应用GPS观测青藏高原东北缘应力场变化

采用各向同性弹性地球模型推导了地面位移场速率与地壳内任意点应力场变化的边界积分关系,同时利用青藏高原东北缘1999～2001年观测的GPS资料对观测区地壳深度为5 km和25 km的主应力和最大剪应力进行了计算分析.结果表明,青藏高原东北缘的主应力变化主要集中在祁连山断裂、海原断裂等,在1920～1954年间历史上发生过多次震级为7.0～8.5级强震的断裂附近,并具有主应力变化沿断层走向分布、最大剪应力沿断层走向交替变化等特征.     

Microboudin structures of piemontite along the Sambagawa metamorphic belt, Japan: implications for lateral variation of differential stress during regional metamorphism

Evidence is presented of a lateral variation in differential stress during metamorphism along a regional metamorphic belt on the basis of the proportion of microboudinaged piemontite grains (p) in a quartz matrix in metacherts. It is proposed that p is a practical indicator of relative differential stress. Analysis of 123 metacherts from the 800 km long Sambagawa metamorphic belt, Japan, reveals that p‐values range from < 0.01 to 0.7 in this region. Most samples from Wakayama in the mid‐belt area have p‐values of 0.4–0.6, whereas those from western Shikoku have p‐values of < 0.1. This difference cannot be explained by variations in metamorphic temperature, and is instead attributed to a regional, lateral variation in differential stress during metamorphism.     

Numerical prediction of blast‐induced stress wave from large‐scale underground explosion

This paper presents a numerical model for predicting the dynamic response of rock mass subjected to large‐scale underground explosion. The model is calibrated against data obtained from large‐scale field tests. The Hugoniot equation of state for rock mass is adopted to calculate the pressure as a function of mass density. A piecewise linear Drucker–Prager strength criterion including the strain rate effect is employed to model the rock mass behaviour subjected to blast loading. A double scalar damage model accounting for both the compression and tension damage is introduced to simulate the damage zone around the charge chamber caused by blast loading. The model is incorporated into Autodyn3D through its user subroutines. The numerical model is then used to predict the dynamic response of rock mass, in terms of the peak particle velocity (PPV) and peak particle acceleration (PPA) attenuation laws, the damage zone, the particle velocity time histories and their frequency contents for large‐scale underground explosion tests. The computed results are found in good agreement with the field measured data; hence, the proposed model is proven to be adequate for simulating the dynamic response of rock mass subjected to large‐scale underground explosion. Extended numerical analyses indicate that, apart from the charge loading density, the stress wave intensity is also affected, but to a lesser extent, by the charge weight and the charge chamber geometry for large‐scale underground explosions. Copyright © 2004 John Wiley & Sons, Ltd.     

Application of stress release models to historical earthquakes from North China

Univariate and multivariate stress release models are fitted to historical earthquake data from North China. It is shown that a better fit is obtained by treating separately the Eastern part of the region, including the North China Plain and Bohai Sea, and the Western part of the region, including the Ordos Plateau and its Eastern boundary. Further improvement is obtained by fitting the large events (M7.6) and smaller events in the Western region by different stress release models. The comparisons are made by computing the likelihoods of the fitted models and discounting the number of parameters used by Akaike's AIC criterion. The models are used to develop long-term risk scenarios for the East and West regions.     

Focal mechanism inversion in the Giudicarie–Lessini seismotectonic region (Southern Alps, Italy): Insights on tectonic stress and strain

A set of 41 focal mechanisms (1989–2006) from P-wave first polarities is computed from relocated seismic events in the Giudicarie–Lessini region (Southern Alps). Estimated hypocentral depths vary from 3.1 to 20.8 km, for duration magnitudes (M_D) in the range 2.7–5.1. Stress and strain inversions are performed for two seismotectonic zones, namely G (Giudicarie) and L (Lessini). This subdivision is supported by geological evidence, seismicity distribution, and focal mechanism types. The available number of data (16 in G, 22 in L) does not make possible any further subdivisions. Seismotectonic zones G and L are undergoing different kinematic regimes: thrust with strike-slip component in G, and strike-slip in L. Principal stress and strain axes in each sub-region show similar orientations. The direction of maximum horizontal compressive stress is roughly perpendicular to the thrust fronts along the Giudicarie Belt in zone G, and compatible with right-lateral strike-slip reactivation of the faults belonging to the Schio-Vicenza system in zone L. On the whole, kinematic regimes and horizontal stress orientations show a good fit with other stress data from focal mechanisms and breakouts and with geodetic strain rate axes.     

A new method of estimating the ratio between in situ rock stresses and tectonics based on empirical and probabilistic analyses

This paper describes a new procedure for assessing the ratio between in situ stresses in rock masses by means of K (K = σ_H / σ_v, being σ_H and σ_v principal stress) and tectonics for purposes of engineering geology and rock mechanics. The method combines the use of the logic decision tree and the empirical relationship between the Tectonic Stress Index, TSI, and a series of K in situ values obtained from an extensive database. The decision tree considers geological and geophysical factors affecting stress magnitudes both on the regional and local scale. The TSI index is defined by geological and geomechanical parameters. The method proposed provides an assessment of the magnitude of horizontal stresses of tectonic origin. Results for several regions of Europe are presented and the possible applications of the procedure are discussed.     

Experimental constraints on the effects of pressure and H2O on the fractional crystallization of high-Mg island arc basalt

H₂O-undersaturated melting experiments of synthesized basalt (SiO₂ = 50.7 wt.%, MgO = 8.3 wt.%, Mg# = 60) were conducted at fO₂ corresponding to NNO+1 and NNO−1 to clarify the effects of pressure (2–7 kbar) and H₂O on fractional crystallization in island arcs. H₂O content was ranged from nominally anhydrous to 4.4 wt.%. Differentiation trends, namely the liquid lines of descent, change sensitively according to pressure-H₂O relations. Tholeiitic differentiation trends are reproduced with H₂O ≤ ∼2 wt.% in primary magma. With such quantities of H₂O, fractional crystallization is controlled by olivine + plagioclase at 2 kbar. Increasing the pressure from 2 to ≥4 kbar induces early crystallization of orthopyroxene instead of olivine and therefore SiO₂ enrichment in the residual melts is suppressed. Increasing H₂O (≥ ∼2 wt.% in primary magma) stabilizes clinopyroxene relative to orthopyroxene and/or magnetite. Although the phase relations and proportions strongly depend on fO₂ and H₂O content, differentiation trends are always calc-alkaline.     

Depths of Partial Crystallization of H2O-bearing MORB: Phase Equilibria Simulations of Basalts at the MAR near Ascension Island (7 11{degrees}S)

Phase equilibria simulations were performed on naturally quenchedbasaltic glasses to determine crystallization conditions priorto eruption of magmas at the Mid-Atlantic Ridge (MAR) east ofAscension Island (7–11°S). The results indicate thatmid-ocean ridge basalt (MORB) magmas beneath different segmentsof the MAR have crystallized over a wide range of pressures(100–900 MPa). However, each segment seems to have a specificcrystallization history. Nearly isobaric crystallization conditions(100–300 MPa) were obtained for the geochemically enrichedMORB magmas of the central segments, whereas normal (N)-MORBmagmas of the bounding segments are characterized by polybariccrystallization conditions (200–900 MPa). In addition,our results demonstrate close to anhydrous crystallization conditionsof N-MORBs, whereas geochemically enriched MORBs were successfullymodeled in the presence of 0·4–1 wt% H₂O in theparental melts. These estimates are in agreement with direct(Fourier transform IR) measurements of H₂O abundances in basalticglasses and melt inclusions for selected samples. Water contentsdetermined in the parental melts are in the range 0·04–0·09and 0·30–0·55 wt% H₂O for depleted and enrichedMORBs, respectively. Our results are in general agreement (within±200 MPa) with previous approaches used to evaluate pressureestimates in MORB. However, the determination of pre-eruptiveconditions of MORBs, including temperature and water contentin addition to pressure, requires the improvement of magma crystallizationmodels to simulate liquid lines of descent in the presence ofsmall amounts of water. KEY WORDS: MORB; Mid-Atlantic Ridge; depth of crystallization; water abundances; phase equilibria calculations; cotectic crystallization; pressure estimates; polybaric fractionation