鲢鱼(Hypophthalmichthys molitrix)摄食强度和节律的实验研究

报道用室内实验方法对鲢鱼摄食强度和摄食节律的研究结果,探讨了影响它们的因子。提出鲢鱼在不同水温、不同花粉密度及不同鱼规格下的摄食量的统计分析。指出:食粒密度和水温与摄食量正相关,而鱼规格与摄食量负相关;食粒密度对摄食量影响最大(P<0.01),其次为水温;水温和食粒密度在影响摄食量的过程中可能有一定的交互作用。鲢鱼摄食强度在室内条件下也具明显的昼夜节律。在食粒规格较小、密度较低且溶氧充足条件下,鲢鱼夜晚非但不停食且出现摄食率次高峰。在本实验条件下,鲢鱼的日摄食节律与水温和光照无关,可能受饵料可得性和自身的生物钟节律等制约。     

南黄海灾害地质因素及分区

尝试性地将南黄海灾害地质因素分为4大类。同时参考地貌沉积界线和其他因素将南黄海分成4个灾害地质区：即海岸带、苏北浅滩、海州湾和南黄海东部灾害地质区，并时各灾害地质区进行了定性评价，苏北浅滩灾害地质区是研究区内灾害地质环境最不稳定的区域。     

Dynamic analysis of a vertical plate exposed to breaking wave impact

From the experimental studies in recent years, it has become known that when a wave breaks directly on a vertical faced coastal structure, high magnitude impact pressures are produced. The theoretical and experimental studies show that the dynamic response of such structures under wave impact loading is closely dependent on the magnitude and duration of the load history. The dynamic analysis and design of a coastal structure can be succeeded provided the design load history for the wave impact is available. Since these types of data are very scarce, it is much more convenient to follow a method which is based on static analysis for the dynamic design procedure. Therefore, to facilitate the dynamic design of a vertical plate that is exposed to breaking wave impact, a multiplication factor called “dynamic magnification factor” is herein presented which is defined as the ratio of the maximum value of the dynamic response to that found by static analysis. The computational results of the present study show that the dynamic magnification factor is a useful ratio to transfer the results of static analysis to the dynamic design of a coastal plate for the maximum impact pressure conditions of p_max/γH₀≤18.     

船舶受冲击力作用时的水动力试验研究

根据冲量相似的要求进行船舶在冲击作用下的模型试验，并将模型试验结果与理论计算及实际试验进行了对比和分析。     

软粘土中插入式大直径薄壁圆筒结构的一种极限状态分析模型

根据插入式大直径薄壁圆筒结构的工作特点建立了其合理的破坏机制，以此为基础建立了受横向荷载作用的插入式大直径薄壁圆筒结构的上限法极限分析模型，从中可以得到作用于插入式大直径薄壁圆筒结构上的横向极限荷载近似的上限解；并根据上限法模型计算结果，提出了计算受横向荷载作用的插入式大圆筒结构侧壁极限抗力的简化修正模型，利用此修正模型，基于极限平衡法，可以求解作用于插入式大直径薄壁圆筒结构上的横向极限荷载。     

环太湖河道污染物负荷量的初步研究

根据１９８７－１９８８年环太湖河道水质，水量实测资料以及环湖主要河道的流量和水质的历史资料，结合平原水网地区的水情特征，提出了环太湖河道污染物负荷量的计算方法，并分析探讨了不同设计水情下环太湖河道污染物负荷量及其时空变化。结果表明，污染物负荷量与水情关系密切，枯水年的河道入湖污染物负荷量大于丰水年。环湖２２条主要河道的入湖污染物负荷量占全部河道入湖总量的７２％－９１％，且不同污染物入湖负荷量的分布     

Wave Loads and Protective Techniques of An On-Shore Wave Power Device

In this paper, the extreme wave loads on an on-shore wave power device are investigated. First, boundary element method is applied to solve the three dimensional potential problem based on the small amplitude wave assumption. Then the motion of the Oscillating Water Column (OWC) inside the device and its laods on the device are calculated in time domain. Several protective techniques often applied are simulated by changing the constraint of the upper end of the chamber of the device. Numerical results are used to judge the effectiveness of these techniques. The investigation shows that damping can not effectively restrain the motion of OWC when the period of incident wave is long, which may cause dangerous loads on the structure. The shut chamber can effectively restrain the motion of OWC, but alternatively cause high pressure in the chamber. A Contracting opening with a Taper (CT) can exhaust a great amount of kinetic energy of OWC, and significantly decrease the loads. It is a promising protective tec     

Behavior of Pile Groups under Lateral Load

Based on investigation and model tests, and in combination with the research work on group effect for pile groups under lateral loads relating to the code of fixed offshore platforms, a series of studies have been performed on the behavior and failure mechanism of laterally loaded pile groups, critical pile spacing inducing group effect, lateral bearing capacity of pile groups and its main influence factors, the stress-strain relationship for single piles and pile groups and so on. Some new laws about non-uniformity of load distribution in the longitudinal direction of pile groups and load-deflection (p - y) curves for pile groups have been discovered, and an empirical formula is presented in order to remedy the defect of current calculating methods at home and abroad. These results can be used for reference in the design of pile foundation under lateral loads.     

Calculating Method and Verification of Wave Pressure Distribution on the Breast Wall of Mound Breakwater

In this paper, the calculating charts and formulae about wave pressure on the breast wall are derived with seven parameters on the basis of physical model study. The verification shows that the charts agree with the example, and are adopted in the Specifications of Fishery Harbours Breakwater by the Ministry of Agricultures.     

Elasto-Plastic Analysis of Tubular Joints of Offshore Platforms by Finite Element Method

The plastic node method is reformulated by the variational principle and is applied to elasto-plastic finite element analysis of tubular joints, eventually including the effect of internal and external gussets, stiffener rings, etc., if necessary. Four different joints are studied here in detail for the elasto-plastic behavior, the strain at the hot spot, the strain concentration factor around the intersection line, and the propagation of the plastic region with loading up to collapse in order to determine the ultimate strength, safety factor, and development of the plastic field. The present results are in good agreement with the experimental results.