Validation through HVSR measurements of a method for the quick detection of site amplification effects from intensity data: an application to a seismic area in Northern Italy

An instrumental validation is attempted of an innovative approach devoted to the quick individuation, from macroseismic data, of site amplification phenomena able to significantly modify seismic hazard levels expected on the basis of average propagation effects only. According to this methodology, two evaluations of hazard are performed at each investigated locality: the former, obtained by epicentral intensity data ‘reduced’ at the site through a probabilistic attenuation function and, the latter, computed by integrating such data with seismic effects actually observed at the site during past earthquakes. The comparison, for each locality, between these two hazard estimates allow to orientate the identification of those sites where local amplifications of earthquake ground motion could be significant. In order to check such methodology, indications obtained in this way from macroseismic data are compared with the estimates of transfer functions performed through the HVSR technique applied to microtremors. Results concerning municipalities located in a seismic area of Northern Italy indicate a good agreement between macroseismic and instrumental estimates.     

Modelling of meteorological conditions at an urban scale for the PUMA winter campaign

For the winter 2000 campaign of the Pollution of Urban Midlands Atmosphere project, observation and numerical modelling of meteorological conditions over the West Midlands conurbation, UK, was undertaken. Modelling was performed using the regional atmospheric meteorological system (RAMS). This paper presents a comparison of modelled and observed wind and temperature for 25 and 26 January 2000. The RAMS model uses two nested grids with a mesh size of 2 km for the inner grid which is embedded in the outer grid with a mesh size of 8 km. Statistical evaluation of the model results against the observational data of wind speed, direction and temperature at 10 m was conducted. In general, the modelling results are in a reasonable agreement with observation. The statistical evaluation suggests that model performance is poorer for the inner grid than the outer grid as the model uncertainties (mainly mean bias) transfer from the outer to inner one. The low indices of agreement of temperature and wind are mainly associated with the systematic root-mean-square-difference values. For temperature, the systematic bias may also be affected by representation of cloud amount by the model. For wind, the model tends to have a poor performance for calm conditions, as under a stable anti-cyclonic situation local wind patterns associated with topography may develop, although the topography of the region is relatively flat. The results for the inner grid reveal some subtle spatial patterns at a scale smaller than 10 km near hills and valleys with differences in elevation of a few hundred metres.     

Development and testing of numerical methods for two-way nested air pollution modelling

A new 3-D model REGINA (REGIonal high resolutioN Air pollution model) is under development at the National Environmental Research Institute (NERI). The model is based on pieces from several models developed over the last decades at NERI. The aim of the work is to develop a nested model which can operate with very high resolution in both space and time. To fulfill this aim the choice and implementation of accurate numerical methods is crucial. The model will be applied for studying air pollution phenomena (both monitoring, forecasting and scenarios) over Denmark. The present paper is focussed on the modification, implementation and testing of a numerical method for treating the horizontal advection in the model as well as the implementation of two-way nesting techniques. The horizontal transport in the model is solved using an accurate space derivative algorithm. This method is traditionally implemented with periodic boundary conditions, however, this is not an option for nested modelling. A new method for calculating non-periodic boundary conditions has been developed in order to overcome this problem. Extensive testing of the numerical solution of the advection and the coupling of the solution of advection and chemistry in the model using Molenkamp–Crowley rotation tests have been carried out. The results show that the model with the current implementation of numerical methods is suitable for calculating air pollution levels with high resolution.     

数字化形变资料分析处理流程

根据形变数字化数据和前兆特征。主要对EIS000中提供的数据处理及异常判定方法进行了使用分析。针对固体潮成分和非固体潮成分。提出了在日常分析和会商中较为适用的方法和步骤。     

网络地理信息系统（WebGIS）在地震研究中的应用

介绍了网络地理信息系统（WebGIS）的概念、原理、实现技术和发展现状；讨论了WebGIS在地震研究中的重要作用和发展前景；开发了一个地震地质基础信息WebGIS应用系统．该系统基于浏览器／服务器体系结构，能够实现空间数据和GIS应用系统的网络共享和初步的协同工作．这一技术方案在地震研究领域具有广阔的应用前景，很值得推广．      

非规则测区三维地震偏移的边界吸收层法

对不规则测区的地震资料直接进行三维偏移不仅可减少计算量,而且可提高偏移剖面的质量. 本文在单程波方程中增加了一项简单的阻尼因子,其作用如同在实际不规则测区的外部有一个薄吸收层. 因为波穿越这个薄层时,波场值迅速衰减,所以偏移时把吸收层外边界处的波场值取为零所产生的反射非常微弱. 又因为不规则测区零边界条件偏移程序极易编制,所以就可以实现对不规则测区的地震资料直接进行三维偏移. 通过对实际地震资料的处理,说明了该方法的有效性.     

数字地震仪的发展历史及展望

地震仪经历了光点，模拟和数字的变化，数字地震仪本身由16位发展到24位，其附属设备（电缆，检波器）也是到了不同程度的发展。近年来，I／O等公司利用MEMS技术研制了新型地震检波器，这一新的发展对于地震采集尤其是多分量采集带来重要影响。     

依据剖面资料求解断层的水平位移

提出依据开挖剖面中的楔形体在受到断层作用时其厚度的变化量求解断层水平位移的方法。分析表明断层水平位移量S与楔形体在断层两侧厚度变化量Δh满足关系式S＝Δh/ρsinβ。式中ρ为楔形体在断层走向上的尖灭系数，β为断层的倾角，该关系式不仅能满足纯走滑运动的断层，而且也满足一般斜滑断层，同时提出了在剖面上判断断层水平运动性质的方法。     

科技形变资料的管理模式

科学的进步使地形变监测事业得到长足发展，市场经济的繁荣催生出形变监测行业独有的管理之道。形变监测行业是个介于科研、IT及服务行业三者之间的特殊行业，因此，它的发展必须具有一定的科学性、前瞻性和服务性。     

基于Exchange Server 5.0前兆网络邮件系统的建立

各省地震局 95 - 0 1- 0 2地震信息网络项目采用的邮件系统是基于 IRIX 6 .5操作系统的Netscape Mail Server2 .0 ,由于其应用与管理有局限性 ,笔者进行了基于 NT系统的 ExchangeServer5 .0邮件系统的应用研究 ,详细论述了基于 Exchange Server5 .0的黑龙江省地震前兆信息网络邮件系统的安装及配置过程 ,得出该网络邮件系统有管理方便、功能强大的结论