一种典型的同生沉积型微细浸染型金矿床--桂西北高龙金矿床

桂西北高龙微细浸染型金矿床位于广西田林县高龙乡。含矿硅质岩与热水沉积作用有关，而非首人认为的断裂破碎—热液硅化交代岩。矿床的典型地质特征以及地球化学特征显示该矿床具有典型的同生沉积—准同生成岩的成因特征，矿床属同生沉积型，而不是前人认为的后生热液改造型。矿床的形成与右江沉积盆地演化关系密切，含矿流体为以大气降水为主要补给源的深循环盆地卤水和与沉积物发生了同位素交换的埋藏古海水，流体的运移方式以压实驱动流为主，含矿流体主要以沉积喷流方式成矿。     

Sea-level changes and hydrothermal sedimentary mineralization of large-superlarge ore deposits among Sinian to Triassic in South China

Among the Sinian to Triassic strata in South China, the stratiform, quasi-stratiform and lenticular metallic deposits in association with hydrothermal sedimentation mainly occur in the four periods: (1) the Sinian Datangpo interglacial period, (2) the early period of Early Cambrian, (3) the late period of Middle Devonian to early period of Late Devonian,and (4) the late period of Early Permian. The four mineralization periods all happened around the maximum flooding period in the third-order seal-level cycle during the ascending stage in the first-order sea-level cycle. The deep seawater layer, starved and non-compensatory basin, low sedimentary rate, and low energy and anoxic environment during the maximum flooding period are very suitable for the formation and preservation of large to superlarge hydrothermal sedimentary deposits. The maximum flooding period also coincided with the intensified regional tectonism, extensive deep magmatism and hydrothermal sedimentation, which provide, for the formation of large to superlarge hydrothermal sedimentary deposits through the rapid accumulation of hydrothermal sediments, the needed dynamics, ore-forming materials and favorable passway for hydrothermal fluids to enter the basin.     

Sedimentary facies during early stages of flooding in an extensional basin: the Brèche Rouge de Carboneras (Late Miocene, Almería/SE Spain)

The intramontane basins of the Betic Cordilleras (SE Spain) formed subsequent to the main phase of orogenic deformation during the middle Miocene in a close genetic relation to the Trans-Alboran Shear zone. Left lateral movements along a local branch (Carboneras fault zone, CF; strike NE–SW) of this zone played a major role in controlling the formation and dynamics of the Nijar-Carboneras Basin. To the south of the fault, a major phase of strike-slip faulting is recorded during the late Tortonian. The expression of this event is the Brèche Rouge de Carboneras (BRC), which seals a deep denudational surface on top of dislocated fault blocks formed by volcanics of the Cabo de Gata complex and early Tortonian shallow marine calcarenite. The sedimentary facies of this widely distributed unit in the Carboneras-Subbasin mirror the submarine topography and the distribution of the fault zones. Along strike-slip fault zones, autoclastic breccias and neptunian dikes preferentially oriented NW–SE and NE–SW occur, which are interpreted to represent the near-surface expression of the faults. Red limestone forms the groundmass of the autoclastic breccia and infills of neptunian dikes, which exhibit multiple phases of opening of fissures, gravitational sedimentary infill, lithification, and renewed creation of cracks. Steep relief, probably along fault scarps, was mantled by epiclastic volcanic conglomerate with a red carbonate matrix. Well-lithified coarse skeletal limestone rich in planktonic foraminifera formed pavements along sediment starved rocky surfaces in deep water. Laterally, within topographic depressions, the pavement limestone grades into thick accumulations of skeletal rudstone composed of fragmented azooxanthellate corals and stylasterid hydrozoans, which were concentrated by powerful bottom currents and gravitiy flows. Within the shallow water zone of dip slope ramps, cross-bedded calcarenite and calcirudite formed. Based on textures, fabrics and biota, rocks of the BRC were grouped into nine genetic lithofacies which document cryptic, deep-aphotic and shallow-photic environments typical of a sediment starved extensional basin.     

A mineral equilibria study of the hydrothermal alteration in mafic greenschist facies rocks at Kalgoorlie, Western Australia

The influx of a H₂O–CO₂‐dominated fluid into actinolite‐bearing metabasic rocks during greenschist facies metamorphism in the Kalgoorlie area of Western Australia resulted in a zoned alteration halo around inferred fluid conduits that contain gold mineralisation. The alteration halo is divided into two outer zones, the chlorite zone and the carbonate zone, and an inner pyrite zone adjacent to the inferred fluid conduits. Reaction between the fluid and the protolith resulted in the breakdown of actinolite and the development of chlorite, dolomite, calcite and siderite. In addition, rocks in the pyrite zone developed muscovite‐bearing assemblages as a consequence of the introduction of potassium by the fluid. Mineral equilibria calculations undertaken using the computer software thermocalc in the model system Na₂O–CaO–K₂O–FeO–MgO–Al₂O₃–SiO₂–H₂O–CO₂ show that mineral assemblages in the outer zones of the alteration halo are consistent with equilibrium of the protoliths with a fluid of composition X_CO2 = CO₂/(CO₂ + H₂O) = 0.1–0.25 for temperatures of 315–320 °C. The inner zone of the alteration halo reflect equilibrium with a fluid of composition X_CO2≈ 0.25. Fluid‐rock buffering calculations show that the alteration halo is consistent with interaction with a single fluid composition and that the zoned structure of the halo reflects the volume of this fluid with which the rocks reacted. This fluid is likely to have also been the one responsible for the gold mineralisation at Kalgoorlie.     

Magnetotelluric Investigation of the Hydrothermal System and Heat Source in the Muine-Toyoha Geothermal Area, Hokkaido, Japan

Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area.     

Chemical, Isotopic, and Fluid Inclusion Evidence for the Hydrothermal Alteration of the Footwall Rocks of the BIF-Hosted Iron Ore Deposits in the Hamersley District, Western Australia

Abstract. The petrography, chemical, fluid inclusion and isotope analyses (O, Rb-Sr) were conducted for the shale samples of the Mount McRae Shale collected from the Tom Price, Newman, and Paraburdoo mines in the Hamersley Basin, Western Australia. The Mount McRae Shale at these mines occurs as a footwall unit of the secondary, hematite-rich iron ores derived from the Brockman Iron Formation, one of the largest banded iron formations (BIFs) in the world. Unusually low contents of Na, Ca, and Sr in the shales suggest that these elements were leached away from the shale after deposition. The δ¹⁸O (SMOW) values fall in the range of + 15.0 to +17.9 per mil and show the positive correlation with calculated quartz/sericite ratios of the shale samples. This suggests that the oxygen isotopic compositions of shale samples were homogenized and equilibrated by postdepositional event. The pyrite nodules hosted by shales are often rimmed by thin layers of silica of varying crystallinity. Fluid inclusions in quartz crystals rimming a pyrite nodule show homogenization temperatures ranging from 100 to 240C for 47 inclusions and salinities ranging from 0.4 to 12.3 wt% NaCl equivalent for 18 inclusions. These fluid inclusion data give direct evidence for the hydrothermal activity and are comparable to those of the vein quartz collected from the BIF-derived secondary iron ores (Taylor et al, 2001). The Rb-Sr age for the Mount McRae Shale is 1,952 ± 289 Ma and at least 200 million years younger than the depositional age of the Brockman Iron Formation of ∼ 2.5 Ga in age. All the data obtained in this study are consistent with the suggestion that high temperature hydrothermal fluids were responsible for both the secondary iron ore formation and the alteration of the Mount McRae Shale.     

Submarine hydrothermal mineralization in the Okinawa Trough, SW of Japan: an overview

The Okinawa Trough is a heavily sedimented, rifted back-arc basin formed in an intracontinental rift zone. Submarine hydrothermal activity is located within the six back-arc rifts located in the middle and southern Okinawa Trough and its distribution is controlled principally by tectonic factors. Subduction of the Daito and Gagua Ridges beneath the Ryukyu Arc has resulted in fracturing of the brittle lithosphere beneath the Okinawa Trough. Hydrothermal activity is strongest in the volcanic arc-rift migration phenomenon (VAMP) area plus the JADE site and Southernmost Part of the Okinawa Trough (SPOT) area which form the prolongation of these two ridges. These areas are characterized by extremely high heat flow locally. Submarine hydrothermal fluids from the Okinawa Trough tend to be strongly influenced by interaction of the hydrothermal fluids with organic matter in the sediment resulting in high alkalinity and NH₄⁺ concentrations of the fluids. The fluids also contain high concentrations of CO₂ of magmatic origin. Submarine hydrothermal mineralization in the trough is diverse. The CLAM site consists principally of carbonate chimneys. Interaction of the hydrothermal fluid with organic matter in the sediment is particularly strong at this site. This is most probably a sediment-hosted deposit in which sulphide minerals have deposited within the sediment column leaving ‘spent ore-fluids’ to emerge at the seafloor. The JADE site consists of active and inactive sulphide–sulphate chimneys and mounds. The Zn–Pb-rich sulphides at this site contain the highest concentrations of Pb, Ag and Au so far recorded in submarine hydrothermal sulphide deposits. At Minami-Ensei Knoll and Hatoma Knoll, active and inactive chimneys consist principally of anhydrite and barite as a result of phase separation of the hydrothermal fluids beneath the seafloor. An intense black smoker has recently been discovered at Yonaguni Knoll in the SPOT area. If it is confirmed that sulphide mineralization is dominant at this site, this could be a highly prospective area. The most prospective areas for economic-grade minerals in the Okinawa Trough appear to be the JADE site and the SPOT area.     

若尔盖铀矿床含矿热液性质的热力学研究

作者利用热力学方法研究了若尔盖铀矿床含矿热液的特性。研究结果表明，初始含矿热液具有高温高压性质，来源于深部，而不是大气降水或由大气降水成因的地下水，随着含矿热液的演化，从早阶段到晚阶段，其温度、压力、碱度及氧逸度降低，而氧化还原电位升高，说明铀在相对还原条件下迁移，而在相对氧化的成矿环境中被还原。     

中酸性隐爆角砾岩、次火山(超浅成)岩与成矿的关系——以广西贵港新民—吉塘铜银矿区为例

研究了隐爆角砾岩与断层角砾岩、火山爆破角砾岩的区别,隐爆岩筒上、中、下部隐爆角砾岩的区别,含矿隐爆角砾岩筒特征,以及与隐爆、成矿作用有关的次火山(超浅成)岩特征。     

冀西北东坪金矿床成矿流体的来源研究

冀西北东坪金矿床成矿流体的来源研究＊莫测辉王秀璋程景平梁华英（华南农业大学资源环境学院，广州５１０６４２）（中国科学院广州地球化学研究所，广州５１０６４０）关键词金矿床成矿流体来源岩浆热液大气降水热液侵入岩体中的金矿床乃至岩体接触带或附近地层中的金矿...