等离子体发射光谱法分析毒砂单矿物

研究了大孔膦酸树脂对毒砂中主、次和痕量元素的吸附行为及洗脱条件,结合巯基棉和TBP柱分离技术,建立了两个分离流程。在J-A1160型多道直读光谱仪上实现了毒砂单矿物中包括主量元素Fe和As在内的20个元素测定。主量元素As和Fe的相对标准偏差(n为5～10)分别为1.03％和0.9％,其它元素在5％～11％范围。流程经实际试样分析验证,结果与化学法相符。     

化学注浆治理巨厚表土层立井井壁漏水

煤矿立井由于各种原因经常发生井壁渗漏水,严重影响正常的煤矿安全生产。邱集煤矿副立井表土层厚320m,为巨厚表土层,发生渗水后,采用改性脲醛树脂浆材成功进行了破壁注浆处理,将井筒的涌水量由10m3/h降至0.3m3/h左右。同时,注浆时浆液形成的帷幕能达到加固地层,减少地层压缩沉降量,排除生产安全隐患,保护井桶的作用。     

GDX-502树脂富集高效液相色谱法测定地表水中酚类化合物

采用自制GDX-502固相萃取小柱萃取水中苯酚、对硝基酚、间甲酚、2，4-二氯酚、2，4，6-三氯酚、五氯酚等6种酚类化合物，以乙腈作为洗脱剂，选择280nm和290nm双波长紫外高效液相色谱进行检测。结果表明，方法检出限为0．01-0．05mg／L，IL水的平均加标回收率为82．5％-95．0％，精密度（RSD，n=7）为3．6％-9．2％。方法用于实际地表水中痕量酚类化合物的检测，操作简单，有机溶剂用量少，分析效率高；萃取小柱可多次重复使用，分析成本低。     

P－350浸渍树脂分离富集Ag，Cd体系及其应用

以Ｐ－３５０吸附于ＤＡ＿（２０１）树脂上，制得了Ｐ－３５０浸渍树脂，通过柱层析法，试验了树脂吸附和解脱Ａｇ，Ｃｄ的条件和干扰离子的影响。建立了Ｐ－３５０浸渍树脂分离－富集Ａｇ，Ｃｄ体系，并应用于岩石样品分析中，效果较好。     

UTEVA树脂分离纯化珊瑚中铀、钍的改进研究

珊瑚是记录海洋环境变化信息的载体之一,测定其U/Ca比值可重建海水温度或测定Th/U同位素比值可计算年龄重建海平面高度等.准确测定珊瑚中U、Th含量及同位素比值是提取所记载的海洋环境变化信息的前提,其难点在于高Ca基体分离和痕量U、Th富集纯化.基于此,本研究拟采用UTEVA树脂改进了一步富集分离珊瑚中U、Th的前处理...     

粘土-有机树脂超吸水复合材料的制备及性能研究

超吸水材料是一种吸水能力特别强的物质,能够吸收自身重量的几十倍甚至几千倍的水;吸水后,在加压的情况下也不脱水或脱水很少。因此,又称它为高保水材料。由于它既具有独特的吸水和保水性能,又具备高分子材料的优点,从而在国民经济众多领域中获得了广泛的应用［１～３］,从１９６１年美国将其开发应用［３］至今,一直保持着良好的发展势头。本文制备了粘土淀粉接枝丙烯酰胺超吸水复合材料。通过Ｃｅ４＋引发,使淀粉、粘土接枝丙烯酰胺;以Ｎ,Ｎ’亚甲基双丙烯酰胺作为交联剂使接枝物适度交联;交联产物经水解、洗涤、脱水、干…     

Chemical Procedures for Rhenium Extraction from Geological Samples: Optimising the Anion Resin Bead Clean‐up Step

Rhenium–osmium geochronometry for samples with low Re and complex matrices requires improved Re extraction methods. Here, we investigate plausible controls on efficiency and efficacy of Re extraction during our anion resin bead purification. Four different protocols are compared, each isolating a single variable to test. Rhenium concentrations for solutions at each step of each protocol document differences in chemical recovery/yield. The negative‐thermal ionisation mass spectrometry (N‐TIMS) signal intensity serves as a proxy for Re yield and purity. These data document correlations between the N‐TIMS signal intensity and (a) the duration of anion resin bead conditioning prior to loading with Re‐bearing solution, and (b) both duration and strength of nitric acid used during rinsing of the Re‐loaded anion resin bead. The optimal protocol improved Re signal intensity around fourteen times compared with our current Re extraction protocol, an aggregate of 2.4 times improvement in chemical recovery (yield) and 5.8 times improvement in emission efficiency (purity). Repeated N‐TIMS isotopic measurements on our in‐house Re standard solution (1407) verify that our optimal protocol‐3 does not fractionate Re isotopes. The improved anion resin bead method considerably lowers the Re detection limit and allows Re‐Os isotopic analysis of picogram‐level Re hosted in geological samples with complex matrices.     

离子交换法制取无水氯酸锂

以732凝胶型强酸性阳离子交换树脂,采用两种工艺方案进行了离子交换法制取无水氯酸锂小型实验研究。在小型实验的基础上,推荐了用离子交换法制得氯酸,然后再中和、脱水制取无水氯酸锂的工艺。在推荐的工艺下,进行了扩大试验,制得了主含量为99%,杂质及水分符合国外用户标准的无水氯酸锂产品。     

Testing dendrogeomorphic approaches and thresholds to reconstruct snow avalanche activity in the Făgăraş Mountains (Romanian Carpathians)

Snow avalanches are a widespread natural phenomenon in steep mountain environments, where they modulate landscapes and frequently disturb forest stands. Such disturbances in trees have been used since the 1970s to retrospectively date avalanches, study their extent and reach, as well as to document their triggers. Although virtually every dendrogeomorphic paper is still based on the concepts established by Shroder (1978), important methodological improvements have been achieved in the field ever since and more particularly over the last decade. This study therefore reports on recent methodological progress and employs three different approaches (i.e. Shroder index value and Kogelnig-Mayer weighted index value) and different sets of signals in trees (i.e. inclusion of tangential rows of traumatic resin ducts as evidence of past avalanching) to record snow avalanche activity. Using 238 increment cores from 105 Picea abies (L.) Karst trees which colonize a snow avalanche path in the Romanian Carpathians, we illustrate possibilities and limitations of the different approaches for the period covered by the chronologies (1852–2013). In addition, we sampled 30 undisturbed P. abies trees from a forest stand north of the avalanche path, where no geomorphic disturbance was identified, so as to build a reference tree-ring chronology. The three avalanche chronologies constructed with the disturbed trees allow identification of past process activity, but results differ quite considerably in terms of avalanche frequency, number of reconstructed events and their temporal distribution. Depending on the approach used, 15 to 20 snow avalanches can be reconstructed, with the best results being obtained in the dataset including tangential rows of traumatic resin ducts. The addition of this anatomical feature, formed after mechanical impact enlarges the number of growth disturbances by 43.5%, and can thus explain the increase of reconstructed avalanches by one-third as compared to the results of the chronology using the “conventional” Shroder approach.