凤太矿田层控铅锌(铜)矿床的成矿物质来源探讨

秦岭凤太矿田层控铅锌(铜)矿床的金属物质、硫和成矿溶液主要来自深部基底的岩石,属海底喷流—沉积成因矿床。从这一理论认识出发可进一步分析控矿地质条件及今后在该区有效地寻找同类矿床。     

元岭金矿蚀变破碎带特征及其找矿意义

根据对元岭金矿三条蚀变破碎带一般地质特征、微量元素特征的对比研究，并借鉴邻近矿区蚀变破碎带的矿化特征，本文阐明了元岭蚀变破碎带矿化的有利构造部位，总结了蚀变破碎带特征与矿化强度之间的关系，指出蚀变破碎带的矿化蚀变元素为中低温组合，矿化蚀变愈强则参与元素的种类愈多、数量愈大。围岩性质对矿化蚀变有一定影响，围岩中的易迁移亲铜元素和亲硫铁族无素对矿化有利。据此，为进一步成矿预测、评价蚀变破碎带的含矿性提供依据。     

广西难处理金矿固化焙烧氰化提金试验

通过对广西六梅金矿、明山金矿、金牙金矿含高砷高硫难浸金矿石进行固化焙烧—氰化提金的试验研究 ,获得了砷、硫固定率分别为 99.0 3%、97.0 4 % ,金浸出率 92 .35 %的较好指标 ,为这类难浸金矿的开发 ,展示了一种经济有效的途径     

DCMT光电扫描主测微器的设计与研究

DCMT主测微器不同于其它类型的子午环测微器,它具有自校准测定仪器参数的功能。该测微器采用了活动光栅的方案,其优点是能观测近极星和各类准直像;活动光栅另一个显著优点是不同赤纬星几乎可用相同的观测时间.对“V”形光栅的工作原理和误差进行了详细讨论,并给出了一组严格的公式。其系统误差来源有:光栅形状改正、光栅驱动方向相对于光栅的倾斜、光栅驱动方向相对于赤径方向的倾斜、星径曲率改正。     

黄金的成色

黄金的成色并不是一成不变的，它成色的高低是与成矿温度、成矿阶段、深度、时代、变质程度、水溶液及风化作用等有一定关系，我们从这些关系中可以寻找到我们找矿的捷径和依据。     

中国北西部金矿主要类型,分布规律和成矿带划分

本文较系统地总结了我国北西部金矿主要类型、矿化特征和金矿时空分布规律,在此基础上划分出4个成矿区、12条成矿带、32条成矿亚带,从而指明了找矿方向,为贯彻“以铀为主,综合找矿,多种经营,搞活地质”的方针,提供了较好的参考资料。     

A seismic source zone model for the seismic hazard assessment of the Italian territory

We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.

We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.

The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.

ZS9 is made out of 36 zones where earthquakes with M_w > = 5 are expected. It also assumes that earthquakes with M_w up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.

Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates.