旋转谱理论探讨

本文应用向量随机过程分解模型对旋转谱作出物理解释;此外,还修改了线性振荡度的定义,导出了极化度、线性振荡度和旋转系数之间的关系式,并讨论了它们与总相干、同相相干、异相相干之间的关系。     

水成沉积与风成沉积及古土壤的磁组构特征

晚第四纪水成沉积、风成沉积、古土壤等的磁组构研究表明,不同成因的沉积物具有明显不同的磁组构特征。一般地,水成沉积的体积磁化率Ｋ受物源和水动力因素控制,Ｐ和Ｆ均＞１．０２,ｑ＜０．５;风成沉积的Ｋ受物源控制,内陆黄土的Ｋ明显高于沿海黄土及海岸风沙Ｋ,Ｐ和Ｆ均＜１．０２,ｑ的平均值＞０．５５;古土壤的Ｋ受母质沉积类型和成土环境的氧化还原条件控制,内陆古土壤的Ｋ偏高,沿海古土壤的Ｋ偏低,内陆古土壤的Ｋ远高于沿海古土壤的Ｋ,Ｐ和Ｆ均＜１．０２,ｑ的平均值在０．５左右。运用典型沉积的磁组构特征对比分析未知沉积物,可以得到未知沉积物的物源、沉积过程和环境信息。     

深水网箱投饵机设计与试验研究

根据网箱养殖的特点,结合网箱养殖的经验,设计了1种深水网箱投饵机,并进行了相应的试验,测定了不同情况下产生的真空度以及在冲饵管和吸饵管不同开度时的下料时间。此投饵机使用水力环流供饵、水力抽负吸饵、水动力投饵,充分利用了丰富的海水资源,用汽油机水泵作动力,利用管道将饵料抛向网箱,可向多个、距离不同的网箱供饵。作为1种新的投饵机具,可用于网箱养鱼和池塘养鱼的投饵。     

渤海南部表层沉积的相特征

通过海上调查及实验室分析,查明渤海南部表层沉积物在结构类型、矿物组合、生物组分及沉积构造等相特征方面具有明显的分区性。渤海南部存在五种沉积相:黄河水下三角洲相、陆架盆地相、海湾相、潮流浅滩相及古滨岸相。黄河水下三角洲相从河口延至水深15—20米处,沉积速率很高,沉积物富含碎屑云母及CaCo_3。陆架盆地相的沉积为粉砂质粘土,具有生物扰动构造。     

A Note on Tsunami Bore Front

A note is presented on tsunami bore front. This tsunami bore front is an old dynamical problem but also a new problem to be understood. The tsunami event on 2004 December 26 has raised this is an urgent problem. The author introduces here a model in order to see a hydrodynamical specific property of the tsunami bore front. This modeling gives us a new understanding about what mechanics is for the interested tsunami bore front, especially, around a coastal zone. This work adds a new understanding about mechanics of water motions as the tsunamis generated by the earthquake undersea at a distant area from the coast. The model in this work points out a specific transitional pattern as a function of time and space of tsunami bore front. This modeling gives what is essential at considering tsunami bore front.     

An Experi mental Study on Wave-Induced Dynamic Stresses in Seabed

1 .IntroductionEvery year ,Taiwanis subjectedtotwo or three typhoonintrusions in average which always causedisasters . Most of the disasters which occur around the coastal zone are due to seabed instability andcoastal structure destruction caused bytyphoo…     

土壤吸湿-湿过程中水力传导度的拟合研究

非饱和含水介质在吸湿和脱湿的不同过程中,水力传导度随介质含水率的变化规律是不同的。本文选取大沽河流域两种代表性砂土,对其吸湿-脱湿两个过程分别进行试验观测,并使用VanGenuchten—Mualem模型对其吸湿-脱湿过程进行水力传导度的拟合。研究结果表明：砂土在吸湿过程的非饱和水力传导度与脱湿过程的非饱和水力传导度大小并不相同,在含水率相同的情况下,吸湿过程的水力传导度要比脱湿过程大,在含水率较低时（小于15％）相差可达1个数量级。     

Estimation of statistical parameters for censored lognormal hydraulic conductivity measurements

Field tests of hydraulic conductivity (e.g., injection test, pumping test, etc.) in low permeability formations are subject to censoring due to the detection limit of the instruments used. An iterative method of estimating the mean and variance of hydraulic conductivity data with a presumed log-normal distribution function is presented. This method accounts for the data that are actually below the lower detection limit (called truncated data) and thus gives distribution parameters that are more representative for the underlying distribution. The proposed method is then tested on two simulated normally distributed random datasets having different variances. The results show that the means and variances estimated by the proposed method are very accurate. Finally, the method is used to estimate the mean and variance of hydraulic conductivity data from single hole water injection tests in a fractured geological formation.     

高压旋喷桩有关问题的探索和研究

通过工程实例，介绍了单管法高压旋喷桩施工工艺、技术参数、施工中存在的问题以及注意事项。阐述了一些常见故障及预防措施。     

The log-normal distribution for hydraulic conductivity of compacted clays: Two or three parameters?

Risk and uncertainty assessments for waste containment systems employing clay barriers often include spatial variability in the hydraulic conductivity as part of the analysis. The two-parameter log-normal distribution is often used to describe the spatial variability, but for compacted clays the three-parameter form can be more appropriate. A statistical hypothesis test was developed that can be used to determine if the two- or three-parameter form of the log-normal distribution is more appropriate. The test is based on a likelihood ratio, comparing likelihood functions for the two- and three-parameter forms at their maximums. Likelihood functions are used assuming that a data set can be segregated into a set of distinct groups of hydraulic conductivities. A step-by-step calculation procedure is described and the test is applied to data collected from 45 sites.