火电厂粉煤灰的矿物磁性及其环境意义

火电厂排放的粉煤灰是重要的大气颗粒污染物之一,利用粉煤灰的磁性监测环境污染是新近发展的新手段。应用矿物磁测技术和X射线衍射对浙江省主要电厂排放的粉煤灰的矿物磁性特征和磁性矿物学,以及与重金属元素的关系进行了研究,结果表明粉煤灰具有较高的磁化率（X）、软剩磁（IRM20mT）和饱和等温剩磁（SIRM）值,粉煤灰频率磁化率（Xfd）的平均值为2．5％,磁性矿物以多畴（MD）颗粒存在,粉煤灰的剩磁矫顽力（BCR）在42～53mT之间。矿物测试结合X射线衍射分析表明粉煤灰中的氧化铁矿物以FeO4和Fe2O3-α为主,粉煤灰的磁化率与Fe、Mn、Pb、Zn、Cu、CA含量呈显著线性正相关,相关系数（r）分别是0．924,0．866,0．725,0．756,0．945和0．867,磁化率可作为粉煤灰中重金属元素含量的代用指标。     

Swelling behaviour of expansive soil treated with fly ash–GGBS based binder

In this article, the potential of a binder developed by admixing fly ash and ground granulated blast furnace slag (GGBS) to stabilise expansive soils is evaluated. Laboratory tests included determination of free swell index, swell potential and swelling pressure tests of the soil/binder mixtures at different mixing ratio. The test results showed decrease in the swelling behaviour of the soil with increase in binder content. The percent swell–time relationship was observed to fit the hyperbolic curves enabling us to predict the ultimate percent swell from few initial test results. Addition of 1% of lime to the binder showed further improvement in reducing swelling. A good linear relationship is established between percent oedometer swell and modified free swell index (MFSI) for soil/binder mixtures without lime but the same has not been observed in the presence of lime. The compressibility characteristics of the soil/binder mixtures reduced nominally with increase in binder content but in the presence of lime, the compressibility reduced significantly. Binder used in this study has been found to be effective and economic to stabilise expansive soils with lesser amount of chemical additives such as lime.     

Use of fly ash with no water consumption for cold regions transportation infrastructure

The construction period in cold regions is very short due to problems related to excavation and use of frozen soils in embankment construction, which leads to excessive deformations upon thawing. Also, handling of compaction water is critical due to freezing temperatures. Coalburning thermal power plants are very common in cold regions to supply electricity. The inorganic part of the pulverized coal after burning produces fly ash, which is available in large volumes. Due to excavation difficulties and the poor engineering behavior of frozen soils in cold regions, the utilization of fly ash when it is readily available must be promoted. Any construction technique which utilizes alternative materials like fly ash and minimizes water consumption has a potential to extend the short construction season and even allow service and maintenance during extreme weather conditions. This paper presents two potential techniques to solve the moisture affinity of silt-sized materials like fly ash. One technique involves in-plant production of fly ash pellets using cold-bonding pelletization to manufacture aggregates of up to 40,000-μm diameter from 15- to 60-μm-diameter fly ash grains. Large disc pelletizers have annual production capacities of up to one million ton at a reasonable cost. The product has adequate strength for embankment construction even when no water is used and no compaction is applied. The second technique is an in situ mixing technique which uses snow instead of compaction water for fly ash. The snow is the main element in this technique to compact the embankment. Water is needed for the hydration reactions to form cementitious minerals in fly ash. The slower the hydration reaction, the greater the crystal growth of cementitious minerals. In the proposed technique, in situ snow is mixed with fly ash and is compacted on-site. The temperature increase due to the hydration reaction of fly ash upon contact with snow crystals provides water for continued long-term hydration, which results in high strength, a high void ratio, light weight, and high thermal insulation capability. The presented techniques have the potential to extend the short construction season in cold regions and will provide fill material, decreasing the need for excavation. Both techniques are well documented under laboratory conditions, the research results have been published, and the techniques are ready for field trials to assess implementability.     

粉煤灰增强回填碱渣工程特性的试验研究

碱渣与饱和卤水混合制成浆体回填到盐矿废弃盐腔可同时解决碱渣处理问题和地下废弃盐腔存在的地质隐患。回填碱渣强度是影响充填效果的重要因素。因此,为了提高回填碱渣强度,采用掺入粉煤灰制成复合碱渣对其强度特性进行改良。针对不同粉煤灰掺合比的碱渣开展了组成、力学和细观试验。研究结果表明：（1）掺入粉煤灰能明显改善碱渣的强度,使其黏聚力、内摩擦角都大幅提高,抗剪强度大幅增加;（2）粉煤灰掺合比越大,增强效果越明显,但强度并非随掺合比呈线性变化,对黏聚力而言,在0～20%内的掺合比下增加速度最快,而对内摩擦角则在20%～30%的掺合比区间增加最快,对抗剪强度而言,0～20%的掺合比内增加最明显;（3）粉煤灰掺入还可显著改善碱渣的压缩固结特性,使其固结系数大幅提高,从而提高碱渣固结速度,缩短充填工期,其中在0～10%的掺合比内对压缩固结特性改善最显著;（4）矿物组成分析表明,粉煤灰掺入改变了矿物组成,使得亲水性矿物含量急剧锐减,进而改变了其沉积特性。而细观分析则表明,粉煤灰掺入使碱渣从絮凝团细观结构变成了粉煤灰充当骨架的充填结构,且粒间支撑和拉联效应明显。从增强效果提高、压缩固结特性增强、控制成本和工期综合分析表明,最优掺合比为20%左右,建议工程中以不高于20%的掺合比作为实用掺合比即可取得较为理想的充填增强效果。该研究为揭示碱渣增强机制及废弃盐腔碱渣充填工艺优化提供了有益参考。     

四川万州中侏罗统上沙溪庙组粘土岩中火山灰的岩矿和地球化学证据

四川盆地东北缘万州地区中侏罗世上沙溪庙组产出稳定层状浅色粘土岩。利用X射线、X荧光光谱、等离子光谱（ICP）等方法对矿物成分、常量、微量和稀土元素进行了测试分析,粘土岩主要矿物为蒙脱石、伊利石和绿泥石。通过与澳大利亚后太古代平均页岩（PAAS）、北美平均页岩（NASC）、地壳粘土岩背景值以及其它具有代表性岩石的对比发现,本区粘土岩微量元素具有明显的低V,低Ti和低铁族元素的特点,高Al2O3／TiO2比值和低Ti／Th比值特征显著,某些层位具有明显的Eu负异常。推断本区粘土岩沉积物源具有火山灰和陆源碎屑的二元混合成因,各层位成分的差异显示了不同沉积时间内二者的混合比例发生变化。区域对比和地球化学资料显示火山灰可能来自于西部600km远的特提斯洋岛弧火山。     

大掺量粉煤灰淤泥固化土的强度与耐久性研究

基于传统水泥和石灰固化处理方法,提出了利用大掺量低钙粉煤灰、水泥和石灰固化剂进行淤泥固化处理的方法,以期改善淤泥的强度和耐久性,达到淤泥和粉煤灰双重资源化利用的目的。通过一系列室内试验,探讨了该方法处理后固化淤泥的击实特征、强度特性、水稳性和耐久性。试验结果表明：淤泥固化后最优含水率有所降低、最大干密度则略有增加;弹性模量、无侧限抗压强度和抗拉强度均有不同程度的增加,水泥掺量越大,养护时间越长,强度和弹性模量越大;固化后淤泥水稳性得到明显改善;浸水软化和冻融循环导致固化土抗压强度显著劣化,冻胀融缩导致设计混合料的无侧限抗压强度减小约22%。     

Utilization of sodium waterglass from sugar cane bagasse ash as a new alternative hardener for producing metakaolin-based geopolymer cement

Sugar cane bagasse ash from SOSUCAM company in Cameroon was used to synthesize sodium waterglass as a new alternative hardener. The new hardener was used to prepare metakaolin-based geopolymer cements. The compressive strength of the resulting geopolymer cement cured at room temperature for 28 days was 32.9 MPa. Samples soaked for 28 days in water in parallel experiments revealed a strength of 31.4 MPa. This shows that exposure of water does not lead to any weakening. The value of water absorption was 7.1% in the water-soaked cements, indicating the presence of fewer pores and voids than in the dry cements. However, in SEM micrographs, the microstructure of geopolymer cement appears rather homogeneous and compact without any change by water soaking. It can thus be concluded that sodium waterglass from sugar cane bagasse ash can be used as an alternative hardener or reactive ingredient for producing geopolymer cement with a high degree of cross-linking geopolymer framework. The use of this low-value silica-rich waste for producing sodium waterglass results in environmental benefits including a significant reduction of CO₂ emission and energy consumption compared to the production of commercial sodium waterglass.     

Characteristics of phosphate adsorption onto granulated coal ash in seawater

The deterioration of sediments is a serious environmental problem. Controlling nutrient release fluxes from sediments is important to alleviating eutrophication and to reducing terrigenous nutrient loads. The purpose of this study was to evaluate the phosphate removal performance of granulated coal ash (GCA) from seawater, which is produced from coal thermal electric power generation. Batch experiments were carried out to investigate the removal kinetics of phosphate from seawater under both oxic and anoxic conditions. Phosphate was removed well from seawater under both oxic and anoxic conditions. The adsorption isotherm for phosphate revealed that GCA could remove phosphate effectively from seawater above a concentration of 1.7 μmol L⁻¹. GCA can reduce the concentration of phosphate in seawater effectively under anoxic conditions where iron type adsorbents cannot be applied. Therefore, GCA could potentially be used to adsorb phosphate in the organically-enriched sediment, which generally occurs under highly reductive conditions.     

长白山地区火山碎屑粒度特征研究

长白山地区全新世火山活动活跃,发育了良好的火山空降、火山碎屑流、火山涌流和火山泥石流堆积物。这些堆积物交错堆积,野外区分较为困难。在火山碎屑地层剖面调查基础上,系统采集了各种类型的火山碎屑堆积物样品。在实验室通过粒度参数和概率累积曲线分析,对堆积物成因类型进行了判别,讨论了火山空降堆积物和火山碎屑流堆积物随着与火口距离变化的规律。首次对研究区内粒度范围为62.5～0.02μm的细火山灰进行了粒度分析,对火山碎屑流和火山碎屑涌流中细火山灰端元分布特征和地质意义进行了分析和讨论     

Liquefaction behaviour of loose and compacted pond ash

Most of the ash produced all over the world is primarily disposed off by wet disposal method onto the ash ponds, which are occupying huge valuable lands. This disposal problem can be minimized by utilizing ash in large geotechnical earthworks. However, its use in earthquake prone areas requires thorough understanding of its liquefaction resistance and nature of development of excess pore pressures under dynamic loading conditions. Investigations have been carried out in this paper on the liquefaction behaviour of pond ash by conducting cyclic triaxial tests on inflow and outflow ash samples collected from two different ash ponds. Distinctly different liquefaction phenomenon was observed for the ash samples from inflow and outflow points of the same ash pond. Inflow samples exhibited higher cyclic resistance than outflow samples and their strengths were comparable with the natural sands. Further studies revealed that the influence of various factors on liquefaction susceptibility of both the types of ashes is similar to that of natural sands.