酸溶——催化极谱法测定地质样品中的钨、钼

本文采用混合酸溶解样品,对影响催化体系稳定的酸度、温度和不同反应时间的因素分别进行了对比试验,确定催化体系相对稳定的最佳条件,经过大量样品的分析验证,分析方法可靠。     

山东三山岛金矿床流体包裹体特征及其地质意义

三山岛金矿床位于莱州市三山岛—仓上断裂带内,矿石主要为蚀变岩和含金石英脉2种类型。随着胶东金矿床研究的深入和三山岛金矿资源的不断减少,对三山岛金矿床的成矿作用及深部开发前景问题研究具有更重要的意义。针对上述问题,对三山岛金矿床2种类型矿石的成矿流体特征进行对比研究,认为代表成矿早—中期的蚀变岩型矿石形成于中温(均一温度为325～240℃)、低盐度(2.07%～6.88%)、低密度(0.720～0.868g/cm3)、酸碱性不均匀(pH=3.27～10.43)、以氟化物和氯化物为成矿物质载体的还原性流体;代表成矿中—晚期的含金石英脉型矿石形成于中—低温(均一温度为306～160℃)、低盐度(1.05%～9.73%)、低密度(0.739～0.962g/cm3)、碱性(pH=9.25～9.85)、以氯化物和硫化物为成矿物质载体的还原性流体。成矿流体性质的转变反映了成矿流体处于由比较封闭到比较开放的构造环境的转变期,且成矿流体早期以原生岩浆水为主,后期有变质水、大气降水以及海水的参与作用。三山岛金矿成矿深度为2.5～5km,根据目前的开采深度推算其深部还有一定的资源量可供开发。     

胶东半岛大磨曲家金矿床成矿流体物理化学条件演化

胶东大磨曲家金矿床流体包裹体包括水溶液包裹体、富CO2包裹体和高盐卤水包裹体3种类型,前两者发育较多,高盐卤水包裹体发育极少。流体包裹体显微测温及盐度、密度、压力估算显示,水溶液包裹体均一温度为98~376℃,据冰点温度估算,盐度为0.53%~8.28%,水溶液包裹体均一压力低于50×105Pa;富CO2包裹体完全均一温度为255~348℃,盐度为2.42%~11.43%,均一压力为1 000×105~2 500×105Pa;富CO2包裹体中CO2均一温度为23.0~32.4℃,指示该类包裹体可能含有数量不等的CH4或H2S。静水压力体制下,根据纯CO2包裹体均一压力估算成矿深度约为1 km。在270℃左右,均一压力从富CO2包裹体到水溶液包裹体急剧降低,指示成矿流体在270℃左右可能发生过一次减压沸腾过程,成矿流体盐度和密度在270℃左右也有显著的变化。因此,沸腾作用及其引起的成矿流体物理化学条件的急剧变化可能是导致大磨曲家金矿床成矿物质沉淀的重要机制。     

塔东地区古城4井上寒武统—中、上奥陶统流体地球化学示踪

通过对塔东地区古城4井上寒武统和中、上奥陶统碳酸盐岩围岩及充填物的碳、氧、锶同位素地球化学和流体包裹体成分的对比研究表明,充填于中、上奥陶统和上寒武统的流体分属于2个不同来源的流体体系。充填于中、上奥陶统灰岩裂缝中方解石脉的w(87Sr)/w(86Sr)介于0.7084~0.7088,它与早奥陶世海水的w(87Sr)/w(86Sr)相近;流体体系为CH4-H2O体系;充填物与围岩间具有明显的碳、氧同位素差异,表明上部流体体系中的流体来自于奥陶系地层本身。上寒武统白云岩裂缝中方解石脉的w(87Sr)/w(86Sr)为0.7138,明显地高于同时代海水的锶同位素值;流体体系为CO2-H2O体系;下部流体体系中的流体为外来富锶流体。上、下流体体系间互不连通暗示着上寒武统地层具有相对较好的保存条件。     

火山沉积岩及其矿床研究中伽马测井曲线解释的误区

根据酸性凝灰岩和酸性火山事件粘土岩的自然伽马测井曲线,对当前流传的"沉积岩层的放射性强度(或放射性核素的含量)随泥质含量的增加而增高"的概念和用自然伽马值及经验公式求泥质含量提出质凝。酸性凝灰岩的自然伽马曲线有高异常响应,若解释为泥岩显然是误解,故将沉积岩伽马曲线高异常一律解释为泥岩是片面的。各类火山事件粘土岩的伽马值相差悬殊,但其泥质含量几乎相等,用它们的伽马值计算泥质含量误差甚大。最后对铝土矿层的伽马曲线稍加解释,指出核测井应用的远景。     

Interaction of copper with fatty acids in Soxhlet extraction and its influence

Treatment with metallic copper for the removal of elemental sulfur from bitumen extracted from sedimentary rocks or petroleum is the most widely used method. Little attention has been paid, however, to its disadvantages. It was observed that copper can interact with some polar organic substances during conventional sulfur removal, which can strongly influence the quantitative and qualitative determination of bitumen, as has been confirmed by interaction of long-chain fatty acids with copper. The copper soap generated was analyzed by element analysis, inductively coupled plasma optical emission spectrometry （ICP-OES）, thermal analysis （TG-DSC） and Fourier Transform Infrared spectroscopy （FFIR）. Mechanism of the interaction was investigated and elucidated. Our experimental results would necessitate improvement of the present method for sulfur removal and/or a search for a new one.     

Magnetite-Fluorite Rock: A New Rock Type of Hot Water Sedimentation

The new type hot water sedimentary rock - magnetite-fluorite rock occurs as quasi-layers inflat parts of contact zones between rock body and strata in Bamiaushan of Changshan County,Zhejiang Province, China. The main mineral assemblage is fluorite magnetite cassiterite. The rockshows typical laminated structure and obvious mosaic texture. Its formation temperature is between123℃-160℃, averaging at 142℃. The major chemical composition of the rock includes CaF2, SiO2,Al2O3, FeO, and Fe2O3; the high-content microelement association includes W, Sn, Be, Rb, Sr, S, andCl; and the total content of REE is low (∑REE between 35.34x10-6-38.35x10-6), showing LREEenrichment type of distribution pattern. Diagenesis: driven by the tectonic stress, the formation waterheated in the deep strata had moved along the fissures or fractures in strata and had extractedcomponents from the strata on the way, and finally stagnated in the flat parts of contact zones betweenrock body and strata. With drop in temperature, magnetite and fluorite were separated from the hotwater and precipitated alternately, forming this hot water sedimentary rock with new typemineralogical composition, typical laminated structure, obvious mosaic texture and sub-horizontaloccurrence. The characteristics of the new type mineralogical composition, sedimentary tectonicenvironment and chemical composition are different from that of the well-known traditionalhydrothermai sedimentary rocks.     

岩石中的渗透率、流体流动及热液成矿作用

热液成因的固体金属矿床形成过程中都曾拥有一段流动的历史。成矿物质以溶液的形式从矿源地穿过孔隙或断裂达到了现在的栖身之所,在此过程中流体通过的路径决定了它们的走向,而溶液本身也改变了路径的特征。因此,对于此类矿床的研究不能仅仅囿于眼之所见,而应将古流体流动的观念融入其中,并考察它们的跋涉之路。文中总结了近年来国内外在岩石孔隙、断裂介质及与其相关渗透率对热液成矿作用的控制等领域的研究成果和最新进展,对岩石渗透率、渗透率的影响因素、岩石中流体流动的特征等问题进行了阐述,讨论了渗透率对于热液成矿作用深度、成矿规模、矿质沉淀机制等方面的重要影响,藉此在固体金属矿床研究中强化流"体运动"的观念,并促进构造地质学和成矿作用地球化学间一个新研究方向的发展。     

Fluid–Sediment Interaction in a Marine Shallow-Water Hydrothermal System in the Wakamiko Submarine Crater, South Kyushu, Japan

The Wakamiko submarine crater is a small depression located in Kagoshima Bay, southwest Japan. Marine shallow‐water hydrothermal activity associated with fumarolic gas emissions at the crater sea floor (water depth 200 m) is considered to be related with magmatic activity of the Aira Caldera. During the NT05‐13 dive expedition conducted in August 2005 using remotely operated vehicle Hyper‐Dolphine (Japan Agency for Marine‐Earth Science and Technology), an active shimmering site was discovered (tentatively named the North site) at approximately 1 km from the previously known site (tentatively named the South site). Surface sediment (up to 30 cm) was cored from six localities including these active sites, and the alteration minerals and pore fluid chemistry were studied. The pore fluids of these sites showed a drastic change in chemical profile from that of seawater, even at 30 cm below the surface, which is attributed to mixing of the ascending hydrothermal component and seawater. The hydrothermal component of the North site is estimated to be derived from a hydrothermal aquifer at 230°C based on the hydrothermal end‐member composition. Occurrence of illite/smectite interstratified minerals in the North site sediment is attributed to in situ fluid–sediment interaction at a temperature around 150°C, which is in accordance with the pore fluid chemistry. In contrast, montmorillonite was identified as the dominant alteration mineral in the South site sediment. Together with the significant low potassium concentration of the hydrothermal end‐member, the abundant occurrence of low‐temperature alteration mineral suggests that the hydrothermal aquifer in the South site is not as high as 200°C. Moreover, the montmorillonite is likely to be unstable with the present pore fluid chemistry at the measured temperature (117°C). This disagreement implies unstable hydrothermal activity at the South site, in contrast to the equilibrium between the pore fluid and alteration minerals in the North site sediment. This difference may reflect the thermal and/or hydrological structure of the Wakamiko Crater hydrothermal system.     

Numerical simulation of migration–accumulation of oil resources

Numerical simulation of oil migration and accumulation is to describe the history of oil migration and accumulation in basin evolution. It is of great value to the evaluation of oil resources and to the determination of the location and amount of oil deposits. This thesis discusses the characteristics of petroleum geology and permeation fluid mechanics. For the three-dimensional problems of Dongying hollow of Shengli Petroleum Oil Field, it puts forward a new model and a kind of modified method of upwind finite difference fractional steps implicit interactive scheme. For the famous hydraulic experiment of secondary migration–accumulation, the numerical simulation test has been done, and both the computational and experimental results are basically identical. For the actual problem of Dongying hollow, the numerical simulation test and the actual conditions are basically coincident. Thus, the well-known problem has been solved.