渤海中南部悬浮物海洋调查资料分析

对于悬浮物 (SPM)的研究目前已引起诸多学者关注。作者利用 1998和 1999年的中德合作海洋调查所获得的资料进行分析。主要进行三个方面的工作 :研究悬浮物与透明度的关系 ;研究悬浮物与浊度的关系 ;估计海底剪切速度。并为研究悬浮物输运提供资料和作前期研究     

大气垂直速度计算中校正方法的探讨

本文对大气运动中垂直速度ｗ计算中的几种校正方法作了分析比较，并在前人工作的基础上，对校正方法作了改进，提出了进行低通滤波、散度校正和法线风分量校正的方法。通过这些校正，使计算出的平均散度和垂直速度的垂直廓线能维持原计算曲线的形式，并能满足整个气层连续方程积分为零的条件，也符合误差随高度增大的情况。     

Internal generation of waves: Delta source function method and source term addition method

In this study, we investigate two internal wave generation methods in numerical modeling of time-dependent equations for water wave propagation, i.e., delta source function method and source term addition method, the latter of which has been called the line source method in literatures. We derive delta source functions for the Boussinesq-type equations and extended mild-slope equations. By applying the fractional step splitting method, we show that the delta source function method is equivalent to the source term addition method employing the energy velocity. This suggests that the energy velocity should be used rather than the phase velocity for the transport of incident wave energy in the source term addition method. Finally, the performance of the delta source function method is verified by accurately generating nonlinear cnoidal waves as well as linear waves for horizontally one-dimensional cases.     

Imaging of Buried Archaeological Materials: The Reflection Properties of Archaeological Wood

Effective marine archaeological site management demands detailed information on not only the spatial distribution of artefacts but also the degradation state of the materials present. Although sonar methods have frequently been used in an attempt to detect buried wooden shipwrecks they are currently unable to indicate their degradation state. To assess the sensitivity of acoustic measurements to changes in the degradation state of such material, and hence the potential for sonars to quantify degradation, laboratory measurements of compressional wave velocity, as well as bulk density for oak and pine samples, in varying states of decay, were undertaken. These data enabled the calculation of theoretical reflection coefficients for such materials buried in various marine sediments. As wood degrades, the reflection coefficients become more negative, resulting in the hypothesis that the more degraded wood becomes, the easier it should be to detect. Typical reflection coefficients of the order of −0.43 and −0.52 for the most degraded oak and pine samples in sand are predicted. Conversely, for wood exposed to seawater the predicted reflection coefficients are large and positive for undegraded material (0.35 for oak, 0.18 for pine) and decrease to zero or slightly below for the most degraded samples. This indicates that exposed timbers, when heavily degraded, can be acoustically transparent and so undetectable by acoustic methods. Corroboration of these experimental results was provided through comparison with high resolution seismic reflection data that has been acquired over two shipwrecks.     

Dynamic analysis of a vertical plate exposed to breaking wave impact

From the experimental studies in recent years, it has become known that when a wave breaks directly on a vertical faced coastal structure, high magnitude impact pressures are produced. The theoretical and experimental studies show that the dynamic response of such structures under wave impact loading is closely dependent on the magnitude and duration of the load history. The dynamic analysis and design of a coastal structure can be succeeded provided the design load history for the wave impact is available. Since these types of data are very scarce, it is much more convenient to follow a method which is based on static analysis for the dynamic design procedure. Therefore, to facilitate the dynamic design of a vertical plate that is exposed to breaking wave impact, a multiplication factor called “dynamic magnification factor” is herein presented which is defined as the ratio of the maximum value of the dynamic response to that found by static analysis. The computational results of the present study show that the dynamic magnification factor is a useful ratio to transfer the results of static analysis to the dynamic design of a coastal plate for the maximum impact pressure conditions of p_max/γH₀≤18.     

船舶受冲击力作用时的水动力试验研究

根据冲量相似的要求进行船舶在冲击作用下的模型试验，并将模型试验结果与理论计算及实际试验进行了对比和分析。     

海洋沉积物声速与物理参数的关系

海洋沉积声速与物理性质密切相关，特别是含水量Ｗ和孔隙度Ｎ，它们在建立回归议程和预报沉积物性质中有所贡献。中国东，南海沿海沉积物的资料和数据表明：声速和声速比可以用来预报沉积物性质。     

珠江口现代沉积速率及其反映的沉积特征

文章分析了珠江河口海区泥沙来源及淤积动态,采用以历史海图分析对比为主,~(210)Pb测年数据校核等方法,参考有关沉积速率定性方面的标志,推算出珠江口不同地段的现代沉积速率,并相应划分出高速率沉积、快速率沉积、中速率沉积和慢速率沉积或稍有侵蚀等4个分区.进而,还论述了沉积作用的特征.     

Prediction of impact pressure induced by breaking waves on vertical cylinders in random seas

This paper presents a method to statistically predict the magnitude of impact pressure (including extreme values) produced by deep water waves breaking on a circular cylinder representing a column of an ocean structure. Breaking waves defined here are not those whose tops are blown off by the wind but those whose breaking is associated with steepness. The probability density function of wave period associated with breaking waves is derived for a specified wave spectrum, and then converted to the probability density function of impact pressure. Impacts caused by two different breaking conditions are considered; one is the impact associated with waves breaking in close proximity to the column, the other is an impact caused by waves approaching the column after they have broken. As an example of the application of the present method, numerical computations are carried out for a wave spectrum obtained from measured data in the North Atlantic.