电涌保护器级间退耦元件的选型分析

针对电涌保护器（SPD）级间能量配合试验中配合失效的问题,主要利用波的传输理论与基尔霍夫定律进行分析,结合JB/T 10618-2006（组合式电涌保护器）的规定假设一套组合型SPD,通过基础理论分析与精确计算得出：当被保护装置属于低频（直流）设备时,在不影响信号强度的情况下,退耦元件采用电感或电阻型元件均可;当被保护装置属于高频设备时,退耦元件只能选用低电感量的电阻型退耦元件.退耦元件的参数值均可按照波的传输理论与基尔霍夫定律进行理论计算.这在组合型SPD退耦元件的选型过程中,具有重要的指导意义.     

涉及埃达克岩实验的若干基本概念与问题辨析

根据热力学原理,部分熔融是相变的一种表现形式。当岩石沿p-T轨迹穿过固相线时即可发生熔融。自然界岩石常见的不一致熔融行为可以导致残留相具有不同于源岩的整体成分与矿物组合。残留相与源岩可以属于不同的变质相,岩性也可以不同。"C型埃达克岩"含有含水矿物,它们不是干体系熔融的产物。实验岩石学研究表明,基性成分(SiO_250%)体系较中性、酸性体系在1.0~2.0 GPa压力条件下失水熔融时更易于形成"榴辉岩质"的残留相。源岩除SiO_2以外的其它主要氧化物会影响残留相中各矿物的比例,进而影响熔体的Sr、Y及HREE含量。因此,"C型埃达克岩"高Sr低HREE特征的形成取决于熔融温压条件以及源岩的主量元素、微量元素组成等多重因素。高钾含量(K_2O≈1.0%)的基性、中基性源岩形成的熔体成分与"C型埃达克岩"相比过于富Al或富Na。中等富钾的基性源岩的低程度熔融可以形成高硅的"C型埃达克岩",但无法形成中性的"C型埃达克岩"。     

冰层取心回转钻进模拟实验台的设计与测试

极地钻探实践表明,冰盖底部冰岩交界附近地质情况异常复杂,不但可能存在暖冰、基底融水,甚至还存在厚度不等的冰岩夹层,取心钻探异常困难,而优选钻头类型、确定合理的钻进参数是保证其安全、快速钻进的重要因素。本文设计了一套能够模拟冰层回转钻进的实验台,其技术参数为：钻压、转速分别可在0～10 kN、0～300 r/min范围内调节,最大扭矩约100 N·m。该实验台能够测量钻头切削具温度、钻孔深度及钻进速度等参数,为深入研究钻头类型及结构参数、钻进参数对扭矩、钻速和切削温度的影响规律提供了手段。采用PDC复合片钻头进行了冰钻实验,结果表明,实验台能够准确调节钻压和转速,可满足实验要求。     

Prediction of Seaward Slope Recession in Berm Breakwaters Using M5' Machine Learning Approach

In the design process of berm breakwaters, their front slope recession has an inevitable rule in large number of model tests, and this parameter being studied. This research draws its data from Moghim’s and Shekari’s experiment results. These experiments consist of two different 2D model tests in two wave flumes, in which the berm recession to different sea state and structural parameters have been studied. Irregular waves with a JONSWAP spectrum were used in both test series. A total of 412 test results were used to cover the impact of sea state conditions such as wave height, wave period, storm duration and water depth at the toe of the structure, and structural parameters such as berm elevation from still water level, berm width and stone diameter on berm recession parameters. In this paper, a new set of equations for berm recession is derived using the M5'' model tree as a machine learning approach. A comparison is made between the estimations by the new formula and the formulae recently given by other researchers to show the preference of new M5'' approach.     

3500m岩心钻探装备在油气井勘查中的示范应用

3500 m岩心钻探装备（YDX—6型钻机）是我国自主研发的深部矿产资源勘查技术装备,采用N级口径钻深可达3500 m,其最大特点是采用长油缸钻进和起下钻。本文主要介绍了该钻机在油气井勘查中生产试验情况,同时对矿区地层、钻孔结构、钻进过程、钻进效果、遇到的主要问题及解决办法等进行了介绍。     

岸滩侧蚀崩塌速率的试验量测方法

岸滩侧蚀崩塌现象普遍存在于冲积河流演变过程中,是河道治理需重点关注的问题之一,岸滩侧蚀崩塌速率的准确量测则是崩岸机理及其治理措施研究的关键基础。基于图像处理技术,建立了河岸侧蚀崩塌速率试验量测系统,通过图像追踪河岸模型上边缘示踪网格位置变迁,提出了一种河岸侧蚀崩塌速率测量方法。以试验水槽为例,对河岸侧蚀崩塌速率进行了量测,并与经验公式计算值进行了比对,两者基本吻合,可较好地反映流速、土体级配等岸滩侧蚀崩塌速率的影响因素及其变化规律。研究成果可为江河崩岸机理的深入研究提供技术支撑。     

锚定式方钢管混凝土柱与钢梁节点抗震性能试验研究

通过低周反复加载试验对6个锚定式方钢管混凝土柱-H形钢梁节点进行了试验研究,研究了不同轴压比情况下节点的破坏模式、延性、耗能性能、强度及刚度退化等。试验结果表明,破坏之前节点具有良好的滞回性能、延性及耗能能力,满足现行抗震规范的要求。锚定式方钢管混凝土梁柱节点可以用于拉力较小的节点。文中提出了有关的设计建议。     

地震工程研究的科学大平台

始于十九世纪末的地震工程研究,在其100多年的历史中积累了大量的理论和实践经验,随之而建设起来的各类地震工程实验设施分布于世界各地。近20年来,信息技术的飞速发展使得分布于世界各地的实验设施通过网络实现协同实验和资源共享。基于以上的信息,为了更好更快地和国际接轨,本文提出了建设一个地震工程研究领域的科学大平台设想。这个大平台包括三个方面的内容:数值模拟,网络协同实验系统和基础信息系统,将形成本领域开放性的综合科学平台。在数值模拟方面,这个科学平台将利用最新的信息技术将本领域的科学研究结果和方法集成起来,形成一个模块式的科学研究平台系统。在网络协同实验方面,将采纳美国NEES的思路,并对其改进和提高之后应用于中国。在基础数据方面,将利用最为先进的数据仓储技术,建设一个可以服务于地震工程科学研究的数据平台。最后,文章给出了建设这个科学平台的规划,以及目前的进展和资金支持等情况。     

Loss of energy dissipation capacity from the deadzone in linear and nonlinear viscous damping devices

In a viscous damping device under cyclic loading, after the piston reaches a peak stroke, the reserve movement that follows may sometimes experience a short period of delayed or significantly reduced device force output. A similar delay or reduced device force output may also occur at the damper’s initial stroke as it moves away from its neutral position. This phenomenon is referred to as the effect of “deadzone”. The deadzone can cause a loss of energy dissipation capacity and less efficient vibration control. It is prominent in small amplitude vibrations. Although there are many potential causes of deadzone such as environmental factors, construction, material aging, and manufacture quality, in this paper, its general effect in linear and nonlinear viscous damping devices is analyzed. Based on classical dynamics and damping theory, a simple model is developed to capture the effect of deadzone in terms of the loss of energy dissipation capacity. The model provides several methods to estimate the loss of energy dissipation within the deadzone in linear and sublinear viscous fluid dampers. An empirical equation of loss of energy dissipation capacity versus deadzone size is formulated, and the equivalent reduction of effective damping in SDOF systems has been obtained. A laboratory experimental evaluation is carried out to verify the effect of deadzone and its numerical approximation. Based on the analysis, a modification is suggested to the corresponding formulas in FEMA 356 for calculation of equivalent damping if a deadzone is to be considered.     

Estimation of peak relative velocity and peak absolute acceleration of linear SDOF systems

In the seismic analysis and design of structures, the true velocity and absolute acceleration are usually approximated by their corresponding pseudo-values. This approach is simple and works well for structures with small damping (say, less than 15%). When the damping of a structure is enhanced for the purpose of response reduction, it may result in large analysis and design errors. Based on theory of random vibration and the established mechanism of seismic response spectra analysis, a method is developed (1) to predict the relative velocity spectra with any damping ratio level directly from the 5% standard pseudo-acceleration spectrum; and (2) to estimate the peak absolute acceleration. The accuracy of both is validated by using two selected ensembles of ground motion records.