昆明南市区地下热水环境质量评价

昆明市地热田的开发利用已有20多年历史，部分地段长期过量开采诱发的环境地质问题日趋突出。本文用TOPSIS法和综合指数法对昆明市南市区近l0年来地下热水水质演变过程及现状作分析评价，研究结果表明昆明市地下热水已遭受到不同程度的污染，并且有恶化的趋势。     

多孔结构矿物（岩石）及其环境修复材料的实用性

具有多孔结构的矿物(岩石)作为一类特殊的工业原材料，在环境修复领域的应用前景正在成为研究热点。本文从微孔的尺度、结构、形态、成分等表面固体特征出发，概括性地论述了凹凸棒石、海泡石、蒙脱石、沸石、硅藻土等十几种多孔结构矿物(岩石)在环境修复工程中用作过滤材料、吸附剂、离子交换剂和催化剂等材料时的基本特征和使用时应注意的问题。     

南京市玄武湖水下交通隧道环境地质评价

玄武湖地下交通隧道既在城市,又在水下,环境地质条件极为复杂,是一种脆弱环境下的典型的地质工程。本文对玄武湖地下交通隧道的环境地质条件特别是水文地质条件进行了评价,预测了可能出现的如水污染、地面沉降、地面塌陷、巷道突水等环境地质问题,并提出了相应的防治对策。     

A critical state interpretation for the cyclic liquefaction resistance of silty sands

Contrary to many laboratory investigations, common empirical correlations from in situ tests consider that the increase in the percentage of fines leads to an increase of the cyclic liquefaction resistance of sands. This paper draws upon the integrated Critical State Soil Mechanics framework in order to study this seemingly not univocal effect. Firstly the effect of fines on the Critical State Line (CSL) is studied through a statistical analysis of a large data set of published monotonic triaxial tests. The results show that increasing the content of non-plastic fines practically leads to a clockwise rotation of the CSL in (e–ln p) space. The implication of this effect on cyclic liquefaction resistance is subsequently evaluated with the aid of a properly calibrated critical state elasto-plastic constitutive model, as well as a large number of published experimental results and in situ empirical correlations. Both sets of data show clearly that a fines content, less than about 30% by weight, may prove beneficial at relatively small effective stresses (p₀<50–70 kPa), such as the in situ stresses prevailing in most liquefaction case studies, and detrimental at larger confining stresses, i.e. the stresses usually considered in laboratory tests. To the extent of these findings, a correction factor is proposed for the practical evaluation of liquefaction resistance in terms of the fines content and the mean effective confining stress.     

地震荷载作用下温度和围压对冻土强度影响的试验研究

通过对重塑冻结兰州黄土的动三轴试验，较系统研究了地震荷载作用下冻土的动强度特性，并且定量研究了其在不同温度(-2℃、-5℃、-7℃)和围压(1MPa、3MPa、5MPa)条件下的变化规律．结果发现：冻结黄土的动抗剪强度随围压的增大、温度的降低、振次的减少而增大；动粘聚力Cd随振次的减小和温度的降低而增大；动内摩擦角吼随振次的增大和温度的降低而增大。     

长江三角洲长江以北地区全新世以来人地关系的环境考古研究

通过长江三角洲长江以北地区高邮龙虬庄和海安青墩两个新石器时代考古遗址剖面粒度、磁化率、孢粉以及年代学测定，较为全面地分析了该区全新世以来生态环境变化与人类文明兴衰的相互关系，研究结果表明：在有人类活动以前，该区距离海洋较远，但受海面变化影响强烈。此后，气候向暖湿方向发展，7000—6000间的大西洋温暖湿润气候以及3700aB．P．左右期间，该区气候适宜，人类文明在这样的适宜气侯条件下得到长足发展。值得注意的是，海安青墩遗址剖面中出现厚达1m多的自然沉积地层，粒度分析以及孢粉分析表明，这一自然沉积地层是4000aB．P．以来的海侵事件所致，正是这次海侵事件，使研究区人类文明得以衰落。     

磷脂脂肪酸在地下水微生物生态学中的应用及存在的若干问题

磷脂脂肪酸(PLFA)是研究地下水微生物生态的一种新兴技术，它比基于培养基的传统方法有许多明显的优势，但同时也存在一些需要解决的问题。样品中的PLFA总量可以通过转换因子估算地下水微生物的生物量，但微生物群落组成的差异和环境的物理变化都是潜在的误差来源，以传统微生物技术互补和选择合适的转换因子可提高结果的可靠性；PLFA还可以被用来指示地下水微生物在各种环境压力下的生理状态；用特定的PLFA生物标志物、PLFA的组成模式、指纹技术来描述地下水微生物的群落结构和变化特征时，存在的主要问题是不同微生物PLFA的重叠、背景值的干扰和环境因子变化的影响，以PLFA技术为主导，借助于数学统计方法，结合传统微生物技术、核酸鉴定、同位素示踪等多种技术可望有效地消除各种干扰因子，从而揭示完整的地下水微生物的生理生态，为地下水污染的生物修复提供理论指导。     

Floodplain Residents' Preferences for Water Level Management Options in Flood Control Projects in Bangladesh

A maximum difference conjoint (MDC) model was part of a questionnaire toassess floodplain residents' preferences for the outcomes of water level managementinside an enclosed embankment system on the left bank of the Dhaleswari River, calledthe Compartmentalization Pilot Project (CPP)-Tangail. The outcomes were described as(a) varied flood depths in the rice field, (b) incidence of flooding on the courtyard andinside homes, (c) changes in floodplain and culture fisheries, and (d) varied conditionsof drainage congestion. Following a standard survey, the respondents from inside andoutside a completed section of the compartment (Cluster 1b) were shown profiles of these flood management outcomes and were asked to indicate for each profile the one most preferred and the one least preferred item. The results of the study indicated that the respondents had a clear preference for preventing flooding of their homes and courtyards and for an ideal water depth of 2 ft in the aman rice fields. At the same time, they also showed a strong concern about malfunctioning of sluices and to a lesser extent about the changes in the fish habitat. The successful application of the MDC as an approach to model tradeoffs among rural residents of Bangladesh shows that a relatively complex quantitative survey method, incorporating choice cards as pictograms, can be applied successfully even in a developing country.     

软粘土层上的油罐差异沉降

根据某一大型油罐软基加固处理工程方案设计和优选需要,按照离心模型相似律,开展了三组模型试验,分别模拟了天然地基、土工合成材料袋装碎石垫层和既在填土层中设置袋装碎石垫层又在淤泥质粘土层设置土工合成材料排水板三种情况,以研究这一加固布置形式对减小高压缩性软土层地基上油罐罐底的差异沉降效果反应。模型油罐地基采用原型土重塑制备,现场土工合成材料袋装碎石采用柔性机织玻璃纤维细管塞装粗砂条模拟,并在不停机运转条件下模拟了多次充放水预压加载。试验结果表明,油罐软弱地基经土工合成材料袋装碎石加固后,罐底总沉降值和差异沉降值均明显小于天然地基情形下对应的沉降值,罐底畸变得到显著减小,就本文所述的土质条件、土层厚度和预压荷载强度,地基经加固处理后,油罐罐底畸变减小了近50 %。最后就土工合成材料在加固油罐地基布置形式的合理性进行了初步探讨。     

Researches on Cartographic Database-Based Interactive Three-Dimensional Topographic Map

With the development of computer graphics, the three-dimensional (3D) visualization brings new technological revolution to the traditional cartography. Therefore, the topographic 3D-map emerges to adapt to this technological revolution, and the applications of topographic 3D-map are spread rapidly to other relevant fields due to its incomparable advantage. The researches on digital map and the construction of map database offer strong technical support and abundant data source for this new technology, so the research and development of topographic 3D-map will receive greater concern. The basic data of the topographic 3D-map are rooted mainly in digital map and its basic model is derived from digital elevation model (DEM) and 3D-models of other DEM-based geographic features. In view of the potential enormous data and the complexity of geographic features, the dynamic representation of geographic information becomes the focus of the research of topographic 3D-map and also the prerequisite condition of 3D query and analysis. In addition to the equipment of hardware that are restraining, to a certain extent, the 3D representation, the data organization structure of geographic information will be the core problem of research on 3D-map. Level of detail (LOD). space partitioning, dynamic object loading (DOL) and object culling are core technologies of the dynamic 3D representation. The objectselection, attribute-query and model-editing are important functions and interaction tools for users with 3D-maps provided by topographic 3D-map system, all of which are based on the data structure of the 3D-model. This paper discusses the basic theories, concepts and cardinal principles of topographic 3I)-map,expounds the basic way to organize the scene hierarchy of topographic 3D-map based on the node mechanism and studies the dynamic representation technologies of topographic 3D-map based on LOD, space partitioning, DOL and object culling. Moreover. such interactive operation functions are explored, in this paper, as spatial query, scene editing and management of topographic 3D-map. Finally, this paper describes briefly the applications of topographic 3D-map in its related fields.