饱和烃经5à分子筛络合前后单体烃碳同位素分析对比研究

通过对自配标准样品(正构烷烃)进行5à分子筛吸附试验,测定了用5分子筛吸附法分离前后正构烷烃、异构烷烃和环烷烃碳同位素值,探讨试验前后碳同位素值的变化。尽管实验过程中样品经过85℃长时间加热回流及吸附样品的5à分子筛用氢氟酸酸化处理,但实验结果经仪器检测,证明该方法对正构烷烃碳同位素值影响因素不大。本文还介绍了原油和煤可溶有机质中饱和烃络合前后的单体烃碳同位素分析方法。并在前人工作的基础上,改进采用微型索氏抽提加热回流实验装置,既提高了样品的回收率,也减少了样品中轻组分的损失。     

温度变化对夏季降温耗能的影响

该文采用降温度日数作为评估夏季降温耗能的指标 ,分析了我国夏季降温度日分布和长期变化特征。温度与降温耗能相关分析表明 ,两者相关密切 ,相关程度随气温升高而增加 ;降温耗能的 1℃效应量 ,北方大于南方。文章最后 ,利用气温距平与降温度日变率建立了夏季降温耗能评估模型。     

波包传播诊断的理论基础和计算方法

文中提出了一种新的利用实际观测资料研究波包传播的诊断方法 (WPD) ,并通过理想资料和实际资料的计算证明了该方法的可用性和广泛性     

土壤热异常对地表能量平衡影响初探

将来自土壤深部的热通量引入off line的陆面过程模式 (NCAR—LSM ) ,通过长达 2a的数值试验对比分析了它对各层次土壤温度和地表能量平衡的影响。　　在土壤底部引入 5W /m2 的热通量使底层土壤显著升温 ,但升温随着接近表层而迅速衰减。积分 3个月后 ,由地下进入地表的热流量增幅可达 1W/m2 以上 ,并持续增大到 5W /m2 ,地表最大升温约 0 .5K ,同时地表感热、蒸发潜热及长波辐射通量均有 1W /m2 左右的正异常 ;若将土壤热传导系数放大一个量级以加速热量交换 ,则地表升温提高到 1K以上 ,长波辐射增加 3W /m2 以上 ,超过了气溶胶全球平均的辐射效应。结果表明 :一定量值的土壤热异常对地表能量平衡和短期气候变化 (10 -1～ 10 1a)有着不可忽略的影响。同时 ,深入的资料分析、完善的陆面过程模式以及它与大气模式的耦合试验也是亟待进行的相关工作。     

土壤热异常影响地表能量平衡的个例分析和数值模拟

The statistical relationship between soil thermal anomaly and short-term climate change is presented based on a typical case study. Furthermore, possible physical mechanisms behind the relationship are revealed through using an off-line land surface model with a reasonable soil thermal forcing at the bottom of the soil layer.In the first experiment, the given heat flux is 5 W m-2 at the bottom of the soil layer (in depth of 6.3 m)for 3 months, while only a positive ground temperature anomaly of 0.06℃ can be found compared to the control run. The anomaly, however, could reach 0.65℃ if the soil thermal conductivity was one order of magnitude larger. It could be even as large as 0.81℃ assuming the heat flux at bottom is 10 W m-2. Meanwhile, an increase of about 10 W m-2 was detected both for heat flux in soil and sensible heat on land surface, which is not neglectable to the short-term climate change. The results show that considerable response in land surface energy budget could be expected when the soil thermal forcing reaches a certain spatial-tem poral scale. Therefore, land surface models should not ignore the upward heat flux from the bottom of the soil layer. Moreover, integration for a longer period of time and coupled land-atmosphere model are also necessary for the better understanding of this issue.     

Optimal design of passive energy dissipation systems based on H∞ and H2 performances

Passive energy dissipation devices (EDDs), such as viscous dampers, viscoelastic dampers, etc., have been used to effectively reduce the dynamic response of civil infrastructures, such as buildings and bridges, subject to earthquakes and strong winds. The design of these passive energy dissipation devices (EDDs) involves the determination of the optimal locations and the corresponding capacities. In this paper, we present two optimal design methodologies for passive EDDs based on active control theories, including H_∞ and H₂ performances, respectively. The optimal design methodologies presented are capable of determining the optimal locations and the corresponding capacities of EDDs. Emphasis is placed on the application of linear matrix inequality (LMI) for the effective design of passive EDDs using the popular MATLAB toolboxes. One important advantage of the proposed approaches is that the computation of the structural response is not needed in the design process. The proposed optimal design methodologies have been applied to: (i) a 10‐storey building and a 24‐storey building both subject to earthquake excitations, and (ii) a 76‐storey wind‐excited benchmark building, to demonstrate the advantages of the proposed design methodologies over the conventional equal capacity design. Copyright © 2002 John Wiley & Sons, Ltd.     

Numerical evaluation of the damping‐solvent extraction method in the frequency domain

The damping‐solvent extraction method for the analysis of unbounded visco‐elastic media is evaluated numerically in the frequency domain in order to investigate the influence of the computational parameters—domain size, amount of artificial damping, and mesh density—on the accuracy of results. An analytical estimate of this influence is presented, and specific questions regarding the influence of the parameters on the results are answered using the analytical estimate and numerical results for two classical problems: the rigid strip and rigid disc footings on a visco‐elastic half‐space with constant hysteretic material damping. As the domain size is increased, the results become more accurate only at lower frequencies, but are essentially unaffected at higher frequencies. Choosing the domain size to ensure that the static stiffness is computed accurately leads to an unnecessarily large domain for analysis at higher frequencies. The results improve by increasing artificial damping but at a slower rate as the total (material plus artificial) damping ratio ζ_t gets closer to 0.866. However, the results do not deteriorate significantly for the larger amounts of artificial damping, suggesting that ζ_t≈0.6 is appropriate; a larger value is not likely to influence the accuracy of results. Presented results do not support the earlier suggestion that similar accuracy can be achieved by a large bounded domain with small damping or by a small domain with larger damping. Copyright © 2002 John Wiley & Sons, Ltd.     

Damaging properties of ground motions and prediction of maximum response of structures based on momentary energy response

Dynamic damaging potential of ground motions must be evaluated by the response behaviour of structures, and it is necessary to indicate what properties of ground motions are most appropriate for evaluation. For that purpose, the behaviour of energy input process and hysteretic energy dissipation are investigated in this study. It is found that the momentary input energy that is an index for the intensity of input energy is related to the characteristics of earthquakes such as cyclic or impulsive, and to the response displacement of structures immediately. On the basis of these results, a procedure is proposed to predict inelastic response displacement of structures by corresponding earthquake input energy to structural dissipated damping and hysteretic energy. In this procedure the earthquake response of structures is recognized as an input and dissipation process of energy, and therefore structural properties and damaging properties of ground motions can be taken into account more generally. Lastly, the studies of the pseudodynamic loading test of reinforced concrete structure specimens subjected to ground motions with different time duration are shown. The purpose of this test is to estimate the damaging properties of ground motions and the accuracy of the proposed prediction procedure. Copyright © 2002 John Wiley & Sons, Ltd.     

25～75℃酸性NaCl溶液中方铅矿的溶解动力学

在25～75℃、pH=0.43～2.45的1mol/LNaCl溶液中进行了方铅矿的溶解动力学实验。发现在远平衡条件下,方铅矿的溶解速率r与氢离子活度犤H+犦呈线性关系,溶解速率方程(速率定律)为:r=k犤H+犦,即对H+而言,溶解反应为一级。其中速率常数k为2.344×10-7mol/m2·s(25℃)、1.380×10-6mol/m2·s(50℃)、7.079×10-6mol/m2·s(75℃)。溶解反应的活化能为43.54kJ/mol,方铅矿的溶解机理为表面化学反应,速率决定步骤为表面配合物的离解。     

Analyzing CO2 emissions mitigation by technology improvement in Central and Eastern Europe

As a legacy of the centrally planned economy, the economies in transition of Central and Eastern Europe (CEE) have a unique potential to reduce their greenhouse gas emissions through the improvement in their high energy intensities. Since much of this `low-hanging fruit' in energy-efficiency improvements can be highly cost-effective, many developed countries facing difficulties in meeting their greenhouse gas (GHG) emission targets domestically are eager to find such opportunities in the CEE region. Therefore, studies analysing the potentials and costs of carbon dioxide reduction through technology improvement in the region have come into the limelight. While there are a few excellent studies in the region aimed at analysing climate change abatement potentials, they all embark on different assumptions, methodologies and boundary conditions. It is hence difficult, if not impossible, to compare and analyse the results of these studies across different authors, countries or time horizons. Consequently, the purpose of this paper is to place four leading studies on GHG mitigation through technology improvement from the CEE region into an internationally comparable framework. Four studies were selected from three countries, Poland, Hungary and Estonia, which are all the results of major national and international efforts to assess costs and potentials of GHG reduction. The paper places their assumptions, methods and final results into a framework which enables policy-makers and project designers to compare these across geographical and technological boundaries. Since other studies from around the globe have been analysed in this framework in the literature, this paper provides a vehicle for the findings of these four studies to be compared to others worldwide. In addition, the paper highlights a few areas where similar studies to be completed in the future in the region may be enhanced by incorporating features used in GHG mitigation research in other parts of the world. This revised version was published online in July 2006 with corrections to the Cover Date.