东胜煤田乌拉素矿区水文地质特征及充水因素研究

近年不断发生的突水事故,给煤矿安全生产带来严重威胁,研究矿区水文地质特征,分析矿井充水因素有重要现实意义。根据东胜煤田乌拉素矿区地质勘探和水文地质资料,对煤层开采导水裂隙带高度进行计算,结果表明:直罗组底部、含煤系地层的裂隙承压水含水层和上部煤层采空区内的积水,是煤层开采时矿井涌水的主要充水水源,矿井充水通道有断层裂隙带、封闭不良钻孔、采动导水裂隙带;其中导水裂隙带会将上部煤层采空区积水导通,使充水强度增大,矿坑涌水量增加。建议开采过程中要做到边探边采,探采结合,预防突水问题。     

溶液和温度作用下膨润土防水毯的渗透性能

以颗粒状和粉末状膨润土防水毯(GCLs)为对象,运用GDS (global digital systems)全自动渗透仪开展渗透试验,研究CaCl_2溶液作用下GCLs渗透性能的温度效应,初步探讨其机理。试验表明:当水化液为0.05mol/L的CaCl_2溶液时,两种GCLs渗透系数随温度升高呈现增大趋势;当水化液为去离子水时,颗粒状GCL渗透系数随温度升高而减小,粉末状GCL渗透系数随温度升高而增大。去离子水情况下,膨润土吸附结合水量随温度升高而减小;CaCl_2溶液作用下,吸附结合水量较去离子水情况大幅降低。当CaCl_2溶液浓度一定时,膨润土膨胀指数随温度升高而略有增大;当温度一定时,膨润土膨胀指数随CaCl_2溶液浓度升高而显著减小。以去离子水进行试验时:颗粒状和粉末状GCLs渗透系数随温度的变化主要影响因素为凝胶态蒙脱石数量,其次为流体黏滞系数和吸附结合水量;颗粒状GCLs膨润土孔隙结构越不均匀,凝胶态蒙脱石数量的影响就越显著,导致渗透系数随温度升高而减小、固有渗透率随温度升高显著降低。以CaCl_2溶液进行试验时,两种GCLs渗透系数随温度变化的主要受流体黏滞系数和吸附结合水量的影响,而受凝胶态蒙脱石数量的影响较小。孔隙溶液性质、温度和膨润土类型均对GCLs的防渗性能具有重要影响。     

Fracture grouting and geonails for soft soil tunnelling

To stabilise the tunnel faces and slopes in soft clay for the Airport Link construction in Australia, fracture grouting and glass fibre-reinforced plastic (GFRP) soil nails are proposed for the soil improvement as well as ease of handling. The compensation caused by the fracture grouting and the gain in strength due to consolidation as well as the geonail have stabilised the soft clay during construction. Only a small amount of ground settlement during soft clay box-jacking operation is generated so that the railway traffic above the embankment can be maintained without interference. The design method of the fracture grouting ground improvement study for this difficult project is discussed in this paper. Extensive laboratory and field tests were employed to verify the design assumptions and to fine-tune the ground improvement studies. The success of this project in poor ground conditions results from combined efforts of extensive field tests, an improved ground improvement design method and a realistic numerical analysis to assess the unstable/highly stressed zones for the placement of soil reinforcement.     

Fully coupled hydraulic fracture simulation using the improved element partition method

The improved element partition method (IEPM) is a newly developed fracture simulation approach. IEPM allows a fracture to run across an element without introducing extra degrees of freedom. It can also simulate any number of fractures in a prescribed mesh without remeshing. In this study, the IEPM is extended to hydraulic fracture simulation. First, the seepage and volumetric storage matrix of a cracked element are derived using virtual nodes (the intersection points of a crack with element edges). Subsequently, the fully coupled hydromechanical equation is derived for this cracked element. To eliminate the extra degrees of freedom (virtual nodal quantities), the water pressure and displacement of the virtual nodes are associated with their adjacent nodes through least squares interpolation. Finally, the fully coupled equation in terms of nodal quantities is obtained. The verification cases validate the method. By using this method, the field-scale hydraulic fracturing process is well simulated. The proposed approach is simple and efficient for field-scale hydraulic fracture simulation.     

Response to the paper by H. Zia,B. Lecampion “Explicit versus implicit front advancing schemes for the simulation of hydraulic fracture growth” (Int. J. Numer. Anal. Methods Geomech., 2019, 43 (6), 1300–1315)

The response presents three comments, which (i) explain theoretical background for the success of the explicit front advancing scheme by Zia and Lecampion (comment 1), (ii) suggest possible extensions (comment 2), and (iii) pay attention on expected limitations of the scheme to be checked by the authors in numerical experiments (comment 3). The response does not intend to present novel results: it is entirely based on known results published in the references cited.     

Advances in pan‐European flood hazard mapping

Flood hazard maps at trans‐national scale have potential for a large number of applications ranging from climate change studies, reinsurance products, aid to emergency operations for major flood crisis, among others. However, at continental scales, only few products are available, due to the difficulty of retrieving large consistent data sets. Moreover, these are produced at relatively coarse grid resolution, which limits their applications to qualitative assessments. At finer resolution, maps are often limited to country boundaries, due to limited data sharing at trans‐national level. The creation of a European flood hazard map would currently imply a collection of scattered regional maps, often lacking mutual consistency due to the variety of adopted approaches and quality of the underlying input data. In this work, we derive a pan‐European flood hazard map at 100 m resolution. The proposed approach is based on expanding a literature cascade model through a physically based approach. A combination of distributed hydrological and hydraulic models was set up for the European domain. Then, an observed meteorological data set is used to derive a long‐term streamflow simulation and subsequently coherent design flood hydrographs for a return period of 100 years along the pan‐European river network. Flood hydrographs are used to simulate areas at risk of flooding and output maps are merged into a pan‐European flood hazard map. The quality of this map is evaluated for selected areas in Germany and United Kingdom against national/regional hazard maps. Despite inherent limitations and model resolution issues, simulated maps are in good agreement with reference maps (hit rate between 59% and 78%, critical success index between 43% and 65%), suggesting strong potential for a number of applications at the European scale. Copyright © 2013 John Wiley & Sons, Ltd.     

Reply to comments on “Explicit versus implicit front advancing schemes for the simulation of hydraulic fracture growth” (Int. J. Numer. Anal. Methods Geomech., 2019, 43 (6), 1300–1315)” by Prof. Linkov

We reply to Prof. Linkov comments on our article entitled “Explicit versus implicit front advancing schemes for the simulation of hydraulic fracture growth” (Int. J. Numer. Anal. Methods Geomech., 2019, 43 (6), 1300–1315). We present additional results indicating that both the implicit and explicit front advancement schemes are robust even in the case of a large stress contrast.     

Transient streambed hydraulic conductivity in channel and bar environments,Loup River,Nebraska

Streambed hydraulic conductivity (K) and vertical K (K _v) are key controls on groundwater and surface water exchange and biogeochemical fluxes through the hyporheic zone, but drivers of transient hydraulic properties in different fluvial environments are poorly understood. This study combines hydrogeology, geophysics, and sedimentology to reveal mechanisms of K and K _v transience in the upper 0.5 m of a sandy streambed during low discharge. Hydraulic tests (44 slug tests, 130 falling-head permeameter tests) and 130 grain-size analyses were repeated three times over 8 weeks on a 1,200 m² grid spanning: (a) a channel with continuously flowing water and mobile bed load; (b) an adjacent mid-channel bar that was stationary and infrequently submerged. Aerial photographs and ground-penetrating radar show scour and complete reworking of fluvial sediments in the channel. Bar sediments below the water table remained immobile, but infrequent flows of moderate discharge reworked the uppermost few centimetres of the bar top. Despite differences in sediment mobility and stream flow characteristics across environments, K and K _v exhibited order-of-magnitude differences in spatial heterogeneity and temporal variability in both the channel and bar. Mean K and K _v values in the channel were comparatively stable over time. In the immobile bar, mean K declined 20% and K _v declined 26% after increased discharge temporarily inundated the bar. Grain-size distributions were steady across both environments over time, but repeat geophysical surveys of the bar show a decrease in electrical conductivity, likely from porosity reduction. These findings suggest that sediment dynamics and stream flow characteristics in different streambed environments are important drivers of K transience during low discharge conditions. Specifically, pore clogging can be an important mechanism of transience over short durations (weeks to months) in immobile sediments subject to infrequent flows and minor reworking.     

Static and dynamic conceptual model of a complexly fractured crystalline rock aquifer

A conceptual model of anisotropic and dynamic permeability is developed from hydrogeologic and hydromechanical characterization of a foliated, complexly fractured, crystalline rock aquifer at Gates Pond, Berlin, Massachusetts. Methods of investigation include aquifer‐pumping tests, long‐term hydrologic monitoring, fracture characterization, downhole heat‐pulse flow meter measurements, in situ extensometer testing, and earth tide analysis. A static conceptual model is developed from observations of depth‐dependent and anisotropic permeability that effectively compartmentalizes the aquifer as a function of foliation intensity. Superimposed on the static model is dynamic permeability as a function of hydraulic head in which transient bulk aquifer transmissivity is proportional to changes in hydraulic head due to hydromechanical coupling. The dynamic permeability concept is built on observations that fracture aperture changes as a function of hydraulic head, as measured during in situ extensometer testing of individual fractures, and observed changes in bulk aquifer transmissivity as determined from earth tides during seasonal changes in hydraulic head, with higher transmissivity during periods of high hydraulic head, and lower transmissivity during periods of relatively lower hydraulic head. A final conceptual model is presented that captures both the static and dynamic properties of the aquifer. The workflow presented here demonstrates development of a conceptual framework for building numerical models of complexly fractured, foliated, crystalline rock aquifers that includes both a static model to describe the spatial distribution of permeability as a function of fracture type and foliation intensity and a dynamic model that describes how hydromechanical coupling impacts permeability magnitude as a function of hydraulic head fluctuation. This model captures important geologic controls on permeability magnitude, anisotropy, and transience and therefor offers potentially more reliable history matching and forecasts of different water management strategies, such as resource evaluation, well placement, permeability prediction, and evaluating remediation strategies.     

Near‐surface hydraulic conductivity of northern hemisphere glaciers

The hydrology of near‐surface glacier ice remains a neglected aspect of glacier hydrology despite its role in modulating meltwater delivery to downstream environments. To elucidate the hydrological characteristics of this near‐surface glacial weathering crust, we describe the design and operation of a capacitance‐based piezometer that enables rapid, economical deployment across multiple sites and provides an accurate, high‐resolution record of near‐surface water‐level fluctuations. Piezometers were employed at 10 northern hemisphere glaciers, and through the application of standard bail–recharge techniques, we derive hydraulic conductivity (K) values from 0.003 to 3.519 m day^?1, with a mean of 0.185 ± 0.019 m day^?1. These results are comparable to those obtained in other discrete studies of glacier near‐surface ice, and for firn, and indicate that the weathering crust represents a hydrologically inefficient aquifer. Hydraulic conductivity correlated positively with water table height but negatively with altitude and cumulative short‐wave radiation since the last synoptic period of either negative air temperatures or turbulent energy flux dominance. The large range of K observed suggests complex interactions between meteorological influences and differences arising from variability in ice structure and crystallography. Our data demonstrate a greater complexity of near‐surface ice hydrology than hitherto appreciated and support the notion that the weathering crust can regulate the supraglacial discharge response to melt production. The conductivities reported here, coupled with typical supraglacial channel spacing, suggest that meltwater can be retained within the weathering crust for at least several days. Not only does this have implications for the accuracy of predictive meltwater run‐off models, but we also argue for biogeochemical processes and transfers that are strongly conditioned by water residence time and the efficacy of the cascade of sediments, impurities, microbes, and nutrients to downstream ecosystems. Because continued atmospheric warming will incur rising snowline elevations and glacier thinning, the supraglacial hydrological system may assume greater importance in many mountainous regions, and consequently, detailing weathering crust hydraulics represents a research priority because the flow path it represents remains poorly constrained.