Movement and strain conditions of active blocks in the Chinese mainland

The definition of active block is given from the angles of crustal deformation and strain. The movement and strain parameters of active blocks are estimated according to the unified velocity field composed of the velocities at 1598 GPS stations obtained from GPS measurements carried out in the past years in the Chinese mainland and the surrounding areas. The movement and strain conditions of the blocks are analyzed. The active blocks in the Chinese mainland have a consistent E-trending movement component, but its N and S components are not consistent. The blocks in the western part have a consistent N-trending movement and the blocks in the eastern part have a consistent S-trending movement. In the area to the east of 90°E, that is the area from Himalayas block towards NE, the movement direction of the blocks rotates clockwisely and the movement rates of the blocks are different. Generally, the movement rate is large in the west and south and small in the east and north with a difference of 3 to 4 times between the rates in the west and east. The distributions of principal compressive strain directions of the blocks are also different. The principal strain of the blocks located to the west of 90oE is basically in the SN direction, the principal compressive strain of the blocks in the northeastern part of Qingzang plateau is roughly in the NE direction and the direction of principal compressive strain of the blocks in the southeastern part of Qingzang plateau rounds clockwisely the east end of Himalayas structure. In addition, the principal strain and shear strain rates of the blocks are also different. The Himalayas and Tianshan blocks have the largest principal compressive strain and the maximum shear strain rate. Then, Lhasa, Qiangtang, Southwest Yunnan (SW Yunnan), Qilian and Sichuan-Yunan (Chuan-Dian) blocks followed. The strain rate of the blocks in the eastern part is smaller. The estimation based on the stain condition indicates that Himalayas block is still the area with the most intensive tectonic activity and it shortens in the NS direction at the rate of 15.2±1.5 mm/a. Tianshan block ranks the second and it shortens in the NS direction at the rate of 10.1±0.9 mm/a. At present, the two blocks are still uprising. It can be seen from superficial strain that the Chinese mainland is predominated by superficial expansion. Almost the total area in the eastern part of the Chinese mainland is expanded, while in the western part, the superficial compression and expansion are alternatively distributed from the south to the north. In the Chinese mainland, most EW-trending or proximate EW-trending faults have the left-lateral or left-lateral strike-slip relative movements along both sides, and most NS-trending faults have the right-lateral or right-lateral strike-slip relative movements along both sides. According to the data from GPS measurements the left-lateral strike-slip rate is 4.8±1.3 mm/a in the central part of Altun fault and 9.8±2.2 mm/a on Xianshuihe fault. The movement of the fault along the block boundary has provided the condition for block movement, so the movements of the block and its boundary are consistent, but the movement levels of the blocks are different. The statistic results indicate that the relative movement between most blocks is quite significant, which proves that active blocks exist. Himalayas, Tianshan, Qiangtang and SW Yunnan blocks have the most intensive movement; China-Mongolia, China-Korea (China-Korea), Alxa and South China blocks are rather stable. The mutual action of India, Pacific and Philippine Sea plates versus Eurasia plate is the principal driving force to the block movement in the Chinese mainland. Under the NNE-trending intensive press from India plate, the crustal matter of Qingzang plateau moves to the NNE and NE directions, then is hindered by the blocks located in the northern, northeastern and eastern parts. The crustal matter moves towards the Indian Ocean by the southeastern part of the plateau.     

Compositional Geometry and Mass Conservation

A geometrical structure is imposed on compositional data by physical and chemical laws, principally mass conservation. Therefore, statistical or mathematical investigation of possible relations between data values and such laws must be consistent with this structure. This demands that geometrical concepts, such as points that specify both mass and composition in linear space, and lines in projective space that specify composition only, be clearly defined and consistent with mass conservation. Mass thus becomes the norm in composition space in place of the Euclidean norm of ordinary space. Coordinate transformations inconsistent with this geometry are accordingly unnatural and misleading. They are also unnecessary because correlation arising from the constant mass presents no unusual difficulty in the analysis of the underlying quadratic form.     

场地条件对地震动相干函数的影响

本通过弹性半空间内位错源的数值解法研究了曲岩地震动相干函数，采用有限元方法分析了一些典型场地的地表地震动相干函数，两的对比结果表明：复杂场地对地震动相干函数的影响强烈。     

陆面过程模式的改进及其检验

文中对陆面过程模式 (BATS)进行了改进 ,改进后的模式能较好地模拟地表物理量的年、季和日变化 ,它有两方面的特点 :采用热扩散方程模拟 7层土壤温度 ,模拟的温度可与实测值进行比较 ;在BATS的地表径流方案中 ,考虑了空间不均匀性的一般地表径流 (GVIC)过程 ,研究结果表明 :⑴模式能很好地模拟各层土壤温度的年、季和日变化。冬季土壤温度下层高于上层 ,而在夏季上层高于下层 ,这种上下层温度的转换时间大约在 4和 10月份 ,这与实测土壤温度的年变化非常一致。较为准确地模拟了各层土壤温度日变化的时滞效应。⑵用南京和武汉站的资料 ,将BATS地表径流方案模拟的地表水分分量与GVIC方案进行比较 ,BATS地表径流方案模拟的地表水分分量 ,与总水量的平衡相差较大 ,而GVIC模拟的效果相对较好 ,地表总水量基本上与降水总量达到了平衡     

Quantitative Evaluation of Water Deposited By Dew on Monuments

Samples of White and Green Carrara marble, and three types oflimestone and brick exposed in the field vertically and horizontally were used to evaluate condensationon monuments during clear sky nights. Experiments in a simulation chamber under controlledconditions led to a general equation for the actual amount of water deposited on a surface by dew.This is determined by: How much and for how long the surface temperature falls below the dew point,the moisture content in the air and the ventilation. On clear nights, the condensation on buildingstructures facing the sky may reach some 0.2 kg m^-2 (or 0.2 mm), whereas condensation on verticalsurfaces is very small. Computation of the seasonal trend of night-time condensationshowed that the maximum amount of water condensed per night occurs in the autumn, with the moreabundant concentration of moisture in the air. The total amount of water condensed per month isfound to be a maximum in the summer-autumn period. Morning condensationfor the thermal inertia of monuments is also relevant, and has been calculated to reach the same order of magnitude as thenocturnal dew. A detailed analysis of the temperature and mixing ratio profiles near a condensingsurface has shown two different situations. In still air, the two profiles follow an exponentiallaw and the thermal and the concentration layers lie within a few tens of millimetres. Inthe presence of turbulence, the thickness of these two layers is dramatically reduced. In still air, infront of a vertical, chilly surface, the deposition rate of air pollutants by thermophoresis and/orStefan flow is increased by 3 or 4 times in comparison with a horizontal surface. In the presence ofturbulence, the thickness of the thermal and concentration layers was dramatically reduced, makingthese two kinds of deposition much faster.     

The climatic impacts of land surface change and carbon management, and the implications for climate-change mitigation policy

Strategies to mitigate anthropogenic climate change recognize that carbon sequestration in the terrestrial biosphere can reduce the build-up of carbon dioxide in the Earth’s atmosphere. However, climate mitigation policies do not generally incorporate the effects of these changes in the land surface on the surface albedo, the fluxes of sensible and latent heat to the atmosphere, and the distribution of energy within the climate system. Changes in these components of the surface energy budget can affect the local, regional, and global climate. Given the goal of mitigating climate change, it is important to consider all of the effects of changes in terrestrial vegetation and to work toward a better understanding of the full climate system. Acknowledging the importance of land surface change as a component of climate change makes it more challenging to create a system of credits and debits wherein emission or sequestration of carbon in the biosphere is equated with emission of carbon from fossil fuels. Recognition of the complexity of human-caused changes in climate does not, however, weaken the importance of actions that would seek to minimize our disturbance of the Earth’s environmental system and that would reduce societal and ecological vulnerability to environmental change and variability.     

顾及地块时空特点的地籍数据组织及查询

通过分析地块变更的时空变化过程，总结出具有父子关系的时态地块的空间相交性和时间相接性特点，归纳出查询这种关系的约束条件。利用扩展时空复合模型和元组时区标记，借助于变更地块的约束条件，设计出查询变更地块的时态链算法。     

丽江地震序列的震源机制,发震应力场和破裂特征

丽江７．０级地震震区位于我国西南地区现代构造应力场空间分布的复杂地区，区域应力场主压应力优势方位为南南东。震区位于可能受到多种构造动力源作用的特定构造运动环境中。获得了主震和２２个ＭＬ≥４．０级余震的震源机制Ｐ波初动解，分析表明，主震发震应力场为北３°东，与震区区域应力场主压应力优势方位有一个小角度的偏差。主震的发震应力不仅有水平应力的作用，同时还有显的垂直应力的作用。在余震序列发展中震区呈现出     

四川地区强震发生条件的综合分析

根据发震断层的时代，发震构造的应力和几何结构条件，对四川地区的强震发生条件进行了综合分析，结果表明，四川地区孕育和发生强震的断层主要晚更新世以来，特别是全新世以来活动的断裂；强震多发生在主压力方向与断层交角成３０°～６０°之间的最危险滑动角值范围，走滑断层的斜列状结构，断裂的交叉结构，断裂的枢纽结构，断裂上的弯曲，转折部位以及断裂带上的横向隆起，拗陷及其交接部位都是发震构造的结构特征，有利于强震的