长江河口潮波传播机制及阈值效应分析

河口潮波传播过程受沿程地形(如河宽辐聚、水深变化)及上游径流等诸多因素影响,时空变化复杂。径潮动力非线性相互作用研究有利于揭示河口潮波传播的动力学机制,对河口区水资源高效开发利用具有重要指导意义。本文基于2007—2009年长江河口沿程天生港、江阴、镇江、南京、马鞍山、芜湖的逐日高、低潮位数据及大通站日均流量数据,统计分析不同河段潮波衰减率与余水位坡度随流量的变化特征,结果表明潮波衰减率绝对值与余水位坡度随流量增大并不是单调递增,而是存在一个阈值流量和区域,对应潮波衰减效应的极大值。为揭示这一阈值现象,采用一维水动力解析模型对研究河段的潮波传播过程进行模拟。结果表明,潮波传播的阈值现象主要是由于洪季上游回水作用随流量加强,余水位及水深增大,导致河口辐聚程度减小,而余水位坡度为适应河口形状变化亦有所减小,从而形成相对应的阈值流量和区域。     

非线性波消波及波场分布研究

本文基于雷诺平均N-S方程,并结合RNG k-e方程建立了粘性数值波浪水槽,对不同波陡、不同相对水深、不同相对波高的非线性规则波的阻尼消波问题和波场分布进行研究。文中提出了两种描述消波区内部阻尼变化的阻尼函数,分别适用于小波陡情形和高波陡情形。研究结果表明,小波陡组消波区可设为一个波长,阻尼系数取10~4～10~5即可满足消波要求,计算结果与实验结果及造波理论吻合良好;高波陡组消波区可设为两个波长,阻尼系数取10~4～10~5亦可满足消波要求,计算结果与实验结果吻合良好。此外,当波陡较小时,波场内反射情况的小幅改变即可对整个波场造成影响,特别是当水深较浅时这种影响极为明显,需谨慎考虑。当波陡较大时,水波能量较高,整个波场沿水波传播方向可观测到明显的衰减现象,在具体试验中需进行考虑。     

Numerical modeling investigation on turbulent oscillatory flow over a plane rough bed composed by randomly arrayed particles

A three-dimensional numerical model is established to simulate the turbulent oscillatory boundary layer over a fixed and rough bed composed by randomly arrayed solid spheres based on the lattice Boltzmann method and the large eddy simulation model.The equivalent roughness height,the location of the theoretical bed and the time variation of the friction velocity are investigated using the log-fit method.The time series of turbulent intensity and Reynolds stress are also investigated.The equivalent roughness height of cases with Reynolds numbers of 1×10~4–6×10~4 is approximately 2.81 d(grain size).The time variation of the friction velocity in an oscillatory cycle exhibits sinusoidal-like behavior.The friction factor depends on the relative roughness in the rough turbulent regime,and the pattern of solid particles arrayed as the rough bed in the numerical simulations has no obvious effect on the friction factor.     

断层周围的弹塑性区及其地质意义

采用弹塑性有限单元方法 ,通过模拟符合实际状况的逐步加载过程所引起应力场和塑性形变区的研究 ,得出如下结果 :①在塑性或韧性剪切形变情况下 ,断裂或形变带的共轭剪切角往往大于 4 5° ;②在双向挤压应力条件下 ,先存断裂的前缘部位没有拉伸应力存在 ,但可能有伸展形变发生 ;③与最大主压应力夹角为 3 0°～ 90°的断层前缘是偏应力的优势方位 ,容易发生塑性剪切形变 ,特别是夹角为 60°左右的断层是最易发生新的构造活动的断层 ;④多数断层两侧一定范围内以及断层内部是相对的低应力区。这些应力的低值区 ,非常有利于矿液和油气的运移、聚集和成藏。     

岩体裂隙等效水力隙宽的统计确定方法

针对天然裂隙岩体等效水力隙宽确定的复杂性,利用平行板水流的立方定律及流量等效原理,推导出光滑平行板单裂隙的等效水力隙宽公式,同时对隙宽分布的频率特性进行了探讨,认为非均匀隙宽单裂隙的等效水力隙宽可近似取40%频率的隙宽,或取隙宽的几何平均值与调和平均值的算术平均值.     

桩基承载力自平衡试验方法在昆明地区的应用研究

概述了自平衡法的基本原理,对云南某化工有限公司5×105t/a合成氨煤气化装置中的三根试桩采用自平衡新方法进行了桩基承载力测试,对测试数据进行了整理和分析。应用结果表明,测试取得较好的工程效果。     

Loss of energy dissipation capacity from the deadzone in linear and nonlinear viscous damping devices

In a viscous damping device under cyclic loading, after the piston reaches a peak stroke, the reserve movement that follows may sometimes experience a short period of delayed or significantly reduced device force output. A similar delay or reduced device force output may also occur at the damper’s initial stroke as it moves away from its neutral position. This phenomenon is referred to as the effect of “deadzone”. The deadzone can cause a loss of energy dissipation capacity and less efficient vibration control. It is prominent in small amplitude vibrations. Although there are many potential causes of deadzone such as environmental factors, construction, material aging, and manufacture quality, in this paper, its general effect in linear and nonlinear viscous damping devices is analyzed. Based on classical dynamics and damping theory, a simple model is developed to capture the effect of deadzone in terms of the loss of energy dissipation capacity. The model provides several methods to estimate the loss of energy dissipation within the deadzone in linear and sublinear viscous fluid dampers. An empirical equation of loss of energy dissipation capacity versus deadzone size is formulated, and the equivalent reduction of effective damping in SDOF systems has been obtained. A laboratory experimental evaluation is carried out to verify the effect of deadzone and its numerical approximation. Based on the analysis, a modification is suggested to the corresponding formulas in FEMA 356 for calculation of equivalent damping if a deadzone is to be considered.     

Estimation of peak relative velocity and peak absolute acceleration of linear SDOF systems

In the seismic analysis and design of structures, the true velocity and absolute acceleration are usually approximated by their corresponding pseudo-values. This approach is simple and works well for structures with small damping (say, less than 15%). When the damping of a structure is enhanced for the purpose of response reduction, it may result in large analysis and design errors. Based on theory of random vibration and the established mechanism of seismic response spectra analysis, a method is developed (1) to predict the relative velocity spectra with any damping ratio level directly from the 5% standard pseudo-acceleration spectrum; and (2) to estimate the peak absolute acceleration. The accuracy of both is validated by using two selected ensembles of ground motion records.     

Pushover analysis procedure for systems considering SSI effects based on capacity spectrum method

This paper presents a new procedure to transform an SSI system into an equivalent SDOF system using twice equivalence. A pushover analysis procedure based on the capacity spectrum method for buildings with SSI effects （PASSI） is then established based on the equivalent SDOF system, and the modified response spectrum and equivalent capacity spectrum are obtained. Furthermore, the approximate formulas to obtain the dynamic stiffness of foundations are suggested. Three steel buildings with different story heights （3, 9 and 20） including SSI effects are analyzed under two far-field and two near-field historical records and an artificial seismic time history using the two PASSI procedures and the nonlinear response history analysis （NLhRHA） method. The results are compared and discussed. Finally, combined with seismic design response spectrum, the nonlinear seismic response of a 9-story building with SSI effects is analyzed using the PASSI procedures, and its seismic performance is evaluated according to the Chinese ＇Code for Seismic Design of Buildings. The feasibility of the proposed procedure is verified.     

主动变刚度-阻尼系统预测最优控制的理论与试验研究

介绍了一种具有自主知识产权的新型开关控制型半主动控制系统——主动变刚度.阻尼(AVS.D)系统的减振控制机理,建立了AVS.D结构振动控制体系的运动方程。为了合理补偿AVS.D系统实时控制过程中不可避免地存在着的控制时滞,本文提出一种预测最优控制算法,推导了其开关控制律。为了检验AVS.D系统的减震控制效果及预测最优控制算法的有效性,我们设计研制出AVS.D装置,编制了AVS.D系统预测最优控制的实时控制软件,在某单层钢框架模型上进行了AVS.D系统的模拟地震振动台试验,比较了不同控制方式时的减震效果。研究结果表明,本文所提出的预测最优控制算法是非常有效的,可推广应用于所有开关控制型半主动控制系统。AVS.D系统具有反应放大功能,经济可靠、安全有效,可望有较好的工程应用前景。