Elastic properties of granulite facies rocks of Mahabalipuram, Tamil Nadu, India

Compressional and shear wave velocities and attenuation measurements have been carried out in some of the borehole samples of acidic, basic and intermediate granulites of Mahabalipuram, Tamil Nadu, India. The results have been obtained at ambient conditions using ‘time-of-flight’ pulse transmission technique at 1.0 MHz frequency. The results show linear relationships between velocity and density, and velocity and attenuation properties of the rocks. The acidic granulites show lower velocities and higher attenuation than the intermediate and basic granulites. The average values of the Poisson’s ratio of acidic, intermediate and basic granulites have been found to be 0.210, 0.241 and 0.279 respectively. The variations in velocities and attenuation in these low porosity crystalline rocks are found to be strongly influenced by their mineral composition. The laboratory velocity data (extrapolated to high pressure) of the present study and the published field velocity data from deep seismic sounding studies indicate that these granulite facies rocks may belong to mid-crustal depths only.     

Surface temperature differences between minerals in crystalline rocks: Implications for granular disaggregation of granites through thermal fatigue

Thermal expansion differences between minerals within rocks under insolation have previously been assumed to drive breakdown by means of granular disaggregation. However, there have been no definitive demonstrations of the efficacy of this weathering mechanism. Different surface temperatures between minerals should magnify thermal expansion differences, and thus subject adjacent minerals to repeated stresses that might cause breakdown through fatigue failure. This work confirms the existence of surface temperature differences between minerals in granitic rocks under simulated short-term temperature fluctuations so as to discriminate their potential for initiating granular disaggregation. The influence of colour, as a surrogate for albedo, and crystal size, as a function of thermal mass are specifically identified because of their ease of quantification. Four rock types with a range of these properties were examined, and subjected to repeated short-term temperature cycles by radiative heating and cooling under laboratory conditions. Results show that while albedo is the main control for overall and individual maximum temperatures, crystal size is the main factor controlling higher temperature differences between minerals. Thus, stones with large differences of mineral sizes can undergo magnified stresses due to thermal expansion differences.     

Estimating the minimum in-stream flow requirements via wetted perimeter method based on curvature and slope techniques

Under the assumptions of triangular cross section channel and uniform stable flow, an analytical solution of the minimum ecological in-stream flow requirement (MEIFR) is deduced. Based on the analytical solution, the uncertainty of the wetted perimeter method is analyzed by comparing the two techniques for the determination of the critical point on the relationship curve between wetted perimeter, P and discharge, Q. It is clearly shown that the results of MEIFR based on curvature technique (corresponding to the maximum curvature) and slope technique (slope being 1) are significantly different. On the P-Q curve, the slope of the critical point with the maximum curvature is 0.39 and the MEIFR varied prominently with the change of the slope threshold. This indicates that if a certain value of the slope threshold is not available for slope technique, curvature technique may be a better choice. By applying the analytical solution of MEIFR in the losing rivers of the Western Route South-to-North Water Transfer Project in China, the MEIFR value via curvature technique is 2.5%-23.7% of the multi-year average annual discharge, while that for slope technique is 11%-105.7%. General conclusions would rely on the more detailed research for all kinds of cross-sections.     

Effects of fracture lineaments and in-situ rock stresses on groundwater flow in hard rocks: a case study from Sunnfjord, western Norway

Systematic field mapping of fracture lineaments observed on aerial photographs shows that almost all of these structures are positively correlated with zones of high macroscopic and mesoscopic fracture frequencies compared with the surroundings. The lineaments are subdivided into zones with different characteristics: (1) a central zone with fault rocks, high fracture frequency and connectivity but commonly with mineral sealed fractures, and (2) a damage zone divided into a proximal zone with a high fracture frequency of lineament parallel, non-mineralized and interconnected fractures, grading into a distal zone with lower fracture frequencies and which is transitional to the surrounding areas with general background fracturing. To examine the possible relations between lineament architecture and in-situ rock stress on groundwater flow, the geological fieldwork was followed up by in-situ stress measurements and test boreholes at selected sites. Geophysical well logging added valuable information about fracture distribution and fracture flow at depths. Based on the studies of in-situ stresses as well as the lineaments and associated fracture systems presented above, two working hypotheses for groundwater flow were formulated: (i) In areas with a general background fracturing and in the distal zone of lineaments, groundwater flow will mainly occur along fractures parallel with the largest in-situ rock stress, unless fractures are critically loaded or reactivated as shear fractures at angles around 30° to σ_H; (ii) In the influence area of lineaments, the largest potential for groundwater abstraction is in the proximal zone, where there is a high fracture frequency and connectivity with negligible fracture fillings. The testing of the two hypotheses does not give a clear and unequivocal answer in support of the two assumptions about groundwater flow in the study area. But most of the observed data are in agreement with the predictions from the models, and can be explained by the action of the present stress field on pre-existing fractures.     

Petrogenesis and tectonic setting of Cadomian felsic igneous rocks, Sandıklı area of the western Taurides, Turkey

In the Sandıklı (Afyon) region, western Taurides, the Late Proterozoic rocks of the Sandıklı basement complex are composed of low-grade meta-sedimentary rocks (Güvercinoluk Formation) intruded by felsic rocks (Kestel Cayı Porphyroid Suite, KCPS). The KCPS is a deformed and highly sheared, dome-shaped rhyolitic body with a granitic core. Quartz porphyry dikes intrude both the slightly metamorphic igneous and the sedimentary rocks of the basement complex. Both the quartz porphyries and rhyolites were converted into mylonites with relict igneous textures. Geochemical data show that these felsic igneous rocks are subalkaline and mainly granitic in composition with SiO₂ >72 wt% and Al₂O₃ >11.5 wt%. The chondrite-normalized incompatible trace element patterns are characterized by distinct negative Rb, Nb, Sr, P, Ti, and Eu with enrichment in Th, U, La, Ce, Nd, Sm, and Zr. The REE patterns of the felsic rocks indicate a strong enrichment in LREE but display slightly flat HREE patterns. According to geochemical characteristics and petrogenetic modeling, extrusive and intrusive rocks of the KCPS were probably derived from an upper continental crustal source (partial melting of granites/felsic rocks) by 18–20% fractional melting plus 18–20% Rayleigh fractional crystallization, which seems to be the most effective igneous process during the crystallization of the KCPS. Single zircon age data from the granitoids and fossils from the disconformably overlying sedimentary successions indicate that the metamorphism and the igneous event in the Taurides are related to the Cadomian orogeny. Based on the geological, geochemical and petrogenetic correlation of the post-collisional granitoids it is further suggested that the Tauride belt in western central Turkey was in a similar tectonic setting to the Gondwanan terranes in North Africa (Younger Granitoids) and southern Europe (Spain, France, Bohemia, Brno Massifs) during the Late Cadomian period.     

江西省宜春城区地面塌陷特征及防治建议

宜春城区属岗阜低丘地形,分布石炭系-二叠系覆盖型及裸露型碳酸盐岩,占城区面积近70%。浅部岩溶发育,覆盖层厚度一般小于20m,土洞较多,基岩面起伏大,第四系岩性结构复杂,地下水埋藏浅。由于抽采地下水及建筑施工振动等人为因素影响,诱发地面塌陷12处,造成重大经济损失。在城市规划功能布局时应充分考虑地面塌陷的易发程度及场地建设适宜性;应限制诱发塌陷因素的强度,在易发区须严格控制地下水开采,严禁新建开采井;塌陷治理的主要方法有填堵、跨越、灌注、深基础控制抽排水强度、及其它综合治理或避让方法,同时做好灾害的监测预报工作。     

邢台矿区山字型构造的发现及其地质意义

邢台山字型构造位于河北省邯邢煤田内，其前弧向ES突出，脊柱呈ES-WN走向。分别分析了山字型构造脊柱及其东、西翼反射弧构造形迹特征，对研究区找矿具有重要意义。