有限元法模拟开挖引起的基坑水平位移和邻近建筑物沉降

以徐州某采用水泥土墙支护的基坑为例,采用有限元数值模拟的方法,对基坑开挖引起的水平位移量和邻近建筑物沉降量进行了计算,并与实际监测值进行了对比分析,得到了一些关于如何控制基坑水平位移和减少基坑周边建筑沉降的结论。     

The Epi－continental arc of Southeast China and relevant earthquakes

ＴｈｅＥｐｉ┐ｃｏｎｔｉｎｅｎｔａｌａｒｃｏｆＳｏｕｔｈｅａｓｔＣｈｉｎａａｎｄｒｅｌｅｖａｎｔｅａｒｔｈｑｕａｋｅｓＪＩＡ－ＷＥＩＸＵ（徐嘉炜）ＤｅｐａｒｔｍｅｎｔｏｆＲｅｓｏｕｒｃｅａｎｄＥｎｖｉｒｏｎｍｅｎｔａｌＳｃｉｅｎｃｅｓ,ＨｅｆｅｉＵ...     

Fault slip analysis of Quaternary faults in southeastern Korea

The Quaternary stress field has been reconstructed for southeast Korea using sets of fault data. The subhorizontal direction of the maximum principal stress (σ₁) trended ENE and the direction of the minimum principal stress (σ₃) was nearly vertical. The stress ratio (Φ = (σ₂ − σ₃) / (σ₁ − σ₃)) value was 0.65. Two possible interpretations for the stress field can be made in the framework of eastern Asian tectonics; (1) The σ_Hmax trajectory for southeast Korea fits well with the fan-shaped radial pattern of maximum principal stress induced by the India–Eurasia collision. Thus, we suggest that the main source for this recent stress field in southeast Korea is related to the remote India–Eurasia continental collision. (2) The stress field in Korea shows a pattern similar to that in southwestern Japan. The origin for the E–W trending σ_Hmax in Japan is known to be related to the mantle upwelling in the East China Sea. Thus, it is possible that Quaternary stress field in Korea has evolved synchronously with that in Japan. We suggest further studies (GPS and in situ stress measurement) to test these hypotheses.     

A laboratory experiment to monitor the contact state of a fault by transmission waves

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.     

Non-volcanic deep low-frequency tremors accompanying slow slips in the southwest Japan subduction zone

Non-volcanic deep low-frequency tremors in southwest Japan exhibit a strong temporal and spatial correlation with slow slip detected by the dense seismic network. The tremor signal is characterized by a low-frequency vibration with a predominant frequency of 0.5–5 Hz without distinct P- or S-wave onset. The tremors are located using the coherent pattern of envelopes over many stations, and are estimated to occur near the transition zone on the plate boundary on the forearc side along the strike of the descending Philippine Sea plate. The belt-like distribution of tremors consists of many clusters. In western Shikoku, the major tremor activity has a recurrence interval of approximately six months, with each episode lasting over a week. The tremor source area migrates during each episode along the strike of the subducting plate with a migration velocity of about 10 km/day. Slow slip events occur contemporaneously with this tremor activity, with a coincident estimated source area that also migrates during each episode. The coupling of tremor and slow slip in western Shikoku is very similar to the episodic tremor and slip phenomenon reported for the Cascadia margin in northwest North America. The duration and recurrence interval of these episodes varies between tremor clusters even on the same subduction zone, attributable to regional difference in the frictional properties of the plate interface.     

大变形有限元法分析边坡稳定性

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。     

考虑滑脱效应和温度场的煤层气渗流数值模拟

由于煤层气的解吸热效应,煤层气的运移过程是一个非等温过程。因此,温度场对煤层气渗流有着重要的影响。前人在研究煤层气渗流规律的研究中并没有同时考虑滑脱效应和温度场因素的影响,而在实际的深部开采中综合考虑滑脱效应和温度场的影响对研究深部煤层气运移规律有着重要的意义。因此本文建立了考虑滑脱效应及温度场的煤层气渗流数学模型,利用有限元数值方法研究了考虑滑脱效应和温度场耦合的煤层气运移规律;研究了考虑滑脱效应和温度场对压力场分布的影响;对考虑滑脱效应及温度场因素的煤层气产量进行了预测。得出了随着温度的升高煤储层的压力在降低,温度的升高对煤层气的产量有着负面的影响这一重要结论。     

VML在WebGIS图形显示中的应用研究

针对目前被动式WebGIS地图显示的局限,提出了引入VML的解决办法,使客户端容易实现矢量地图显示、地物动态变化显示、专题制图显示等,丰富了WebGIS的地图表现方式。     

沁水盆地煤层气钻井工艺方法

针对沁水盆地煤层气概况,地层情况及开采条件,介绍了参数井、生产井、多分支地面煤层气水平开发井、丛式井等钻井工艺、钻具组合、井身结构及井身质量要求.