基于Hyperion影像的涩北气田油气信息提取

 对柴达木地区涩北气田地质地理环境下的蚀变矿物进行分析，结合卫星高光谱遥感数据Hyperion的图谱，对已知气田区与背景区光谱特征进行相关分析，确定了932.64~1 346.25 nm与2 002.06~2 385.5 nm为油气信息识别的有利波长范围； 利用光谱角制图（SAM）技术提取了涩北气田油气的空间分布信息和台吉乃尔含气构造等远景区，为高光谱遥感油气勘探提供了有效技术方法与途径。     

Kinetics of bubble collision and attachment to hydrophobic solids: I. Effect of surface roughness

Influence of surface roughness of the Teflon plates on kinetics of the bubble attachment was studied. Phenomena occurring during collisions of the air bubble, rising in clean water, with Teflon plates, differing only in their surface roughness, were recorded and analysed using a high-speed camera. Variations of the local velocity of the bubble during the collisions and the time of the bubble attachment were determined. It was found that the Teflon surface roughness was the parameter of a crucial importance for the attachment time of the colliding bubble. Depending on degree of the surface roughness the time of the attachment varied by over order of magnitude (from 3 to over 80 ms). In the case the Teflon surfaces having roughness below 1 μm there were recorded four to five “approach–bounce” cycles prior to the bubble attachment. Moreover, after the first collision the rapid pulsations of the bubble shape (within fraction of millisecond) were recorded. For surfaces of roughness ca. 50 μm and larger the attachment always occurred during the first collision—there was no bouncing observed and the time of the attachment was below 3 ms. It was documented that presence of a micro-bubble at the surface facilitated attachment of the colliding bubble.     

极限荷载作用下临近基坑c-土地基的破坏模式

与地面水平时地基土体的对称破坏模式不同,临近基坑（边坡）地基土体的破坏模式呈现明显的非对称性.利用FLAC-3D数值模拟技术,研究了在竖向极限荷载作用下临近基坑c-ψ土地基不同工况时的破坏模式,得出了与J.Graham所假设的边坡附近无黏性土地基破坏模式相一致的结论.最后将数值模拟结果与大尺寸模型试验数据以及J.Graham的基于应力特征线法的非对称滑动破坏模式的地基承载力理论解进行了分析对比.结果表明,采用叠加计算方法得到的承载力系数Nγq偏于安全.     

Statistical features of aftershock distribution size for moderate and large earthquakes in Chinese mainland

Based on data of earthquake sequences with MS≥5.0 in Chinese mainland from 1970 to 2004,for different se-quence types and different rupture modes of the main shock,the relationship between aftershock distribution size Rand the magnitude of the main shock M0 has been studied statistically.Considering the rupture mode of the mainshock,we give the quantitative statistical relationships between R and M0 under 95%confidence level for differentsequence types.Qualitatively,lgR,the logarithm of the aftershock distribution size,is positively correlative to theM0,but the data distribution is dispersed.Viewing from different sequence types,the correlation between R and M0is very weak for isolated earthquake type(IET)sequence,R distributes in the range from 5 to 60 km;For main-shock-aftershock type(MAT),lgR is positively correlative to M0;For multiple main shock type(MMT),the core-lation between lgR and M0 is not very obvious when M0≤6.2 and R distributes in the range from 5 to 70 km,whileit shows a linear correlation when M0≥6.3.The statistical results also show that the occupational ratios of differentsequence types for strike-slip and oblique slip are almost the same.But for dip-slip(mostly are thrust mechanisms),the ratio of MAT is higher than that of IET and MMT.Comparing with previous results,it indicates that,when M0is large enough,R is mainly determined by M0 and there is almost no relationship with the rupture mode of themain shock.     

型钢高强混凝土柱轴压比限值的试验研究

通过20个型钢高强混凝土柱的低周反复加载试验对其受力性能进行了研究，分析了剪跨比、轴压比、配箍率以及混凝土强度对型钢高强混凝土柱延性的影响，提出了不同剪跨比、不同配箍率的型钢高强混凝土柱的轴压比限值。其中，剪跨比大于2．0的型钢高强混凝土柱的轴压比限值由大、小偏心界限破坏时力的平衡条件并结合试验结果确定，而剪跨比小于2．0的型钢高强混凝土柱的轴压比限值则通过与剪跨比大于2．0的型钢高强混凝土柱的延性对比加以确定。     

中国大陆中强以上地震余震分布尺度的统计特征

依据1970年以来记录相对完备的MSge;5.0地震序列资料，统计研究了中国大陆余震分布尺度与序列最大地震震级M0及最大地震破裂形式之间的关系. 在95%置信概率下，考虑主震破裂形式， 分序列类型给出了余震分布尺度与M0之间的统计关系. 定性而言，余震分布尺度的对数lgR与M0正相关， 但数据分布较为离散. 分类型来看， 孤立型序列余震分布尺度与M0之间统计相关程度低， 余震分布尺度介于5~60 km之间； 主余型序列lgR与M0正相关； 多震型序列当M0le;6.2时lgR与M0之间相关性不显著，余震分布尺度介于5~70 km之间， 当M0ge;6.3时lgR与M0线性相关. 统计结果还表明， 走滑近走滑及斜滑型主震所导致序列类型比例之间没有显著差异，而倾滑近倾滑型主震（主要为逆断型破裂）所导致的主余型序列所占比例较高， 孤立型及多震型序列所占比例则相对较低. 对比研究显示， 当M0较高时，余震分布尺度主要取决于主震大小而与主震破裂形式关系不明显.      

“醉汉林”作为滑坡和边坡变形特征标志的意义——以陕西陇县地区为例

“醉汉林”一般被当做滑坡存在的一种标志。在陕西宝鸡地区进行地质灾害详细调查的过程中,发现变形边坡也有“醉汉林”分布。对陕西陇县郭家庄变形边坡“醉汉林”的树木倾斜角与边坡的倾角进行了测量,并结合几何学分析,认为树木倾斜角反映了边坡倾角的变化,并得出边坡倾角不断变陡是该地区边坡变形的一种主要方式的结论。研究结果表明,“醉汉林”有着多样而具体的指示意义:“醉汉林”记录了边坡变形的历史,可以作为区分滑坡与变形边坡的标志,“醉汉林”可以指示滑坡及边坡的状态,还可以判断滑坡剪出口是否存在。     

改进的光谱角制图沿照度方向分类法及其应用——以ETM数据为例

选取多光谱遥感数据（ETM）对新疆北山西段中坡山笔架山一带进行了遥感蚀变信息提取方法研究。根据光谱角制图信息增强方法的优缺点,通过对光谱照度的研究,提出了结合光谱角分类方法进行沿光谱照度方向距离分类的信息提取方法。实验表明,该方法应用于ETM数据,增强了目标信息,同时剔除掉因照度所产生的大量非目标信息,为优化信息提供了一种有效的方法。在地形比较平坦的研究区取得了很好的应用效果。     

Influence of diversion angle on water and sediment flow into diversion channel

Accumulation of the sediment in the stream of the diversion channels adversely affects its operational systems. Diversion channels are often constructed perpendicular to the main river. In this study, the water flow and sediment transport in the diversion channel with different angles were investigated in an attempt to maximize water discharge and minimize sediment discharge. A physical model with movable bed was used to simulate water and sediment flow with five diversion angles (θ) between (30°–90°). Moreover, three bed width ratios (B_r) (the relation between diversion to main channel bed width) between 30% and 50% and five total discharges between (7.25 L/s to 12.25 L/s) were considered for each case of (θ). The results showed, up to 10%, increasing in proportion discharge ratios for 30 and 45 diversion angles compared with 90° diversion angle. The results also showed that the lowest diversion sediment concentration was provided by the (θ) of 30°. Across all scenarios, the average proportion concentration reduction was 64%, compared with 90° diversion angle. Closer observation of the diversion system mechanism confirmed that decreased (θ) result in decreased sediment concentrations in the diversion channels. In conclusion, the diversion channel water and sediment discharge could be effectively managed by changing the (θ) to 30° or 45° instead of 90°.     

冻结粉土动强度的荷载效应及长期极限动强度

荷载效应包括速率效应和疲劳效应两部分．速率效应使冻土的动强度和退荷回弹动弹模随应变速率加快而提高;疲劳效应使冻土的动强度随振频增加而下降,但在低应变速率下却使动强度略有提高．在高应变速率下动强度大于静强度,在低应变速度下动强度小于静强度,其间存在一个临界应变速率．通过动强度－破坏振次关系,可确定长期极限动强度．