Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

交流变频调速CD-2B型岩心钻机的研制

介绍了交流变频调速CD－2B型岩心钻机研制情况，技术参数，主要特点及型式检验，生产试验等情况。     

云南水汞在姚安6.5级地震前的异常特征分析

对2000年1月15日姚安6．5级地震前后云南水汞异常进行分析研究，结果表明：在9个观测台站中，地震前有1个观测台站的水汞出现中期趋势异常，1个台站的水汞出现远震异常，4个台站的水汞出现短期异常，1个台站的水汞出现临震异常。地震前3个月内，水汞短期异常有活跃，平静的过程，在平静中(仅1个台站出现临震异常)发生姚安6．5级地震。姚安地震发生在距出现远震异常的水汞观测台站70km的地方。出现远震异常的水汞观测台站附近，可能是未来强震的发震地区。     

标定大陆科学钻探孔区地震反射体

在中国大陆科学钻探孔区 (江苏省东海县南部 )进行了系统的地球物理调查 ,包括二维地震测网和专门的地震剖面 ,大地电磁法和位场方法等 .地震调查表明 ,在超高压变质岩出露区上地壳充满了反射体 ,包括倾斜反射体与上拱的反射弧 .本文介绍大陆科学钻探先行研究中地震调查的成果 .根据大陆科学钻探预先导孔的岩芯和测井资料、井旁VSP和数值模拟结果证实 ,高波速的榴辉岩体、破碎断裂带和大型韧性剪切带都可引起倾斜的地震反射 ,而上拱的弧形反射体则是由近似直立的榴辉岩体和其中的破碎带的综合反映 .由于地壳深部广泛分布着经受变质的岩石 ,上述研究结果对标定地壳中的反射地震信号具有一定意义     

近几十年来西北江三角洲网河区顶点的河相关系

据西北江三角洲网河区顶点马口、三水两水文站1959－1988年的实测大断面、流量、流速和水位资料，采用Leopold的水力几何形态关系建立断面河相关系，探讨两水文观测断面的河相关系特征、年际变化及河相关系的差异。河相关系表明，西北江三角洲的断面水力几何形态指数β1值相对较小，而β3值相对较大，代表了珠江特有的丰水少沙河流的河相关系。     

Parameter identification for lined tunnels in a viscoplastic medium

This paper is dedicated to the identification of constitutive parameters of elasto‐viscoplastic constitutive law from measurements performed on deep underground cavities (typically tunnels). This inverse problem is solved by the minimization of a cost functional of least‐squares type. The exact gradient is computed by the direct differentiation method and the descent is done using the Levenberg–Marquardt algorithm. The method is presented for lined or unlined structures and is applied for an elastoviscoplastic constitutive law of the Perzyna class. Several identification problems are presented in one and two dimensions for different tunnel geometries. The used measurements have been obtained by a preliminary numerical simulation and perturbed with a white noise. The identified responses match the measurements. We also discuss the usage of the sensitivity analysis of the system, provided by the direct differentiation method, for the optimization of in situ monitoring. The sensitivity distribution in space and time assess the location of the measurements points as well as the time of observation needed for reliable identification. Copyright © 2002 John Wiley & Sons, Ltd.     

中国煤炭地质钻探技术发展五十年

概要介绍了煤田钻探技术五十年来的发展状况，提出了今后的设想。     

地下管线探测工程的资料自动化整理

地下管线探测工程一般分为野外探测和室内资料整理两阶段。内业整理包括成果表的编制、管线综合分布平面图和管线数据库。由于管线探测工程数据多,为了充分利用外业探测成果,应用Visual Basic 6.0(VB6)开发了一套地下管线管理信息系统(UTMIS),该系统实现了地下管线探测工程内业整理的自动化,极大地提高了工作效率数据精确度。     

中国大陆科学钻探钻探子工程钻进实时记录网页的开发

以中国大陆科学钻探实时记录网页的开发为例，介绍了在开发网络数据库时，利用Excel组件作输入界面，实现查询界面上表格的表头和表尾不动、而中间行可以滚动，实现回次滚动查询和界面实时刷新。     

机械卡盘设计中的计算误差分析与应用

通过对普通机构二维力因素影响的分析，利用修正公式计算求值，以修正单因素影响最大值计算所产生的误差。利用这一计算方法，对CD—3型钻机卡盘进行了计算，得到了正确的设计结果，说明用修正公式对多因素影响采用单因素影响最大值计算进行修正是可行的。