离散裂隙渗流方法与裂隙化渗透介质建模

流体渗流模拟的连续介质方法通常适用于多孔地质体，并不一定适用于裂隙岩体，由于裂隙分布及其特征与孔隙差异较大。若流体渗流主要受裂隙的控制，对于一定尺寸的裂隙岩体，多孔介质假设则较难刻划裂隙岩体的渗流特征。离散裂隙渗流方法不但可直接用于模拟裂隙岩体非均质性和各向异性等渗流特征，而且可用其确定所研究的裂隙岩体典型单元体及其水力传导（渗透）张量大小。主要讨论了以下问题：（1）饱和裂隙介质中一般的离散流体渗流模拟；（2）裂隙岩体中的REV（典型单元体）及其水力传导（渗透）张量的确定；（3）利用离散裂隙网络流体渗流模型研究裂隙方向几何参数对水力传导系数和REV的影响；（4）在二维和三维离散裂隙流体渗流模型中对区域大裂隙和局部小裂隙的处理方法。调查结果显示离散裂隙流体渗流数学模型可用来评价不同尺度上的裂隙岩体的水力特征，以及裂隙方向对裂隙化岩体的水力特征有着不可忽视的影响。同时，局部小裂隙、区域大裂隙应当区别对待，以便据其所起的作用及水力特征，建立裂隙化岩体相应的流体渗流模型。     

华北克拉通北部内、外缘中生代流体成矿作用研究--以大井、蔡家营典型矿床为例

华北克拉通北部内、外缘中生代形成的有色金属矿种繁多 ,以外缘富 Sn、内缘富 Mo,Cu、Pb、 Zn遍布内、外缘为主要特色。通过内、外缘典型矿床的研究和综合对比 ,认为外缘的富 Sn是与富 Sn的基底有关 ,内缘的富 Mo是与结晶基底地层和岩浆热液关系密切。而内、外缘 Cu、 Pb、 Zn的成矿与中生代构造转折 ,造成大规模陆相火山活动和成矿流体的卸载密切相关     

川滇密西西比河谷型铅锌矿床成矿流体来源研究:流体Na-Cl-Br体系的证据

应用流体包裹体滤液分析方法，测定了川滇7个MVT铅锌矿床成矿流体的Na,Cl,Br含量，结果表明成矿流体的x(Na/Br)和x(Cl/Br)的平均值分别为185和73，并与高度蒸发浓缩的残留海水的x(Na/Br)和x(Cl/Br)相近。成矿流体的Na,Cl含量呈正相关，在lgNa-lgCl图解中呈线性分布。根据这些事实以及矿床地质特征，认为原始成矿卤水起源于蒸发浓缩的残留海水，原始含矿卤水与富含有机质的大气降水混合导致矿质沉淀而成矿。     

The gravity method in groundwater exploration in crystalline rocks: a study in the peninsular granitic region of Hyderabad, India

The application of variations in the earth's gravity in groundwater exploration on a regional scale, especially in sedimentary basins, metamorphic terrains, valley fills, and for buried alluvial channels, is well established. However, its use in hard crystalline rocks is little known. In granite, for example, the upper weathered layer is a potential primary aquifer, and the underlying fractured rock can form a secondary aquifer. Fracturing and weathering increases the porosity of a rock, thereby reducing the bulk density. Changes in gravity anomalies of 0.1–0.7 mGal for granites, due to weathering or variations in lithology, can be detected. To test the use of gravity as a groundwater exploration tool for crystalline rocks, a gravity survey of the peninsular shield granites underlying Osmania University Campus, Hyderabad, India, was undertaken. At the site, gravity anomalies reflect variations in the lithology and in the thickness of weathered zones. These anomalies also define the position of intrusives and lineaments. Areas of more deeply weathered granite that contain wells of higher groundwater yield are represented by negative gravity values. In the weathered zone, well yield has an inverse relation to the magnitudes of residual gravity. The study confirms the feasibility of gravity as a tool for groundwater exploration in crystalline rocks. Electronic Publication     

Origin of Gold—Bearing Fluid and Its Initiative Localization Mechanism in Xiadian Gold Deposit,Shandong Province

The composition of quartz inclusions and trace elements in ore indicate that gold-bearing fluid in the Xiadian gold deposit,Shandong Province,stemmed from both mantle and magma,belonging to a composite origin.Based on theoretical analysis and high temperature and high pressure experimental studies,gold-bearing fluid initiative localization mechanism and the forming environment of ore-host rocks are discussed in the present paper.The composite fluid extracted gold from rocks because of its expanding and injecting forces and injecting forces and flew through ore-conducive structures,leading to the breakup of rocks.The generation of ore-host faults and the precipitation of gold-bearing fluid occurred almost simultaneously.This study provides fur-ther information about the relationships between gold ore veins and basic-ultrabasic vein rocks and intermediate vein rocks,the spatial distribution of gold ore veins and the rules governing the migration of ore fluids.     

Constraints on the application of carbon isotope thermometry in high- to ultrahigh-temperature metamorphic terranes

Nine marble horizons from the granulite facies terrane of southern India were examined in detail for stable carbon and oxygen isotopes in calcite and carbon isotopes in graphite. The marbles in Trivandrum Block show coupled lowering of δ¹³C and δ¹⁸O values in calcite and heterogeneous single crystal δ¹³C values (? 1 to ? 10‰) for graphite indicating varying carbon isotope fractionation between calcite and graphite, despite the granulite facies regional metamorphic conditions. The stable isotope patterns suggest alteration of δ¹³C and δ¹⁸O values in marbles by infiltration of low δ¹³C–δ¹⁸O‐bearing fluids, the extent of alteration being a direct function of the fluid‐rock ratio. The carbon isotope zonation preserved in graphite suggests that the graphite crystals precipitated/recrystallized in the presence of an externally derived CO₂‐rich fluid, and that the infiltration had occurred under high temperature and low f_O2 conditions during metamorphism. The onset of graphite precipitation resulted in a depletion of the carbon isotope values of the remaining fluid+calcite carbon reservoir, following a Rayleigh‐type distillation process within fluid‐rich pockets/pathways in marbles resulting in the observed zonation. The results suggest that calcite–graphite thermometry cannot be applied in marbles that are affected by external carbonic fluid infiltration. However, marble horizons in the Madurai Block, where the effect of fluid infiltration is not detected, record clear imprints of ultrahigh temperature metamorphism (800–1000 °C), with fractionations reaching <2‰. Zonation studies on graphite show a nominal rimward lowering δ¹³C on the order of 1 to 2‰. The zonation carries the imprint of fluid deficient/absent UHT metamorphism. Commonly, calculated core temperatures are > 1000 °C and would be consistent with UHT metamorphism.     

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

Large-scale mass wasting in ancient volcanic materials

Giant landslides are significant hazards associated with many active volcanic edifices. We describe a similar feature on ancient (>4 Ma) volcanic deposits subject to active tectonism. The landslide is approximately 3 km long by 1 km wide, with an estimated depth of 400 m. Side margins are straight and parallel, mimicking regional structure; narrow valleys incised down these margins provide low-strength side-release surfaces. Between these is a giant slump consisting of at least four, largely intact, discrete blocks that have moved down-dip a distance of >500 m. A series of flows with areal extents ranging from 0.01 to 0.5 km² extends from the front of the failure. The materials represent an eroded sequence of andesite flows on the flanks of a stratovolcano. These have undergone two phases of hydrothermal alteration, and are deeply weathered to low-density (1040±80 kg m⁻³) silt (59%) and clay (35%) materials with strength properties typical of weathered silts (c=26±3 kN m⁻²; φ=42±8°). The size and location of this landslide preclude detailed geotechnical investigation of the failure. The worth of numerical stability analysis as an alternative technique in assessing the nature of the failure and hence the risk it poses to nearby communities is investigated. Sensitivity analysis identified likely conditions under which initial failure may have occurred: analyses for sensitivity to strength and earthquake acceleration needed conversion to critical combinations (F=1.0) of water table and strength/acceleration to remove the overriding influence of water table fluctuations. Failure was likely initiated either by a high water table level (83-84%), or some combination of intensity VII-IX earthquake waves together with water table heights of 40-80%. A general hazard assessment indicates that the risk associated with creep and catastrophic failure of the main mass is small, whereas the risk from flow failures near the toe of the landslide may be high. Important parameters (hydrological regime, flow failure morphology, age of initiation, and rates of movement) requiring closer investigation are identified. Development of a model is crucial to assessing the hazard associated with a feature such as that described here. With limited resources, a detailed stability analysis is a powerful tool as an initial stage in hazard analysis.     

Caractérisation des paragenèses et des paléocirculations fluides dans l'indice d'or de Bleı̈da (Anti-Atlas,Maroc)Characterization of the paragenesis and the fluid palaeo-circulations in the gold showings of Bleida (Anti-Atlas,Morocco)

The gold showings at Bleida are hosted in Late Pan-African N50–80 °E quartz–hematite–chlorite 1 tension lenses that are related to the activity of major sinistral sub-east–west thrusts. Ores result from three superimposed stages of fluid migration. Gold occurs in microcracks offsetting the earlier minerals. Fluids evolved from COHN compositions with a saline component to boiling aqueous fluids. Pressure and temperature decreased from 50 MPa and 300 °C to less than 4 MPa and 150 °C. Thus, the gold showings at Bleida were formed in a typical geothermal (epithermal) setting, likely controlled by the Late Pan-African magmatism. To cite this article: A. Barakat et al., C. R. Geoscience 334 (2002) 35–41     

饱和岩石的各向异性及非线性黏弹性响应

在MTS伺服压机上对不同饱和状态的砂岩、大理岩标本进行了垂直层理和平行层理两个方向的正弦波加载试验,研究了饱和岩石的各向异性及非线性黏弹性行为. 在最大载荷低于岩石的屈服点时,获得的衰减、杨氏模量、泊松比、波速都表现出显著的各向异性,同时它们还具有较明显的应变振幅效应和频率效应. 随着应变振幅的增大,衰减近似呈线性增长,杨氏模量和泊松比近似呈线性下降. 在0.005-4Hz频段内除衰减不明显依赖频率以外,杨氏模量、泊松比、波速对频率的依赖性都较强; 当频段扩大到15Hz时,这4个参数都表现出较强的频率效应. 饱和岩石的衰减、杨氏模量、泊松比、波速均随饱和液体的黏滞系数增大而增大.