江蓠中类菌孢素氨基酸(MAAs)成分分析及提取研究

利用高效液相色谱技术对江蓠(Gracilariaceae)中类菌孢素氨基酸(MAAs)进行了分析,并采用响应面分析法对MAAs物质的提取工艺进行优化研究。根据正交旋转组合试验设计原理,采用四因素五水平的响应面分析法,依据回归分析确定各因素的显著程度及最优工艺条件。结果表明,江蓠中MAAs的主要成分为porphyra-334;提取温度、浸提时间、甲醇浓度及液固比为影响MAAs物质提取的显著因素。通过多元二次回归拟合模型响应面分析,得到最优工艺条件:提取温度48.12℃,液固比34∶1,甲醇浓度25%,浸提时间1.85 h,优化条件下预测提取率为4.943 mg/g;试验值为4.893 mg/g,试验值与预测值吻合较好,响应面回归模型的准确性得到验证。     

Robust leader-follower formation tracking control of multiple underactuated surface vessels

This paper is concerned with the formation control problem of multiple underactuated surface vessels moving in a leader-follower formation.The formation is achieved by the follower to track a virtual target defined relative to the leader.A robust adaptive target tracking law is proposed by using neural network and backstepping techniques.The advantage of the proposed control scheme is that the uncertain nonlinear dynamics caused by Coriolis/centripetal forces,nonlinear damping,unmodeled hydrodynamics and disturbances from the environment can be compensated by on line learning.Based on Lyapunov analysis,the proposed controller guarantees the tracking errors converge to a small neighborhood of the origin.Simulation results demonstrate the effectiveness of the control strategy.     

锦州湾表层海水微塑料分布特征

海洋微塑料是全球关注的新兴环境问题,海湾由于特殊的地理环境特征,成为微塑料分布研究的热点区域。本研究以锦州湾为研究海域,于2017年10月布设了11个点位开展表层海水微塑料样品采集,在实验室采用湿式氧化法开展样品前处理,应用傅立叶变换显微红外光谱仪分析鉴定微塑料成分。研究结果表明,锦州湾表层水体微塑料平均丰度为(0.93±0.59)个/m³,微塑料数量占全部塑料样品的96.2%。微塑料的主要成分为聚丙烯和聚乙烯,分别占55.0%和23.5%;线状和片状塑料的比例最高,分别占41.7%和26.2%;白色、蓝色和半透明微塑料分别占35.1%、26.0%和21.4%。受水动力条件和陆域河流输入等影响,锦州湾表层水体中微塑料的空间分布整体呈现北部偏高,向南部递减的趋势。     

黄骅电厂二期工程温排水排放方案优选

在利用分步杂交有限元方法建立渤海湾潮流场的基础上,通过数值模拟的方法建立黄骅电厂温排水海域的温度场,对不同温排水设计方案进行了预测分析。设计方案充分考虑了排放口位置、排水量和温升对海域环境造成的影响,设计了一、二期工程排放口分建和合建时的五种方案。预测结果的对比分析显示,方案V(一、二期工程温排水集中由2排放)是最佳方案。     

Computation of solitary waves during propagation and runup on a slope

A numerical time-simulation algorithm for analysing highly nonlinear solitary waves interacting with plane gentle and steep slopes is described by employing a mixed Eulerian–Lagrangian method. The full nonlinear free surface conditions are considered here in a Lagrangian frame of reference without any analytical approximations, and thus the method is valid for very steep waves including overturning. It is found that the runup height is crucially dependent on the wave steepness and the slope of the plane. Pressures and forces exerted on impermeable walls of different inclinations (slopes) by progressive shallow water solitary waves are studied. Strong nonlinear features in the form of pronounced double peaks are visible in the time history of pressure and force signals with increasing heights of the oncoming solitary waves. The effect of nonlinearity is less pronounced as the inclination of the wall decreases with respect to the bottom surface.     

Role of sea surface temperature and rainfall in determining the stock and fishery of the common octopus (Octopus vulgaris,Mollusca, Cephalopoda) in Tunisia

Octopus (Octopus vulgaris, Mollusca, Cephalopoda) is an important and valuable fishery resource on the eastern and southern coasts of Tunisia, but its landings are highly variable. This paper explores the effect of environment on octopus catch per unit effort (CPUE) during a 12‐year period, through correlation analyses and the incorporation into surplus production models of sea surface temperature (SST) and rainfall data collected during cold (January–May) and hot (August–October) seasons. CLIMPROD software was used to select the appropriate model and fit it to the fishery and environment data. In both seasons, SST significantly contributed to CPUE variability; fishery production was influenced positively by cold season SST but negatively by hot season SST. Due to a poor fit with cold season data, the impact of rainfall was analysed only for the hot season, during which it has a positive effect on production. Results are discussed in view of the life‐cycle of octopus and the dynamics of the Tunisian fishery. This first study of octopus variability in Tunisia highlights the necessity to incorporate environmental influence into stock assessment and management advice.     

TMI、AMSR-E全球海表温度与Argo近海表温度的比较

本文将TMI（Tropical Rainfall Measuring Mission （TRMM）Microwave Imager）和AMSR-E（Advanced Microwave Scanning Radiometer for the Earth Observing System）卫星观测的全球海表温度与Argo浮标观测的近海表温度进行了比较。并检验了影响海温变化的因素,包括风速、水汽含量、液态云和地理位置。结果显示,TMI、AMSR-E海表温度与Argo近海表温度均明显相关。在低风速时,TMI、AMSR-E海表温度整体比Argo近海表温度高。在低风速时,TMI比AMSR-E海表温度更接近Argo近海表温度,但TMI海表温度在高纬可能没有经过良好校正。温度差异显示,在低水汽含量时,TMI和AMSR-E海表温度显示出暖的差异,代表TMI和AMSR-E海表温度在高纬均没有经过良好校正。黑潮延伸区的海表温度变化要比海潮区明显。春季在黑潮延伸区,卫星观测的海表温度与Argo近海表温度差异较小。在低风速时,TMI和AMSR-E海表温度均经过了良好校正,而TMI比AMSR-E效果更好。     

利用南极走航观测评估卫星遥感海表面温度

利用1989-2005年间南极走航观测的海表面温度,对目前3个主要的卫星反演的SST产品AVHRR(Advanced Very High Resolution Radiometer),TMI(TRMM Microwave Imager)和AMSR-E(Advanced Microwave Scanning Radiometer for the Earth Observing System)进行了较为系统的评估,并着重检验了它们在南大洋的准确性.结果表明,AVHRR SST比观测数据偏冷,白天的偏差为-0.12℃,夜晚的偏差为-0.04℃,而且南大洋的冷偏差更为显著.TMI SST比观测数据明显偏暖,白天的偏差为0.48℃,夜晚的偏差为0.57℃,其温差ΔT受37GHz风速影响,在强风速(>6m/s)下这种影响仍然存在.AMSR-ESST比观测数据偏暖,白天的偏差为0.34℃,夜晚的偏差为0.27℃,而且南大洋的暖偏差相对较大.AMSR-E SST温差受水汽影响,并在南大洋随着水汽的增加而增加.通过进一步比较微波(AMSR-E和TMI)和红外(AVHRR)遥感的SST在2004年北半球冬季(即南半球夏季)的差别,发现微波遥感在热带(15°S-15°N)和南大洋区域(45°S以南)比红外遥感偏暖,而且在南大洋区域的偏差相对较大,相反在北半球中纬度区域(15°~40°N)偏冷.AMSR-E与AVHRR SST的温差,从白天到夜晚有减小的趋势,而TMI与AVHRR SST的温差无明显的变化.     

不同海区石英悬浮体颗粒表面微结构特征及其成因

悬浮石英颗粒表面在不同的水动力环境中会形成一些特有的表面结构,对这些特点的研究有助于理解微小颗粒在水中的行为以及沉积环境的变化。基于对在不同海区采取表层和不同深度的悬浮石英颗粒表面结构的扫描电镜的观察, 发现在水动力较强的南海海域石英颗粒表面大多呈现出机械作用成因的结构,化学溶蚀痕迹不明显;马六甲海峡、孟加拉湾南部海域、阿拉伯海东部海域站位石英颗粒表面开始出现明显的化学溶蚀痕迹,为机械-化学溶蚀作用的结果;莫克兰海沟站位表层样品石英颗粒表面化学溶蚀作用强烈,随着深度的增加,溶蚀作用减弱,200m水深以下,石英颗粒表面的结构主要为机械-化学溶蚀作用的结果。中国南海西南部3号站位、马六甲海峡北部7号站位以及孟加拉湾南部的11号站位的表层石英悬浮体颗粒较大,可以达到10μm左右,大于其他海区的石英颗粒(3～4μm)。研究海区海水中悬浮体石英颗粒大都呈现棱角状,表现为近源沉积,偶尔可见磨圆度较好且表面有新月形撞击坑,推测可能为风尘沉积。