黄河下游串沟截堵技术研究

论述了黄河下游串沟截堵的必要性和汛期串沟截堵判别标准.重点分析串沟截堵技术流程,包括前期准备、截堵时机、修筑裹头、减少来流、进占合龙、闭气等所采用的主要技术方法.串沟截堵技术的研究为串沟截堵预案提供了技术支持,并对现场抢险作业具有技术指导作用.     

以控制地面沉降为约束的地下水资源评价--以上海地区为例

以上海市区第V承压含水层(埋深约350m)以上的整个第四系松散沉积层为研究体,将上海地下水系统作为一个完整且不可分割的系统来研究.由于开采地下水资源引起地下水系统内部物质能量变化,因而产生一系列的环境地质问题(如地面沉降、地下水位下降、资源开采条件恶化等).根据研究区地下水系统特征和已有的研究程度,在技术方法和途径上,着重研究上海地区第四系含水层结构、水文地质工程地质条件,建立水文地质工程地质概念模型;在此基础上建立以地下水资源开采量最大、水位降幅及地面沉降较小、社会经济效益较好为目标的地下水拟三维渗流一维地面沉降的评价与管理模型,并为我国大中城市(特别是在诸如开采地下水引起的地面沉降问题的地区)的地下水资源评价与管理提供可借鉴的经验和方法.     

海冰动力学数值方法研究进展

在海冰动力学数值模拟和预测研究中,人们将海冰视为连续介质分别建立了欧拉坐标下的有限差分（FD）方法、拉格朗日坐标下的光滑质点流体动力学（SPH）方法、欧拉和拉格朗日坐标相结合的质点网格法（PIC）,近年来又发展了基于非连续介质的颗粒流（GF）方法。对以上几种海冰动力学数值方法的特点和适用性进行了讨论,结果表明：FD、PIC和SPH方法可适用于中长期海冰动力学数值模拟,但SPH方法的计算效率需进一步提高;GF方法在不同尺度下的海冰动力学数值模拟中的计算精度均有很强的适用性,但目前较适用于小尺度下海冰动力学基本特性的数值试验研究,计算时效还不能满足实际海冰数值模拟和预测的要求。为进一步提高海冰动力学模拟的精度和适用性,在不同时空尺度下分别发展与其相适应的数值方法是必要的。     

川藏公路二郎山隧道和平沟泥石流特征研究与治理设计

泥石流作为地质环境较差的山区的主要自然灾害之一,对于泥石流的研究思路的进一步发展和完善,在很大程度上将对山区的工程建设有很重要的指导意义。从工程地质研究思路的角度出发,对位于川藏公路二郎山隧道西口和平沟泥石流进行了研究。采用工程地质分析的方法对和平沟泥石流的形成环境(地层岩性条件、构造条件、地貌条件、气象条件、植被发育及人类活动)、基本特征(泥石流沟的基本特征、泥石流的堆积特征)进行了系统的研究,并在此基础上对泥石流沟沿岸的岸坡稳定性(可能泥石流的物源)等进行了评价分析。对泥石流的活动趋势以及可能泥石流的方量做出了较为科学的评价预测。经过这样的系统分析对工程建设中的泥石流防治提出了治理设计方案。     

Analytical modeling on consolidation of stiffened deep mixed column-reinforced soft soil under embankment

Stiffened deep mixed (SDM) column is a new ground improvement technique to improve soft soil, which can be used to increase bearing capacity, reduce deformation, and enhance stability of soft soil. This technique has been successfully adopted to support the highway and railway embankments over soft soils in China and other countries. However, there have been limited investigations on its consolidation under embankment loading. This paper developed an analytical solution for the consolidation of embankment over soft soil with SDM column in which core pile is equal to or shorter than outer DM column. The consolidation problem was simplified as a consolidation of composite soil considering the load shear effect of core pile. The developed solution was verified by a comparison with the results computed by three-dimensional (3-D) finite element analysis. A parametric study based on the derived solution was conducted to investigate influence factors—length of core pile, diameter of core pile, diameter of SDM column, modulus of DM column, and permeability coefficient of DM column—on the consolidation behavior of SDM column-supported embankment over soft soil. The developed solution was applied to a case history of SDM column-supported embankment, and a good agreement was found between the predictions and the field measurements.     

Thresholds of intrabed flow and other interactions of turbidity currents with soft muddy substrates

Controlled laboratory experiments reveal that the lower part of turbidity currents has the ability to enter fluid mud substrates, if the bed shear stress is higher than the yield stress of the fluid mud and the density of the turbidity current is higher than the density of the substrate. Upon entering the substrate, the turbidity current either induces mixing between flow‐derived sediment and substrate sediment, or it forms a stable horizontal flow front inside the fluid mud. Such ‘intrabed’ flow is surrounded by plastically deformed mud; otherwise it resembles the front of a ‘bottom‐hugging’ turbidity current. The ‘suprabed’ portion of the turbidity current, i.e. the upper part of the flow that does not enter the substrate, is typically separated from the intrabed flow by a long horizontal layer of mud which originates from the mud that is swept over the top of the intrabed flow and then incorporated into the flow. The intrabed flow and the mixing mechanism are specific types of interaction between turbidity currents and muddy substrates that are part of a larger group of interactions, which also include bypass, deposition, erosion and soft sediment deformation. A classification scheme for these types of interactions is proposed, based on an excess bed shear stress parameter, which includes the difference in the bed shear stress imposed by the flow and the yield stress of the substrate and an excess density parameter, which relies on the density difference between the flow and the substrate. Based on this classification scheme, as well as on the sedimentological properties of the laboratory deposits, an existing facies model for intrabed turbidites is extended to the other types of interaction involving soft muddy substrates. The physical threshold of flow‐substrate mixing versus stable intrabed flow is defined using the gradient Richardson number, and this method is validated successfully with the laboratory data. The gradient Richardson number is also used to verify that stable intrabed flow is possible in natural turbidity currents, and to determine under which conditions intrabed flow is likely to be unstable. It appears that intrabed flow is likely only in natural turbidity currents with flow velocities well below ca 3·5 m s^?1, although a wider range of flows is capable of entering fluid muds. Below this threshold velocity, intrabed flow is stable only at high‐density gradients and low‐velocity gradients across the upper boundary of the turbidity current. Finally, the gradient Richardson number is used as a scaling parameter to set the flow velocity limits of a natural turbidity current that formed an inferred intrabed turbidite in the deep‐marine Aberystwyth Grits Group, West Wales, United Kingdom.     

A size classification for debris flows

A 10-fold classification for debris flow size is proposed based on total volume, peak discharge and area inundated by debris. Size classes can be used for regional overview studies where detailed site investigations are either unnecessary, too costly or where the highest hazard and risk creeks need to be identified for further study. They are also useful to compare the regional impact between affected areas and the effects of rainstorms, and they allow lay-people to obtain an understanding of debris flow magnitude and consequences. Finally, different size classes allow the estimation of travel times to points of interest based on empirically derived equations. It is proposed that agencies concerned with debris flows should establish a documentation of debris flow size according to this classification, which serves as a data base for hazard and risk planning.     

High heat flow anomalies on an old oceanic plate observed seaward of the Japan Trench

Thirty-three new measurements on the seaward slope and outer rise of the Japan Trench along a parallel of 38°45′N revealed the existence of high heat flow anomalies on the subducting Pacific plate, where the seafloor age is about 135 m.y.. The most prominent anomaly with the highest value of 114 mW/m² is associated with a small mound on the outer rise, which was reported to be a kind of mud volcano. On the seaward slope of the trench, heat flow is variable: high (70–90 mW/m²) at some locations and normal for the seafloor age (about 50 mW/m²) at others. The spatial variation of heat flow may be related to development of normal faults and horst/graben structures due to bending of the Pacific plate before subduction, with fluid flow along the fault zones enhancing the vertical heat transfer. Possible heat sources of the high heat flow anomalies are intra-plate volcanism in the last several million years like that discovered recently on the Pacific plate east of the Japan Trench.     

利用井温分布估算莺-琼盆地地下流体运移速度

莺-琼盆地是典型的高温高压盆地,现今平均地表热流78.7mW/m2,产生地表高热流的主要原因是深部热流体活动。根据盆地地温场分布特征与地下流体活动规律的关系,利用井温资料,我们计算了典型钻孔LD30-1-1A井地下流体的流速分布。结果表明,LD-30-1-1A井地下流体可分为上、中、下三段。上段流体运动微弱,垂向流速仅为8.33×10-12 cm/s;中段流体向下垂向流速为4.37×10-8 cm/s;下段流体向上垂向流速为2.65×10-8 cm/s.      

包气带水气二相流国外研究综述

与传统的包气带中水流研究相比,水气二相流更准确地描述了包气带中的水与空气的流动情况,这对更好地了解固体废物处置场中污染物的运动规律具有重要的意义.与一相流明显不同的是,二相流考虑了空气的运动及其对水流的作用.根据国外近几十年来不同研究者的研究结果,总结了入渗过程中水的流动、空气对水流的影响及空气本身的压力变化情况,并分析了不同作者研究结果的差别.