硬质合金复合片齿钎具

运用力学原理研制成功了复合片齿钎头和复合片齿整钎，并批量投入市场。该系列钎具凿岩速度、寿命和硬质合金片齿有效利用率均显著优于片状和球齿钎具。     

甘肃桦树沟(铁)铜矿床的成因机制

矿床地质地球化学特征研究结果表明，随着古陆边缘弧－槽－盆体系的发生与发展，元古代基底火山（沉积）岩系经深循环水（海水）－热系统的作用，成矿物质被浸出和搬运，并经海底喷溢作用沉淀于海盆洼地中形成桦树沟矿床含铜建造，后期变质作用使成矿物质活化、转移和富集。桦树沟矿床为喷气（流）沉积－变质改造型（铁）铜矿床。     

The law of dislocation between two sides of active faults in China and their geodynamic force

By contrasting and analyzing the characteristics of gravity field nearby some important active faults in the continent of China, it can be found that the crust blocks where Bouguer anomalies are regionally positive (or relatively positive) are moving towards the terrestrial poles and the blocks where Bouguer anomalies in a tremendous area are negative (or relatively negative) are moving towards the equator. By analysis of mechanics and mathematics calculation and based on lots of practical data, the authors hold that the change in density of a crust block is a decisive factor that causes the horizontal movement of the continental crust, while magma activity is an important factor that leads to the change in density of a crust block.     

Interpretation of S-wave data from Tai’an-Xinzhou DSS profile and its relationship with Xingtai earthquakes

On the basis of S wave information from Tai’an-Xinzhou DSS profile and with reference to the results from P-wave interpretation, the 2-D structures, including S-wave velocity V _s, ratio γ between V _p and V _s; and Poisson’ s ratio σ, are calculated; the structural configuration of the profile is presented and the relevant inferences are drawn from the above results. Upwarping mantle districts (V _s≈4.30 km/s) and sloping mantle districts (V _s≈4.50 km/s) of the profile with velocity difference about −4% at the top of upper mantle are divided according to the differences of V _s, γ and σ in different media and structures, also with reference to the information of their neighbouring regions; the existence of Niujiaqiao-Dongwang high-angle ultra-crustal fault zone is reaffirmed; the properties of low and high velocity blocks (zones) including the crust-mantle transitionalzone and the boudary indicators of North China rift valley are discussed. A comprehensive study is conducted on the relation of the interpretation results with earthquakes. It is concluded that the mantle upwarps, thermal material upwells through the high-angle fault, the primary hypocenter was located at the crust-mantle juncture 30.0∼33.0 km deep, and additional stress excited the M _S=6.8 and M _S=7.2 earthquakes at specific locations around 9.0 km below Niujiaqiao-Dongwang, the earthquakes took place around the high-angle ultra-crustal fault and centered in the brittle media and rock strata with low γ and low σ values. This subject is part of the 85-907-02 key project during the “8th Five-Year Plan” from the State Science and Technology Commission.     

1995年永登5.8级地震多种前兆异常特征

研究了１９９５年７月２２日甘肃永登５．８级地震地电、水化学、水动态、地应力、地形变等５种前兆的异常特征，得到如下结论：①该次地震中短期（１年尺度）和短临异常空间分布符合“异常震源地点发震机制主要活断层”之间的特定关系，近２～３年的中期异常集中分布在西秦岭北缘北西向断裂带和海原通渭武都南北向断裂带上；②震前约１年时间尺度震源区发育起来了北北西南南东向挤压变化突出的附加应力场，并引起断层错动；③源兆集中分布在本次地震震源周围，场兆集中分布在上述两条活动断裂带上．源兆占异常的大多数，场兆占少数．在时间上场兆出现在先，源兆在后．     

造山带岩浆活动与构造运动关系研究综述

熔体及其活动在造山带的演化中发挥了重要作用。熔体活动发迹了地壳应力作用方式而诱发形成剪切带或断层；熔体活动调整块体间的位移而影响造山带的变形；     

米山断裂构造变形特征及其意义

米山断裂是一多期变形断裂，早期以韧性变形为主，后期以脆性变形为主，断裂变形具有准对称性，西盘变形强度大于东盘。变形强度决定了断裂带的蚀变及矿化特点，蚀变的分带结构与断裂的不同矿化特征都与断裂的变形有关，因此米山断裂的生成与发展，对胶东东部的成岩成矿具有重要作用，它控制了燕山早期花岗岩的侵入，韧性变形作用是金矿成矿的必要条件。     

闽西北常口—南舟断裂带与萤石成矿关系

福建省区域地质调查队三分队在元坑幅及埔上幅１：５万区调中分别发现了将乐常口大型萤石矿和顺昌南舟萤石矿。两个矿床均位于常口－南舟北东向断裂带中，受其次级张性断裂直接控制，矿床成因类似。     

小秦岭东闯金矿区花岗岩浆活动的性质

东闯金矿区中生开岩交活动的特征是小秦岭地区这一时期岩浆活动的缩影。从钾长花岗岩墙－文峪第一次侵入体－文峪第二次侵入体，岩石向相对基性度增高方向变化，可能暗示区域岩石圈的热－物质调整从印支期至燕山早期持续增强。