滑坡灾害解译模型

无人机低空遥感是近年来新兴的一种快速获取灾情信息的手段,如何利用无人机高分影像构建滑坡灾害解译模型是实现快速自动解译滑坡的关键。针对该问题,对比了多种影像特征提取方法,将迁移学习(TL)特征和支持向量机(SVM)引入到构建滑坡灾害自动解译模型中,提出了一种TL支持下的高分影像滑坡灾害解译模型。选取5·12汶川地震及4·20芦山地震系列无人机影像构建了滑坡灾害样本库并进行了实验,TL特征方法整体分类准确度ACC为95%,ROC达到0.98,识别准确率达到97%。结果表明,所提方法可用于高分影像滑坡自动解译,同时可用于大面积高分影像中快速山地滑坡灾害定位及检测。     

1980-2010年冬季北极涛动季节内振荡的成因分析

采用NCEP/NCAR日平均再分析资料,对冬季热带外低频振荡(大气角动量收支及地形力矩)与AO(Arctic Oscillation)指数进行计算,通过功率谱和统计分析发现,它们都存在30~60 d的周期,大气角动量收支与山脉力矩的变化为正相关,且显著响应AO变化。通过动力学诊断分析初步认为,北半球两大地形的山脉力矩作用于纬向大气角动量,副热带纬向西风发生变化,改变南北西风偶极子结构,使得AO产生变化,而且在两大地形中以喜马拉雅山脉地形作用为主。通过对喜马拉雅山脉地区的动力学诊断发现,在高(低)AO指数阶段,喜马拉雅山脉地区激发准定常行星波并作用于副热带西风,导致副热带西风偏弱(偏强),高纬西风偏强(偏弱),因而AO偏强(偏弱),平流层极涡偏强(偏弱),极涡强(弱)中心偏向东北亚。     

月球东海盆地综合解析与撞击初始条件的研究

东海是月球上最年轻的多环撞击盆地,关于其形成机制的研究很多,但成果大都基于正撞击的机制提出的,虽然有部分学者提出东海是斜撞击的,但缺乏具体撞击参数。本文通过多源数据融合,综合分析LRO影像数据、LOLA地形数据、M~3高光谱数据和IIM高光谱数据,对东海地区的地貌特征、物质成分进行了较为系统的解译,发现在东海中央熔融区存在一条与东海撞击方向垂直的中央隆起区域(中央隆起线),其也是中央熔融区粗糙部分与光滑部分的分界线,结合撞击坑成坑理论,认为其可能是撞击过程冲击波作用引起的堆叠作用形成的。同时利用GRAIL数据及对该地区的重力异常的成因进行了分析,认为异常是由于压强、温度及岩石粘度的改变引起局部莫霍面抬升和中央熔融物的形成而出现的,进而估算出熔融物占盆地内物质的25%,约为1.1×10~6km~3。同时,对GRAIL数据的剖面分析结果也支持了本文的斜撞击理论。最后,综合多方面的信息和撞击理论获取东海盆地构造分布图,并根据中央隆起线、溅射物及线性构造的分布特征等,提出东海盆地理论上是由一直径在50~100km的撞击体以10~30km/s的速度自东偏北约20°~30°方向以20°~30°的角度斜撞击月表而形成的。这可为研究更早期的月球撞击坑提供理论参考。