Borehole pressure correction equation

Conclusion A method of calculation for borehole pressure has been developed and compared to measured data for PETN. The results show that by adjusting the ratio of the specific heats using an equation derived from a curve fit of a pressure as a function of decoupling ratio graph, the plot shifts to a position within the ranges of the measured data. Also, at this point the proper specific heat may be obtained for a given gaseous mixture. Although other mixtures have been considered the results are not yet conclusive, but preliminary values seem to hold for the methodology used.     

Investigation of electrical anisotropy in the deep borehole KTB

Information about electrical anisotropy in and around the deep borehole of the German Continental Deep Drilling Program (KTB) has been acquired using three different methods: (1) Under surface temperature and pressure conditions, the azimuthal dependence of resistivity has been measured in horizontal planes perpendicular to the axes of drill cores. (2) Simulated in-situ conditions (high temperature and pressure) have been applied to mini cores drilled at different orientations to structural features such as foliation. The resistivity was then measured in the direction of the mini cores' long axes. (3) Under quasi-in-situ (downhole) conditions, the azimuthal dependence of resistivity has been measured in horizontal planes using the Azimuthal Resistivity Imager (ARI), a down hole logging tool.These investigations have shown that electrical anisotropy is strongly related to structural features. The anisotropy of gneisses is the highest due to the strong foliation (averaged anisotropy factor 2.8). Lamprophyres are most isotropic (factor 1.2). Most rocks from KTB are amphibolites with intermediate anisotropies (factor 1.3). The anisotropies measured under surface temperature and pressure conditions and quasi-in-situ conditions on amphibolites are approximately the same, whereas anisotropies under simulated in-situ conditions are partially higher.Furthermore, the anisotropies measured on the cm to m scale using the various methods outlined above shall be compared with large scale anisotropies of the km scale measured around KTB using Magneto Tellurics.     

倾斜基岩上的土-框架相互作用研究

倾斜基岩上的框架是山地、丘陵地区多见的一种结构形式，但以往对其抗震性能研究很少。本文利用二次开发后的ANSYS对倾斜基岩上的框架的抗震性能进行了上下部相互作用分析。在研究中发现，考虑土一结相互作用后，结构的高阶振型在地震反应中的参与程度提高；可能在结构的地震反应傅里叶谱中形成双峰；并使地震反应沿结构高度的分布不再沿直线变化，而呈锯齿状分布。由于倾斜基岩将降低土层对地震波的放大作用，但基本不改变地基的卓越频率，因此倾斜基岩将会抑制上部结构的地震反应；而倾斜基岩上结构的地震反应分布将比相应平坦基岩上结构的地震反应分布更接近直线形分布，但变化形状基本相同。     

北京昌平地震台TJ-1体积钻孔应变仪潮汐参数动态特征及其稳定性研究

介绍了北京昌平地震台 TJ- 1型钻孔体积应变仪 1 989年 7月～ 2 0 0 0年 1 2月期间的观测结果 ,分析了潮汐响应函数的动态特征及其稳定性。由全序列观测数据调和分析所得 :O1波潮汐因子 VO1=0 .791 6± 0 .0 1 2 8、相位滞后 ΔΦ0 1=1 .9°;K1波潮汐因子 Vk1=0 .6 4 42±0 .0 0 88、相位滞后ΔΦk1=- 4.2°;M2 波潮汐因子 VM2 =0 .6 5 0 0± 0 .0 0 3 8、相位滞后ΔΦM2 =-2 .9°。液态地核振荡因子 A=VO1/VK1=1 .2 2 8,比理论值小 6 .5 %。     

浅谈野外岩心地质编录工作

岩心地质编录是收集和观察研究岩心中所赋存的各种地质信息和地质现象的一项重要的基础性地质工作。本文根据具体实践经验，简要介绍了岩心地质编录工作的3个阶段以及贯穿于编录工作始终的取样工作。     

Strain and tilt changes measured during a water injection experiment at the Nojima Fault zone, Japan

Abstract In order to make geophysical and geological investigations of the Nojima Fault on Awaji Island, Japan, three boreholes measuring 1800 m, 800 m and 500 m deep were drilled into the fault zone. The fault is one of the seismic source faults of the 1995 Hyogo-ken Nanbu earthquake of M 7.2. A new multicomponent borehole instrument was installed at the bottom of the 800 m borehole and continuous observations of crustal strain and tilt have been made using this instrument since May 1996. A high-pressure water injection experiment within the 1800 m borehole was done in February and March 1997 to study the geophysical response, behavior, permeability, and other aspects of the fault zone. The injection site was located approximately 140 m horizontally and 800 m vertically from the instrument. Associated with the water injection, contraction of approximately 0.7 × 10⁻⁷ str (almost parallel to the fault) and tilt of approximately 1 × 10^-7 rad in the sense of upheaval toward the injection site were observed. In addition to these controlled experiments, the strainmeter and tiltmeter also recorded daily variations. We interpret strain and tilt changes to be related to groundwater discharge and increased ultra-micro seismicity induced by the injected water.     

ENCORE钻孔导斜系统

ENCORE钻孔导斜系统由设计先进的MOLE型固定楔、MULE型活楔、RATTY型扩孔导向矛和DOLPHIN型定向仪组成。可在40－96mm钻孔中进行定向钻进，解决钻孔纠斜或分支孔钻进问题。在分析研究其、工作原理和操作方法基础上进行对比分析，指出优点并介绍了使用效果。     

Climate change of the last millennium inferred from borehole temperatures: regional patterns of climatic changes in the Czech Republic — Part III

Accurate temperature–depth profiles may help to assess the temperature variations associated with the climate changes in the past. Ninety-eight ground surface temperature histories inverted from the temperature–depth borehole logs drilled on the territory of the Czech Republic [Bodri, L., ermák, V., 1995. Climate changes of the last millennium inferred from borehole temperatures: results from the Czech Republic — Part I. Global Planet. Change 11, pp. 111–125; Bodri, L., ermák, V., 1997. Climate changes of the last two millennia inferred from borehole temperatures: results from the Czech Republic — Part II. Global Planet. Change 14, pp. 163–173.] are used to reconstruct the regional patterns of the respective climate change. The climate was mapped for the following periods: 1100–1300 A.D. (Little Climatic Optimum), 1400–1500 A.D., 1600–1700 A.D. (main phase of the Little Ice Age), and for the most recent climate trend after year 1960. Comparison of the obtained maps with the meteorological observations and proxy climatic reconstructions confirmed good applicability of the “geothermal” paleoclimatic reconstructions for the regional studies.     

Determination of Porosity and Permeability out of Dispersion Analyses of Borehole Wall Displacements

Waves carried in the borehole can be measured by the use of controlled sources inside the borehole and receivers located in the same borehole as well. This article gives the theoretical background and develops a new method to determine rock-physical parameters out of such controlled measurements of waves carried inside the borehole. Theoretical dispersion curves of the group velocities are matched to dispersion analyses of registrations obtained in the borehole. This inversion process intends to determine the in situ porosity and permeability of the rock.