滑带土动力学性质试验研究

为了研究地震高烈度区老滑坡的复活变形原因,本文对滑坡滑带土的动力学特性进行了系列研究。本次试验采用扰动土样,制样基本物理指标按滑带土的现场测试指标确定,在不固结不排水条件下,运用MTS810Teststar程控液压伺服土动三轴仪对单个样品逐级放大动应力的分级试验方法进行。侧向压力 (围压 )分别采用 100kPa、20 0kPa、300kPa三级,通过施加轴向振动荷载 (力 )模拟地震作用,振动波形为正弦波,频率为 1Hz,振幅随试样性质确定。研究结果表明,滑带土在动荷载作用下的动力学性质与其静荷载作用下的力学性质有着较大的差异,主要表现在滑带土的动应力与动应变关系的非线性、滞后性及变形积累特点,动弹性模量与动强度的显著降低以及动阻尼比的显著增大特性。这揭示了动力作用下的滑坡复活原因之一,同时为滑坡稳定性评价和动力作用下的变形机制模拟分析提供了基础资料,也为分析滑带土动力本构模型提供了基本内容。     

黄土滑坡临滑预报的应变控制方法

我国西北部地区黄土沉积巨厚，地质构造复杂，土体强度低，水敏感性强，各种类型的黄土滑坡广泛分布。黄土滑坡具有滑动规模大、滑动速度快、灾害损失严重等特点。黄土滑坡滑动时间预报，特别是临滑预报在地质灾害防治领域具重要意义。根据黄土力学性质试验与典型黄土滑坡变形分析研究结果，在对比分析黄土剪切应变特性与滑坡滑动破坏机制的基础上，论文提出了一种黄土滑坡临滑预报的应变控制方法。建立了中、浅层与厚层黄土滑坡的应变破坏标准。经多处滑坡实例验证，结果基本合理，可应用于黄土滑坡临滑预报。     

大兴安岭浅覆盖区生态地质评价方法初探——以1∶25万区调呼中镇幅为例

通过野外调查，在收集统计大量基础地质、经济地质、环境地质、旅游地质、农(林)业地质等数据信息的基础上，在GIS技术指导下，采用定量定性相结合的半定量分析评价方法，对森林浅覆盖区生态地质现状及各类资源的开发利用潜力进行了综合评价。在研究和探讨森林浅覆盖区生态地质综合评价方法的基础上，提出了森林浅覆盖区生态地质评价模型，确定了综合参数，划分了生态地质类型。     

影响新生界"底含"发育的因素及含水层参数修正

分析了“底含”发育的主要影响因素，并以祁东煤矿为例，利用地下水动力学方法重新计算了“底含”的有关参数，对以往抽水试验参数进行修正，并成功地运用到邻近矿井。该研究表明，在富水性较强的古河道发育位置，要合理留设防水煤岩柱，才能保证煤矿安全生产。     

软土大变形固结计算中参数识别的遗传算法

含水量很高的饱和软土在外荷载作用下沉降很大,小变形分析误差太大,必须通过大变形非线性固结计算来模拟。遗传算法是一种全局优化和搜索的仿生算法。近年来随着工程领域中复杂的大规模非线性系统的出现,遗传算法日益得到青睐,目前已经广泛应用到各个领域中。本文对遗传算法做了改进,主要体现在杂交算子的选取和轮盘赌模型的模拟退火拉伸,并将其用于饱和软土的大变形固结分析,解决其中的关键参数识别问题。研究表明该方法是行之有效的,值得进一步研究探索。     

实现数据库管理震源参数的探索

就如何利用数据库，结合Java、XML等手段对震源参数管理进行了一些探索，并给出了一些在一个实际系统中实现了的例子。     

Changes in source parameters of foreshocks and aftershocks of the 2001 M_S=6.0 Yajiang, Sichuan, earthquake

Introduction An MS=6.0 earthquake occurred on February 23, 2001 in Yajiang county, Sichuan Province. The earthquake is located on the east of the southeast segment of the Litang-Dewu fault with strike of NW. Before the event, on February 14, an MS=5.0 earthquake took place nearly in the same place. In 1948 an MS=7.3 earthquake occurred on the northwestern segment of the Litang fault. The length of the surface rupture belt caused by the earthquake is 70 km, which extended from Litang to…     

Limnology of four saline lakes in western Victoria, Australia: II. Biological parameters

Major biological parameters of four permanent (Lake Colac, Modewarre, Bolac and Tooliorook), shallow and slightly saline lakes in the volcanic plains of western Victoria, Australia recorded bi-monthly between November 1999–September 2001 are described. Chlorophyll a concentration ranged from 3–29 μg l⁻¹ with peaks in autumn. Phytoplankton taxa recorded were diverse, with Chlorophyta and Bacillariophyta being common. Cyanobacterial blooms were recorded mostly in summer. Zooplankton abundance in the lakes ranged from 12–368 individuals per litre. Rotifera dominated Lake Bolac, Copepoda dominated Lake Modewarre and they co-dominated Lake Colac and Tooliorook. Zooplankton interactions with phytoplankton suggest that simple predator-prey relationships cannot fully explain the trends exhibited and that a more complex model was acting to regulate algal biomass. A decline in the abundance of zooplankton in summer in Lake Modewarre was attributed to predation by high number of exotic larval carp at that time of the year. A total of 25 benthic macroinvertebrate taxa were recorded from Lake Colac, 30 from Modewarre, 22 from Bolac and 35 from Tooliorook. Twenty-one of the 45 taxa identified occurred in at least three lakes. Nine of the 12 taxa that occurred in only one lake were from Lake Tooliorook. Simpson's diversity index was low in Lake Bolac when compared to other three lakes. Lake Modewarre had more benthic individuals (3246 Ind m⁻²) than other three lakes (range 624–1397 Ind m⁻²). The combined contribution of Ostracoda, Amphipoda and Gastropoda dominated the benthos in all the lakes throughout the study period. Macroinvertebrate taxa richness was higher in the present study lakes than recorded from the lakes in the region. Frequency of sampling and number of sampling sites seemed more important in determining species richness than the size and shallowness of the lakes.     

Optimum multiple tuned mass dampers for structures under the ground acceleration based on the uniform distribution of system parameters

The five MTMD models, with natural frequencies being uniformly distributed around their mean frequency, have been recently presented by the first author. They are shown to have the near‐zero optimum average damping ratio (more precisely, for a given mass ratio there is an upper limit on the total number, beyond which the near‐zero optimum average damping ratio occurs). In this paper, the eight new MTMD models (i.e. the UM‐MTMD1～UM‐MTMD3, US‐MTMD1～US‐MTMD3, UD‐MTMD1 and UD‐MTMD2), with the system parameters (mass, stiffness and damping coefficient) being, respectively, uniformly distributed around their average values, have been, for the first time here, proposed to seek for the MTMD models without the near‐zero optimum average damping ratio. The structure is represented by the mode‐generalized system corresponding to the specific vibration mode that needs to be controlled. Through minimization of the minimum values of the maximum dynamic magnification factors (DMF) of the structure with the eight MTMD models (i.e. through the implementation of Min.Min.Max.DMF), the optimum parameters and values of Min.Min.Max.DMF for these eight MTMD models are investigated to evaluate and compare their control performance. The optimum parameters include the optimum mass spacing, stiffness spacing, damping coefficient spacing, frequency spacing, average damping ratio and tuning frequency ratio. The six MTMD models without the near‐zero optimum average damping ratio (i.e. the UM‐MTMD1～UM‐MTMD3, US‐MTMD1, US‐MTMD2 and UD‐MTMD2) are found through extensive numerical analyses. Likewise, the optimum UM‐MTMD3 offers the higher effectiveness and robustness and requires the smaller damping with respect to the rest of the MTMD models in reducing the responses of structures subjected to earthquakes. Additionally, it is interesting to note, by comparing the optimum UM‐MTMD3 with the optimum MTMD‐1 recently investigated by the first author, that the effectiveness and robustness for the optimum UM‐MTMD3 is almost identical to that for the optimum MTMD‐1 (without inclusion of the optimum MTMD‐1 with the near‐zero optimum average damping ratio). Recognizing these performance benefits, it is preferable to employ the optimum UM‐MTMD3 or the optimum MTMD‐1 without the near‐zero optimum average damping ratio, when installing the MTMD for the suppression of undesirable oscillations of structures under earthquakes. Copyright © 2003 John Wiley & Sons, Ltd.     

地震荷载作用下温度和围压对冻土强度影响的试验研究

通过对重塑冻结兰州黄土的动三轴试验，较系统研究了地震荷载作用下冻土的动强度特性，并且定量研究了其在不同温度(-2℃、-5℃、-7℃)和围压(1MPa、3MPa、5MPa)条件下的变化规律．结果发现：冻结黄土的动抗剪强度随围压的增大、温度的降低、振次的减少而增大；动粘聚力Cd随振次的减小和温度的降低而增大；动内摩擦角吼随振次的增大和温度的降低而增大。