1970-2019年黄浦江上游年最高潮位变化及驱动因子

黄浦江年最高潮位变化关系到上海市的防洪安全,本文基于米市渡站1970－2019年年最高潮位、太湖流域降水量等数据,研究了近50 年来黄浦江上游年最高潮位的变化趋势和变异特性、发生频率变化以及潮位变化的驱动因子。结果表明：年最高潮位在1970－2019年总体呈显著上升趋势,上升幅度为81 cm,年均上升1.62 cm。1995年之后出现跳跃式的波动上升,1996－2002年相对1995年之前较大幅度上升,2003－2011年相比1996－2002年出现较明显下降,之后又较大幅度上升。随着潮位升高,各频率对应的最高潮位均较大幅度增加,升高幅度均达0.9 m以上,五十年一遇、百年一遇、千年一遇高潮位分别由1970年条件下的3.77 m、3.81 m、3.94 m升高到2019年条件下的4.71 m、4.75 m、4.92 m。与此同时,相同潮位下的重现期急剧减小,高潮位发生频率大幅度增加。分析认为,年最高潮位升高受气候变化和人类活动的综合影响,1970－1995年主要受降水量变化等气候因素的影响,1996－2019年主要受水利工程、台风频率增加等因素的影响,尤其是太湖流域太浦河等工程的修建起重要作用。     

清洗频率对固定床生物滤器水处理性能的影响

本实验基于一种新型的具有自洁功能的固定床生物滤器, 研究了不同的清洗频率: 0.5次/d (S1)、1次/d(S2)和2次/d(S3)对生物滤器的硝化性能、截污能力和硝酸盐氮积累的影响。研究表明: 清洗频率对生物滤器去除氨氮(NH₄⁺-N)没有显著影响(P > 0.05); 在第6~9 d对生物滤器内亚硝酸盐氮(NO₂^–-N)的浓度有显著影响(P < 0.05), 第11 d后均无显著影响(P > 0.05); 在整个实验过程中, S3处理组与S1、S2处理组相比总固体悬浮物(TSS)去除分别提高53.52%和19.01%, 化学需氧量(COD_Mn)去除分别提高57.94%和27.01%, 差异性显著(P < 0.05); 在硝酸盐氮(NO₃^–-N)积累方面, S3处理组积累最少, 在整个实验过程期间与S1、S2处理组相比分别降低16.04%和23.01%, 差异性显著(P < 0.05)。总体来说, 高清洗频率对生物滤器的硝化性能无显著影响, 但能使生物滤器截留的TSS快速排出系统, 从而减少系统内的水处理负荷和硝酸盐氮积累, 有利于系统的长期稳定运行。     

印度尼西亚海及周边海域层结的时空变化特征分析

本文利用World Ocean Atlas 2013 (WOA13)和Simple Ocean Data Assimilation version 3.1.1 (SODA v3.3.1)温盐资料,分析印尼贯穿流(ITF)路径及所经印度尼西亚海及周边西太平洋、南海和东印度洋海域的层结强度(N²)和跃层特征的三维时空变化特征。结果表明,气候态下ITF 3条路径上跃层平均N²差异较小,其中中部路径平均值最大,为10^−3.68 s⁻²,东部路径平均值最小,为10^−3.71 s⁻²;各路径跃层深度和厚度存在明显差异,东部路径跃层深度和厚度最大,分别为124 m和192 m,中部次之,西部最小为99 m和143 m,并且印尼海的跃层深度和厚度平均值均小于其他海域。印尼海N²存在显著的季节变化和4～7 a的多年周期变化,其中年际变化可能主要受厄尔尼诺−南方涛动事件影响。季节上,在印尼海域内,ITF 3条路径夏季层结强度均小于冬季(北半球夏冬季),夏、冬两季N²差值最大可达到两个量级。1993−2015年的长期变化趋势显示,印尼海及周边大部分海域的层结强度呈现增强趋势,其中印度洋中部和哈马黑拉海23 a内最大层结增强近0.1个量级。     

Dynamical features of near-inertial motions in global ocean based on the GDP dataset from 2000 to 2019

Based on the latest oceanic surface drifter dataset from the global drifter program during 2000–2019, this study investigated the global variation of relative frequency shift(RFS), near-inertial energy(NIE) and inverse excess bandwidth(IEB) of near-inertial motions, and analyzed their relations with oceanic mesoscale dynamics, relative vorticity and strain. Compared with previous works, we have some new findings in this study:(1) the RFS was high with negative values in some regions in which we found a significant blue shift of the RFS in the equatorward of 30°N(S) and from 50°N to 60°N in the Pacific, and a red shift in the western boundary currents and their extension regions, the North Atlantic and the Antarctic Circumpolar Current regions;(2) more peak values of the NIE were found in global regions like the South Indian Ocean, the Luzon Strait and some areas of the South Ocean;(3) the global distribution of the IEB were characterized by clear zonal bands and affected by vorticity and wind field;(4)the RFS was elevated as the absolute value of the gradient of vorticity increased, the IEB did not depend on the gradient of vorticity, and the eddy kinetic energy(EKE) weakened with the decrease of the absolute value of RFS;(5) the NIE decreased with increasing absolute value of the relative vorticity and the gradient of vorticity, but it increased with increasing strain and EKE when EKE was larger than 0.003 2 m~2/s~2.     

海底沉积物的基本地声结构与地声模型

为准确建立海底地声模型,本文探讨地声模型的基本组成和基本结构。通过样品实验室测量,分析南海海底表层沉积物的密度、孔隙度与声速随着埋深变化的关系,得出海底实际存在的低声速表面–声速缓慢变化类型、低声速表面–声速增大类型、高声速表面–声速缓慢变化类型和高声速表面–声速增大类型4种典型地声结构;对比钻探测量,分析黄海海底沉积物的密度、孔隙度与声速随埋深变化关系,得出海底地声模型分层特征与地声结构组合特征。研究表明,地声模型可以归结为4种基本地声结构的组合,通过与底层海水声速、同层内声速剖面以及与上层海底沉积物下表面声速的比较,可以建立各种海底地声模型;基于实验室测量法建立的地声模型可以作为参考地声模型,但需要考虑实际海底温度和压力梯度以及海底沉积物的频散特性等,借助于声速比校正法和频散性理论模型进行计算及修正。     

Study on General Performance of Jack-up Under Elevated Condition

Method of checking for jack-up elevated performance including leg structure strength, fixation system or jacking system bearing capacity, pre-load requirements, spud can bearing capacity and overturning stability is suggested in this paper. As an example, a jack-up with truss legs is analyzed by finite element analysis method. This paper may be helpful to the rig owners, operators and designers.     

Stable 85Rb micro vapour cells: fabrication based on anodic bonding and application in chip-scale atomic clocks

We describe the microfabrication of ⁸⁵Rb vapour cells using a glass-silicon anodic bonding technique and in situ chemical reaction between rubidium chloride and barium azide to produce Rb. Under controlled conditions, the pure metallic Rb drops and buffer gases were obtained in the cells with a few mm³ internal volumes during the cell sealing process. At an ambient temperature of 90 ℃ the optical absorption resonance of ⁸⁵Rb D1 transition with proper broadening and the corresponding coherent population trapping (CPT) resonance, with a signal contrast of 1.5% and linewidth of about 1.7 kHz, have been detected. The sealing quality and the stability of the cells have also been demonstrated experimentally by using the helium leaking detection and the after-9-month optoelectronics measurement which shows a similar CPT signal as its original status. In addition, the physics package of chip-scale atomic clock (CSAC) based on the cell was realized. The measured frequency stability of the physics package can reach to 2.1×10^-10 at one second when the cell was heated to 100 ℃ which proved that the cell has the quality to be used in portable and battery-operated devices.     

Finite element modeling of heating phenomena of cracks excited by high-intensity ultrasonic pulses

A three-dimensional thermo-mechanical coupled finite element model is built up to simulate the phenomena of dynamical contact and frictional heating of crack faces when the plate containing the crack is excited by high-intensity ultrasonic pulses. In the finite element model, the high-power ultrasonic transducer is modeled by using a piezoelectric thermal-analogy method, and the dynamical interaction between both crack faces is modeled using a contact-impact theory. In the simulations, the frictional heating taking place at the crack faces is quantitatively calculated by using finite element thermal-structural coupling analysis, especially, the influences of acoustic chaos to plate vibration and crack heating are calculated and analysed in detail. Meanwhile, the related ultrasonic infrared images are also obtained experimentally, and the theoretical simulation results are in agreement with that of the experiments. The results show that, by using the theoretical method, a good simulation of dynamic interaction and friction heating process of the crack faces under non-chaotic or chaotic sound excitation can be obtained.     

海水中A3钢样阴极保护电化学场的二维有限元计算

有限元法已被证明是计算阴极保护场中电位、电流密度分布的有效方法。作者建立了二维的有限元数学模型,并讨论了模型中电化学场的非线性边界条件的处理和非线性方程组的迭代法解法。用构建的模型对简单的阴极保护模拟体系进行了分析,得出了较合理的结果。     

分潮波模型多资料数值计算方法研究 Ⅱ.有限差分最小二乘方法

对含多资料的分潮波模型的超定问题进行探讨，建立一种有限差分—最小二乘方法，该方法使得岸边资料直接进入了计算方程，并保证岸界法向流速为零条件。通过对渤海的四大分潮的试算，证实本方法可行。