分潮波模型多资料数值计算方法研究 Ⅱ.有限差分最小二乘方法

对含多资料的分潮波模型的超定问题进行探讨，建立一种有限差分—最小二乘方法，该方法使得岸边资料直接进入了计算方程，并保证岸界法向流速为零条件。通过对渤海的四大分潮的试算，证实本方法可行。     

Shear Failure of a Clamped Dented Tubular Beam Under Lateral Impact

- The shear failure of a rigid-plastic dented clamped tubular beam under the lateral impact of a mass is investigated. Both the denting and the impact point are in the middle span of the beam. It is assumed that denting does not spread during the shear sliding. Numerical results show that the axial force and lateral deflection of the beam are very small at the moment of the occurence of shear failure, which means that the finite deformation effect can be neglected in the shear failure analysis. Also, some aspects of the initial impact energy are investigated.     

Elasto-Plastic Analysis of Tubular Joints of Offshore Platforms by Finite Element Method

The plastic node method is reformulated by the variational principle and is applied to elasto-plastic finite element analysis of tubular joints, eventually including the effect of internal and external gussets, stiffener rings, etc., if necessary. Four different joints are studied here in detail for the elasto-plastic behavior, the strain at the hot spot, the strain concentration factor around the intersection line, and the propagation of the plastic region with loading up to collapse in order to determine the ultimate strength, safety factor, and development of the plastic field. The present results are in good agreement with the experimental results.     

Computation of Viscous Uniform and Shear Flow over A Circular Cylinder by A Finite Element Method

The incompressible viscous uniform and shear flow past a circular cylinder is studied. The two-dimensional Navier-Stokes equations are solved by a finite element method. The governing equations are discretized by a weighted residual method in space. The stable three-step scheme is applied to the momentum equations in the time integration. The numerical model is firstly applied to the computation of the lid-driven cavity flow for its validation. The computed results agree well with the measured data and other numerical results. Then, it is used to simulate the viscous uniform and shear flow over a circular cylinder for Reynolds numbers from lO0 to lO00. The transient time interval before the vortex shedding occurs is shortened considerably by introduction of artificial perturbation. The computed Strouhal number, drag and lift coefficients agree well with the experimental data. The computation shows that the finite element model can be successfully applied to the viscous flow problem.     

桶形基础平台三维有限元稳定性分析

以我国第一座桶形基础采油平台工程实例为原型，采用三维有限元计算方法对桶形基础稳定性分析。平台在波浪、风等荷载作用下，其稳定性不仅与平台的整体结构有关，而且与桶形基础及其周围土体相互作用相关。在计算中，利用薄层摩擦单元模拟土与结构间的相互作用，取得了很好的效果。分析结果表明桶形基础采油平台在设计条件下运行是较为稳定的。     

Numerical simulation of solitary wave scattering by a circular cylinder array

The interaction of a solitary wave with an array of surface-piercing vertical circular cylinders is investigated numerically. The wave motion is modeled by a set of generalized Boussinesq equations. The governing equations are discretized using a finite element method. The numerical model is validated against the experimental data of solitary wave reflection from a vertical wall and solitary wave scattering by a vertical circular cylinder respectively. The predicted wave surface elevation and the wave forces on the cylinder agree well with the experimental data. The numerical model is then employed to study solitary wave scattering by arrays of two circular cylinders and four circular cylinders respectively. The effect of wave direction on the wave forces and the wave runup on the cylinders is quantified.     

The buckling of a corrugated carbon fibre cylinder under external hydrostatic pressure

A theoretical and an experimental investigation was carried out, where a carbon fibre corrugated circular cylinder was tested to destuction under external hydrostatic pressure. The theoretical investigation was via the finite element method, where the structure was modelled with several orthotropic axisymmetric thin-walled shell elements. The experimental observations were aided with strategically placed strain gauges. Comparison between theory and experiment showed that the experimentally observed buckling pressure was a little lower than the theoretical prediction. This may have been due to the fact that the model had slight initial geometrical imperfections in the circumferenential direction.     

鲁苏榴辉岩的地球化学

以微量元素、稀土元素、Ｓｒ和Ｎｄ同位素变异特征为依据，确定鲁苏榴辉岩为多成因、多来源和多阶段，指出主要是在印支期扬子陆块与华北陆块碰撞造山作用过程中，挤入的上地幔碎片以及不同原岩类型的壳内高压变质岩碎块。燕山晚期的区域构造热事件使得某些榴辉岩的同位素体系再平衡。     

Geochemistry and environment evolution of Core E in the Laizhou Bay since last stage of Middle Pleistocene

IwrincrIONOn the evolution of palcoenvironment, salt-water encroachmnt and the distributionof subsurface brine in the LaizhOu Bay area, many researches had been carried out, and muchknowledge abeut the gcolOgical features in this area since Late QUaternary was aCquired' ) (H8nand Wu, l992; Han and Meng, l994; Wen et al. l989). However there was IittIe studyon the sediment geOChemical characteristics since Quaternary. In this Paper, the element strati-graphic characteristics and evolut…