Using numerical modelling to evaluate tsunami hazard near the Kuril Island

A sequence of computer experiments is used to study questions concerning the tsunami problem as a quantitative estimate of tsunami danger, detailed geographical tsunami classification, determination of the parameters of critical tsunami waves, and the conditions of their development. We call a wave critical, if its impact on the coast is most hazardous.Using the Middle Kuril Island as an example, we present the results of a computer experiment which includes determining the wavefields on the shelf and estimating the effects connected with the deep-water Bussol and Diana Straits.Numerical simulation of tsunami waves of different sources permits the assessment of the extent of tsunami danger in different areas of the coastal zone of Simushir Island, depending on the location of the focus zone and their geometry.The major singularities of the wavefield arise in the zones of the deep-water straits. The distribution of the amplification factors is determined by both the global parameters of the wavefields and the local properties of individual harbours. The results obtained for a particular harbour in the northern part of Simushir Island, formed the basis for the quantitative estimate of tsunami danger for this area.     

Field calibration and performance of sediment traps in a eutrophic holomictic lake

In wind-stressed and unstratified Lough Neagh low aspect ratio sediment traps, which allow for internal resuspension, collected sediment at a rate close to the natural sediment accumulation rate inferred from dated sediment cores. High aspect ratio traps grossly overestimated the natural rate of sediment accumulation as did, but to a lesser extent, burial rate measurements on an artificial stratigraphic marker. The former type of trap deployed over long exposure periods is therefore recommended as providing the best estimate of net downward particle flux in lakes such as Lough Neagh. However, it is emphasized that all sediment trap types, when operated in shallow turbulent lakes, will to a greater or lesser extent be contaminated by secondary or redeposited material and so will not provide a direct measure of primary sedimentation. Use of tube traps in lakes such as Lough Neagh should not, however, be discounted since they can provide a record of the quality of sedimenting material through time.     

Analysis on the sources of mercury in soils in the Chengdu Basin, China

Mercury is a pollutant of concern due to its toxic and bioaccumulative properties. Studies on the distribution and hazard of mercury in the environment are mainly focused on its forms, toxicity and the environment standard, and progresses and results have been achieved. But these studies in the past were concentrated on the scales of laboratory or smaller districts merely, such as a small unit of mineral area, vegetable base, paddy field, lake, etc. Multi-target regional geochemical survey carried out by China Geological Survey from the 1990s to now is a fundamental and commonweal geological survey, large-scale and systematical inquisition and research were conducted in 19 provinces （or municipalities directly under the Central Government） in the eastern overlay region of China, and the purpose is to provide the basic geochemical data for national economic construction, adjustment of industrial and agricultural structures and sustainable social development. Geochemical studies aim at investigating soils in these regions and 52 elements have been tested, producing a great amount of data at the same time. Methods： based on the data from 3061 samples of surface soil and 832 samples of deep soil from the project of multi-purpose geochemical survey in the Chengdu Basin, Sichuan, China, this paper describes the correlation relationship between Hg and other 48 elements and their spatial distribution in surface and deep soils of these areas by applying the method of linear regression and factor analysis.     

Powder factors in asymmetric blast patterns

A cell powder factor defines the local powder factor in a simple geometric procedure that accounts for the charge in each blast hole and the triangulation formed by blast hole collars in a blast pattern. In the case of asymmetric blast patterns, the cell powder factor deviates from the global powder factor. Poor drilling of blast hole collars produces significant variation in the cell powder factor, more so, than does poor blast hole charging. The cell powder factor does not account for timing within a blast and does not easily handle non-parallel blast hole configurations. The cell powder factor is best used as a design or audit tool before blast holes are loaded. It gives the opportunity to correct for poor drilling and/or poor charging practices prior to firing a blast.     

River bank erosion control by soil nailing

A study has been done for analysing soil nailed cuts with circular type wedge failure by friction circle method. Various parameters such as nail length, nail diameter, nail inclination, wall inclination and angle of internal friction of soil have been considered to determine the factor of safety of nailed open cuts. The study shows that for cohesionless soil nailed cut, factor of safety increase with increase of parameters like angle of internal friction of soil, length of nail (L) versus height of cut (H) ratio, cohesion of soil and nail inclination (upto 15°) with horizontal. The study revealed that nails grouted with cement perform better than driven nails. A case study further confirms the analytical findings. Received 7 October     

Break out resistance of inclined anchors in sand

Inclined anchors are widely used in a variety of civil engineering problems to resist oblique loads, most relevant being in transmission towers and in rocks and dams for structural strengthening. In the present study, the breakout resistance of the inclined anchors in sand has been worked out using limit equilibrium approach. The breakout resistance has been calculated for different soil friction angles with varying relative depth ratio and anchor inclination. The break out factor increases continuously with the inclination of the anchor. A comparison of predicted values of break out resistance of anchors by the proposed analysis with the experimental values as reported by the other researchers showed reasonably good agreement.     

我国高寒草甸植被生产力及其影响因子

生物量是重要的植物群落数量特征，直接反映生态系统生产者的物质生产量，是生态系统生产力的重要体现。高寒草甸广泛分布于青藏高原，是高寒生态系统的主要植被类型。回顾了高寒草甸生物量的研究成果。高寒草甸生物量呈典型的金字塔式垂直分布格局，地上生物量主要集中于0—10cm的冠层，地下生物量也集中分布于0—10cm的土层内。增温和多雨会降低生物量，叶面积和物种丰富度与地上生物量成正相关关系，氮素的增加有助于植被生物量的增长，而放牧率与生物量成显著负相关。     

A Comparison of Sediment Varves (1950–2003 AD) in Two Adjacent Lakes in Northern Sweden

Koltjärnen and Nylandssjön are two closely situated lakes (<2 km apart) in northern Sweden. During the past century, distinct varved sediments have formed in these lakes. Nylandssjön has two varved, deep basins. Since lake and catchment characteristics superficially appear very similar for the two lakes and they are exposed to the same climate, one would expect the sediment varves to be similar. This investigation compares the varves in the two deep basins of Nylandssjön, and in the two lakes. The comparison of basins of Nylandssjön shows that varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1970–2003). The grey-scale curves are only clearly similar in about 50% of the varves. In the between-lake comparison varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1950–1996). However, the annual accumulation rates of dry mass, minerogenic matter and biogenic silica differ between the lakes, as well as within-varve successions in grey-scale. A general explanation to the differences is that the prerequisites for varve formation are not totally similar because of differences in catchment size, catchment- to-lake material fluxes, lake productivity and land-use influence. This study illustrates the complex relationships that exist between a lake, its catchment, in-lake productivity and formation of sediment varves. As a consequence, we must not apply a too simplistic view of the potential of varves as past climatic indicators, especially if the lakes are affected by land-use.     

Retrieval of stratospheric O3 and NO2 vertical profiles using zenith scattered light observations

Daily zenith scattered light intensity observations were carried out in the morning twilight hours using home-made UV-visible spectrometer over the tropical station Pune (18‡31′, 73‡51′) for the years 2000–2003. These observations are obtained in the spectral range 462–498 nm for the solar zenith angles (SZAs) varying from 87‡ to 91.5‡. An algorithm has been developed to retrieve vertical profiles of ozone (O₃) and nitrogen dioxide (NO₂) from ground-based measurements using the Chahine iteration method. This retrieval method has been checked using measured and recalculated slant column densities (SCDs) and they are found to be well matching. O₃ and NO₂ vertical profiles have been retrieved using a set of their air mass factors (AMFs) and SCDs measured over a range of 87–91.5‡ SZA during the morning. The vertical profiles obtained by this method are compared with Umkehr profiles and ozonesondes and they are found to be in good agreement. The bulk of the column density is found near layer 20–25 km. Daily total column densities (TCDs) of O₃ and NO₂ along with their stratospheric and tropospheric counterparts are derived using their vertical profiles for the period 2000–2003. The total column, stratospheric column and tropospheric column amounts of both trace gases are found to be maximum in summer and minimum in the winter season. Increasing trend is found in column density of NO₂ in stratospheric, tropospheric and surface layers, but no trend is observed in O₃ columns for above layers during the period 2000–2003