基于敏感性分析的裂隙岩体渗流与应力静态全耦合参数反演

基于求解稳定渗流场与弹性位移场耦合问题的全耦合分析方法,应用提出的混合遗传算法作为优化算法,同时利用水头、位移等多类型量测资料,提出了裂隙岩体渗流与应力静态全耦合的参数反演方法。在目标函数建立中考虑了实测水头对渗流参数的敏感性,在待反演力学未知参数的选取中,依据提出的相对灵敏度概念,考虑了实测位移对力学参数的敏感性。针对某裂隙岸坡算例,研究了水库蓄水过程中位移场对力学参数敏感性,据此实现位移测点的优化布置,并以渗流场与位移场全耦合正分析计算结果作为假想实测值,进行该岩坡的全耦合参数反演分析,从而验证了所提出理论与研制程序的正确性和可行性。     

近50年来北极斯瓦尔巴地区冰川物质平衡变化特征

利用长时间序列的冰川物质平衡资料,详细分析了北极斯瓦尔巴地区冰川的物质平衡变化特征以及气候因子对物质平衡的影响。结果表明：近50年来斯瓦尔巴地区冰川物质平衡变化主要呈负平衡、零平衡/略微增长两种状态。冰川净平衡一般为负值,年际变化波动幅度较大且呈负平衡趋势,累积物质平衡表现出长期稳定的负平衡增长态势。除Kongsvegen冰川外,其他冰川不存在短期内的平衡波动。季节变化表现为夏季消融、冬季积累,且夏季消融比冬季积累波动更大,冰川净平衡与夏季消融保持同步变化趋势。冰川净平衡与平衡线高度（ELA）呈负相关（平均相关系数为-0.89）,与积累区面积比率（AAR）呈正相关（平均相关系数为0.84）,该地区大多数冰川AAR减小,说明冰川物质补给处于劣势,冰川物质平衡向负平衡发展。夏季气温升高是斯瓦尔巴地区冰川表面物质加速亏损的直接原因。     

泥盆系弗拉阶/法门阶之交事件沉积和海平面变化

在华南板块南部被动大陆边缘和西伯利亚板块南部活动大陆边缘弗拉阶/法门阶之交识别出7种物理事件相: 细粒钙屑浊积岩相、钙质角砾岩相、软变形灰岩相、含微球粒的粒泥灰岩相、凝灰质砾岩相、黑色页岩相和火山喷溢相.它们在法门阶下Palmatolepis triangularis带底部和/或上Palmatolepis rhenana带底部具有广泛的分布, 可能是两次陨击事件记录, 是良好的高分辨率年代地层对比标志.弗拉期/法门期之交的海平面变化不具有同步性和一致性, 可分辨出2种型式(阶跃型和渐进型) 和5种状态(弗拉期最末期下降→法门期最初期上升、弗拉期最末期上升→法门期最初期下降、弗拉期最末期上升→法门期最初期上升、弗拉期最末期下降→法门期最初期下降、弗拉期最末期与法门期最初期海平面变化不明显).弗拉阶/法门阶之交生物的阶梯状绝灭可能与从上Palmatolepis rhenana带底部至Palmatolepis crepida带不均匀分布的6次陨击事件密切相关.      

方解石脉双晶纹方法在工程勘察中的应用

在工程区基岩被第四纪土、江水等覆盖的情况下，如何充分利用好获得的钻孔岩芯来分析断层的发育和活动性情况就显得非常重要。为此，地基勘察中引入一种显微构造分析方法，即方解石脉双晶纹分析方法。方解石脉双晶纹能解决断层的活动期次、每一期次的强度、断层应力场、断层性质、断层活动时的环境条件和最后一次活动的时代等问题。由于方解石脉双晶纹发育的广泛性，使之具有推广价值。     

西南山区某铁路隧道口高位落石三维运动特征分析

西南山区某铁路隧道口上部广泛分布着高位危岩体,对下部隧道建(构)造物具有严重的威胁.采用Rockfall Analyst软件对该隧道上部五类不同尺寸的高位危岩体进行三维运动轨迹数值模拟,研究表明:研究区的高位危岩落石具有弹跳高度大、速度快、冲击能量高的特点;弹跳高度、运动速度与危岩落石的质量无关,冲击能量大小与落石质量...     

滇西马厂箐斑岩铜(钼)矿床成岩成矿时限的厘定

滇西马厂箐富碱侵入岩为一复式岩体,存在多期次岩浆侵入活动;最早岩浆活动始于52Ma,中期岩浆活动为42～47Ma,晚期岩浆活动最强烈,其时间为33～37Ma,末期岩浆活动为29～32Ma。马厂箐铜钼矿床早期成矿发生在37～40Ma左右,晚期成矿大约在34—35Ma;与区域上其它与富碱侵入岩有关矿床的形成时间相当吻合。马厂箐矿床在时、空上与矿区富碱侵入岩关系密切,其成矿作用主要与晚期的岩浆侵入活动有关。     

基于块体化程度确定裂隙岩体表征单元体

表征单元体（REV,或典型单元体）的存在是应用连续介质方法研究岩体问题的前提,因此,裂隙岩体表征单元体研究是岩体力学及岩体水力学中的一个基础问题,表征单元体的存在与否可以从不同物理参数的角度进行分析。从岩体块体化程度的角度对其存在性进行了较系统的分析,把岩体中由裂隙圈闭形成的孤立块体的总体积在岩体中所占体积百分比定义为裂隙岩体的块体化程度。介绍了GeneralBlock软件的基本分析过程,利用软件建立了三维裂隙岩体模型。根据国际岩石力学学会的裂隙分级,针对5个延展性级别、7个间距级别建立了35种岩体结构模型。利用GeneralBlock对这35种岩体进行了块体识别,分别讨论了这35种岩体结构的块体化程度随着模型范围变化的波动情况。由于所建立的岩体结构模型是随机的,对每种结构的每个研究范围进行了5次随机实现。结果表明,对所有的35种岩体,表征单元体的尺寸在4～8倍间距之间,不超过8倍间距。     

A Common Reference Material for Cadmium Isotope Studies – NIST SRM 3108

Research into natural mass‐dependent stable isotope fractionation of cadmium has rapidly expanded in the past few years. Methodologies are diverse with MC‐ICP‐MS favoured by all but one laboratory, which uses thermal ionisation mass spectrometry (TIMS). To quantify the isotope fractionation and correct for instrumental mass bias, double‐spike techniques, sample‐calibrator bracketing or element doping has been used. However, easy comparison between data sets has been hampered by the multitude of in‐house Cd solutions used as zero‐delta reference in different laboratories. The lack of a suitable isotopic reference material for Cd is detrimental for progress in the long term. We have conducted a comprehensive round‐robin assay of NIST SRM 3108 and the Cd isotope offsets to commonly used in‐house reference materials. Here, we advocate NIST SRM 3108 both as an isotope standard and the isotopic reference point for Cd and encourage its use as ‘zero‐delta’ in future studies. The purity of NIST SRM 3108 was evaluated regarding isobaric and polyatomic molecular interferences, and the levels of Zn, Pd and Sn found were not significant. The isotope ratio ¹¹⁴Cd/¹¹⁰Cd for NIST SRM 3108 lies within ～ 10 ppm Da^?1 of best estimates for the Bulk Silicate Earth and is validated for all measurement technologies currently in use.     

GGR Biennial Critical Review: Analytical Developments Since 2014

This GGR biennial critical review covers developments and innovations in key analytical methods published since January 2014, relevant to the chemical, isotopic and crystallographic characterisation of geological and environmental materials. In nine selected analytical fields, publications considered to be of wide significance are summarised, background information is provided and their importance evaluated. In addition to instrumental technologies, this review also presents a summary of new developments in the preparation and characterisation of rock, microanalytical and isotopic reference materials, including a précis of recent changes and revisions to ISO guidelines for reference material characterisation and reporting. Selected reports are provided of isotope ratio determinations by both solution nebulisation MC‐ICP‐MS and laser ablation‐ICP‐MS, as well as of radioactive isotope geochronology by LA‐ICP‐MS. Most of the analytical techniques elaborated continue to provide new applications for geochemical analysis; however, it is noted that instrumental neutron activation analysis has become less popular in recent years, mostly due to the reduced availability of nuclear reactors to act as a neutron source. Many of the newer applications reported here provide analysis at increasingly finer resolution. Examples include atom probe tomography, a very sensitive method providing atomic scale information, nanoscale SIMS, for isotopic imaging of geological and biological samples, and micro‐XRF, which has a spatial resolution many orders of magnitude smaller than conventional XRF.     

韧性剪切带糜棱岩类质量平衡分析——以豫西秦岭群蛇尾剪切带为例

蛇尾剪切带中糜棱岩的质量平衡分析表明:(1)以Al_2O_3守恒为限制条件,该剪切带损失了10％土的质量和体积,糜棱岩类有Na_2O,Zr,Sr的获得;SiO_2,TiO_2,FeO,Fe_2O_3,MgO,MnO,CaO,K_2O及Co,Ni,V,Cr,Cu,Y则损失了;(2)从初糜棱岩-糜棱岩,初糜棱岩-超糜棱岩和糜棱岩-超糜棱岩得出的质量等比线显示,糜棱岩类之间没有明显的质量和体积损失。糜棱岩组分的得失主要发生在初糜棱岩阶段,同初糜棱岩相比,糜棱岩、超糜棱岩有CaO的获得,FeO,MgO,TiO_2,Cr,Co,V,Y微弱的获得,Na_2O则有轻微的损失。