大别造山带地壳泊松比结构与超高压变质带—来自宽角反射与近垂直反射剖面的启示

综合宽角反射、近垂直反射的探测结果和有关地质资料，对大别造山带地壳结构和超高压变质带研究显示：大别造山带地壳具有层块结构特征。沿安义－庄墓剖面，上地壳有7个弹性块体，中地壳有5个，下地壳有4个。扬子与华北地块的主缝合带是超高压变质带，扬子地块与大别造山带的现今分界线是与郯庐断裂相交的太湖－马庙断裂，磨子潭－晓天断裂是大别造山带的北界，北淮阳构造带呈楔状向下插入，它与华北地块的分界是肥中断裂。郯庐断裂在中、上地壳近于直立，下地壳向西倾斜。超高压变质带的厚度为5－7km，产状向北插入到北大别块体之下，折返过程是构造就位，不是大别山的均匀抬升，折返的主运动面是水吼－五河高温剪切带。     

西南某电站右岸倾坡内夹泥裂隙成因探讨

西南某拟建大型水电站的右岸岩体中存在倾向坡内的夹泥裂隙，通过对其的发育情况以及所处的地质环境进行系统的研究和认真剖析，认为该区内的倾坡内夹泥裂隙的成因并非正常卸荷引起，而是在构造的基础上，穹隆挽近期隆起的结果，为右岸坝肩稳定性评价提供了可靠的依据。     

基于GM(1,1)优化模型的岩石边坡变形预报

岩石边坡系统是一典型灰色系统，其变形发展过程可以用灰色预测模型完成。尽管传统GM（1，1）模型预测有很多成功的实例，但是也存在一些预测偏差过大的情况，必须对其进行优化。逐步迭代法GM（1，1）模型不仅收敛速度快，而且与原始数据库序列的凹凸性保护一致。利用自编的计算程序对马步坎边坡预测测点G1沉降和开裂进行预测分析，结果表明逐步迭代法GM（1，1）优化模型计算精度较传统GM（1，1）模型和背景构造法GM（1，1）优化模型高，较好地反映了岩石边坡的变形趋势。     

福建若干基础地质问题及研究方向探讨

就当前福建基础地质调查研究中涉及的华夏古陆，岩浆构造活动，地质构造等有关问题研究现状及各自不同认识作初步归纳。并对其进一步研究方向作粗浅探讨。     

吐哈盆地侏罗纪煤中主要组分结构特征与生烃性分析

在高纯度煤岩显微组分分离富集的基础上,应用透射式显微傅里叶红外光谱技术 (Micro FTIR),对吐哈盆地侏罗纪煤中的主要组分-镜质体、丝质体、角质体、藻类体的结构组成进行了测定。结果表明 :藻类体主要由长链脂族结构组成,芳香结构含量相对较少;角质体和基质镜质体中含有较丰富的芳香结构以及长链脂族结构;而丝质体则主要由芳香结构组成,脂族结构含量很少。显微组分的这种结构特征决定了藻类体具有很高的生烃潜力、角质体和镜质体的生烃潜力中等、而丝质体的生烃潜力则很低。对于吐哈盆地煤成油来说,由于藻类体主要由长链脂族结构组成,并且生烃潜力也高,因此其具有高的液态烃产率、丝质体的产油率最小、角质体和镜质体的液态烃产率中等。由于镜质体是本区煤中含量最高的组分。因此,对于吐哈盆地所形成的具有工业规模的油田来说,镜质体应该是主要的贡献组分之一。但对于富含藻类体的厚层状烛藻煤,由于它类型好,品质高、生烃潜力大、以中长链脂族结构为主,是煤成油最理想的源岩。     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

Ground‐shaking mapping for a scenario earthquake considering effects of geological conditions: a case study for the 1995 Hyogo‐ken Nanbu,Japan earthquake

In order to examine the applicability of ground‐shaking mapping techniques to a near‐field earthquake, a peak ground velocity map of the 1995 Hyogo‐ken Nanbu, Japan earthquake computed from seismic zoning methods that consider the effects of geological conditions is compared with the actual observed intensity map. When computing the ground‐shaking map, the site amplification at each site is calculated in terms of the average shear‐wave velocity of the ground estimated from the corresponding geomorphological conditions. This map shows a relatively good agreement with the observed intensity map. However, the computations provide smaller values for certain disastrous areas of the earthquake, where the effects on ground motion of a deep, irregular underground structure have been reported. The effect of such structures on site response is examined implementing 2D FEM analyses, thereby being also incorporated into the method. Results considering the effect of the irregular underground structure show better agreement with the observed intensity map. Copyright © 2002 John Wiley & Sons, Ltd.     

塑性岩体与逆冲构造变形关系讨论——库车坳陷西部实例分析

在冲断构造分析过程中 ,常常把塑性岩体仅仅作为滑脱层看待 ,忽略了一些地区塑性变形与冲断构造变形的复合作用。根据露头、钻井、地震等资料 ,应用平衡剖面等技术对库车坳陷西部的构造变形进行了恢复分析 ,发现库车坳陷西部的下第三系盐、膏、泥等塑性体受重力和构造应力联合作用发生了复杂的变形。以往单纯用冲断构造模式分析其成因机制 ,没能科学地反映中生界与新生界之间的变形缩短量的差异 ,通过塑性体的底辟变形和滑脱变形依存关系的剖析 ,能够恢复库车坳陷西部构造演化过程 ,进而为油气勘探提供指导。     

东昆仑东段中更新世以来的成山作用及其动力转换

对东昆仑造山带东段第四纪构造及与地貌关系的分析表明，现代山盆相间的地貌格局成型于中更新世，且在中更新世以来发生了多次构造变形体制的转换。根据布青山北部查干额热格地区第四系剖面的构造、地层时代及地层与构造关系的分析表明，中更新世时期为伸展构造体制，昆仑山内部开始发生了差异隆升，布青山开始崛起。中更新世末应力体制发生急剧变化，由伸展体制转为收缩事件，又急速转为伸展构造体系，短暂的收缩事件造成了中更新世冲洪积层的褶皱，随后的伸展则导致了影响深刻的向北依次断落的阶地状正断层系统。晚更新世应力体系再度发生重大转换，伸展正断层体系被左旋走滑运动体系所代替，并一直延续至今。中更新世以来多次隆升构造变形体制的转换说明东昆仑地区的成山过程受控于多种动力背景，而非单一的挤压抬升。隆升构造变形体系的确定及其时代约束为深入刻划青藏高原东北缘隆升作用的动力过程提供了重要信息。     

鄂尔多斯盆地上古生界高分辨率层序地层分析

按基准面旋回原理，将鄂尔多斯盆地上古生界本溪组（C2b)、太原组（P1t）、山西组(P1s)和下石盒子组（P1xs)划分为3个超长期、8个长期、19个中期和62个短期旋回层序：较为详细地介绍了各级别层序的结构类型、叠加样式和沉积演化序列；建立以长期旋回层序为年代地层框架，中期旋回层序为等时地层对比单元的层序的地层格架；并讨论高分辨率层序地层与天然气藏的关系。