Evaluation of change in subsurface thermal environment due to groundwater flow in the Tokyo Lowland,Japan

Information on the distribution of subsurface temperature and hydraulic heads at 24 observation wells in and around the Tokyo Lowland, the eastern part of the Tokyo Metropolitan area, were examined to make clear the relationship between groundwater and the subsurface thermal environment in the urban area. Minimums in temperature–depth logs due to subsurface temperature increasing at shallow parts were recognized in 21 wells. This fact shows subsurface temperature is affected by ground surface warming in almost all of this area. Deeper than minimums, where the effects of surface warming became relatively small, regional variation is observed as follows: high temperatures are shown in the central part to the southern part, and low temperatures shown in the inland to eastern part. The high temperature area corresponds to an area where the lower boundary of groundwater flow is relatively shallow. This area corresponds also to an area with severe land subsidence resulting from excessive groundwater pumping. It is considered that this high temperature area is formed by the effects of upward groundwater flow affected by hydrogeological conditions and pumping. On the other hand, a comparison between past data (1956–1967) and present data (2001–2003) revealed widespread decreasing temperature in the inland area. This is explained by downward groundwater flow based on an analysis of temperature–depth logs. This fact suggests that subsurface temperature is not only increasing from the effects of surface warming but also decreasing from the effects of groundwater environment change due to pumping.     

松辽盆地白垩纪湖泊水体温度与古气候温度估算

湖泊沉积物沉积的第一场所是湖底,湖底温度的高低影响沉积有机质的保存,也影响湖底下部地层的温度。了解古水体温度尤其是古水底温度情况成为评估松辽盆地白垩系生物气勘探前景的必要研究内容之一。根据已有的古气候研究成果与现今气候对比,得出白垩纪松辽盆地年平均气温约为14~24℃。再根据水库温度的计算方法和利用已有的古纬度及古水深的研究成果计算得出,白垩纪松辽盆地古湖盆水体表面温度为17~25℃;水深大于20 m的深湖区,水底温度为6.2~12.5℃;湖底最深处温度为4.0~11.3℃;青山口组和嫩江组沉积时期,湖水分层明显,湖底温度季节性变化很小且温度较低,约为8℃。湖底的低温对松辽盆地白垩纪生物气勘探是有利的。     

姬塬油田长4＋5砂岩储层孔隙类型与成岩作用

通过常规物性、岩石及铸体薄片、重矿物、X射线衍射、扫描电镜等多项测试方法,对鄂尔多斯盆地姬塬油田长4 5含油砂体的岩石学特征、成岩作用、储集类型进行了分析和研究。长4 5储层孔隙主要以粒间孔和长石溶孔为主,粒间溶孔次之,孔隙组合一般以粒间孔和溶孔-粒间孔为主。本区破坏性成岩作用包括机械压实作用、石英及长石的次生加大、碳酸盐胶结作用等,其中压实作用是造成本区砂岩原生孔隙大量丧失的主要原因。建设性成岩作用为溶蚀作用、绿泥石粘土膜形成作用,但溶蚀作用产生的次生孔隙对储层物性的改善不足。     

非均匀月壤介质的被动微波辐射传输模拟

基于非均匀月壤物理模型和辐射传输方程,模拟月壤介质中的微波辐射传输特性,探讨频率、月壤厚度等与月表亮温的关系。结果表明:在低频段,月壤微波辐射亮温的动态变化范围较大,可探测的月壤厚度大,3 GHz时的最大可探测月壤厚度达12.4 m;在高频段对应的可探测月壤厚度较小,特别是从50GHz往后的频率段内,最大可探测月壤厚度均小于2 m。不同频率的亮温-厚度变化曲线没有交叉点,且频率越高,所能探测的月壤厚度越小。根据模拟结果,建立了月壤厚度与亮温的查找表。基于查找表,利用单个波段的亮温数据即可得到月壤厚度信息。     

测井仪器的故障分析与排除思路

TYSC-3Q与PSJ-2型数字测井仪是目前煤田测井中常用的二种测井仪器,在使用过程中难免发生诸如测井控制故障、声速探管故障、密度三侧向探管故障、井温、井液电阻率探管故障、电法面板故障、数字测井面板故障、电测井故障等常见故障类型。通过对各类故障因素进行剖析,指出了故障易发生的部位,并详细的介绍了检查的方法及故障的排除步骤。     

努力提高三维地震勘探精度，为西部煤炭工业做出新贡献

以国家重大产业技术开发专项“西部煤炭资源高精度三维地震勘探技术”项目的由来、意义和总体研究目标为引,概括的介绍了项目依托工程中各个专项技术研究完成情况,并对非均匀介质成像技术、高精度三维地震静校正技术、高密度采集技术、特观技术、岩性反演技术、属性体解释技术等六项重大关键技术取得的突破性进展进行了重点说明。指出随着我国煤炭生产重点的逐步西移,应加强诸如叠前、叠后深度偏移技术的研究,以解决复杂山区三维地震面元内地震反射波散射问题,提高其三维地震勘探精度,为西部煤炭工业做出新贡献!     

200～300N高强度合成金刚石及其在钻探中的应用

对会“打滑”地层,国内外均为难题,新研究的技术是：（１）用特殊的新构思,运用内设备,压制出可批量２供应的高强度金刚石,这种高强度金刚石可承受比目前高得多的钻压;（２）运用强力钻进的配套技术,用上述高强度金刚石制作头。     

Surface renewal analysis for sensible and latent heat flux density

High frequency temperature measurements were recorded at five heights and surface renewal (SR) analysis was used to estimate sensible heat flux density (H) over 0.1 m tall grass. Traces of the temperature data showed ramp-like structures, and the mean amplitude and duration of these ramps were used to calculate H using structure functions. Data were compared with H values measured with a sonic anemometer. Latent heat flux density (E) was calculated using an energy balance and the results were compared with E computed from the sonic anemometer data. SR analysis provided good estimates of H for data recorded at all heights but the canopy top and at the highest measurement level, which was above the fully adjusted boundary layer.     

新疆第四纪盐类矿产的形成和控制因素——兼论“高山深盆”成盐模式

根据袁见齐教授“高山深盆”成盐模式,探讨新疆天山对第四纪盐类矿床的形成和控制作用,阐述了天山地貌、气候、水文特征与盐类矿产的分布规律和特征。认为“高山深盆”并非一定是四周环山的深盆,可以是某一高山与其间深盆或两侧盆地的有机组合。高山的屏障作用造成了垂直的气候分带,在潮湿多雨的山区利于成盐组份的析出并迁移到干旱少雨的闭流深盆中,形成盐类矿床。     

中国南方离子吸附型稀土矿床成矿类型及其母岩控矿因素探讨

传统认为中国南方的离子吸附型稀土矿床可划分为以“足洞式”为代表的重稀土型和以“河岭式”(或“花山式”)为代表的轻稀土型两种矿化类型。然而，近年来发现的许多矿床(如清溪、寨背和馒头山等)的赋矿风化壳中出现了轻稀土矿与重稀土矿并存现象，表现出特殊的“上轻下重”双层矿体结构。这指示了除重稀土型和轻稀土型之外，还存在着轻重稀土共生型的过渡类型。本研究通过对三种不同成矿类型的若干典型矿床系统对比，指出成矿类型的多样性与母岩性质密切相关，尤其是母岩的稀土元素地球化学和稀土载体矿物属性是制约成矿类型变化的关键因素。统计数据表明，从重稀土型→轻重稀土共生型→轻稀土型，成矿母岩的全岩稀土总量变化不大(ΣREY: 200×10-6~450×10-6→200×10-6~500×10-6→200×10-6~800×10-6)，但轻重稀土配分值出现较显著的区间性差异(ΣLREE/ΣHREY: 02~1→1~5→2~10)。与之同时，母岩中能为离子相稀土提供物源且具有重稀土配分属性的稀土副矿物类型和数量明显减少，这与全岩稀土元素地球化学特征中重稀土分量占比的降低趋势也互相匹配。该结果指示，以往认为重稀土配分母岩形成重稀土矿床、轻稀土配分母岩形成轻稀土矿床的传统观点需要外延，即一部分具有低度轻稀土配分属性(1＜ΣLREE/ΣHREY＜5)且含有丰富易风化稀土副矿物的母岩还可能形成轻重稀土共生型矿床，该认识可为今后离子吸附型稀土矿床勘查工作提供新的找矿依据。