The effective stress concept and the evaluation of changes in pore air pressure under jacketed isotropic compression tests for dry sand based on the 2‐phase porous theory

The effective stress concept for solid‐fluid 2‐phase media was revisited in this work. In particular, the effects of the compressibility of both the pore fluid and the soil particles were studied under 3 different conditions, i.e., undrained, drained, and unjacketed conditions based on a Biot‐type theory for 2‐phase porous media. It was confirmed that Terzaghi effective stress holds at the moment when soil grains are assumed to be incompressible and when the compressibility of the pore fluid is small enough compared to that of the soil skeleton. Then, isotropic compression tests for dry sand under undrained conditions were conducted within the triaxial apparatus in which the changes in the pore air pressure could be measured. The ratio of the increment in the cell pressure to the increment in the pore air pressure, m, corresponds to the inverse of the B value by Bishop and was obtained during the step loading of the cell pressure. In addition, the m values were evaluated by comparing them with theoretically obtained values based on the solid‐fluid 2‐phase mixture theory. The experimental m values were close to the theoretical values, as they were in the range of approximately 40 to 185, depending on the cell pressure. Finally, it was found that the soil material with a highly compressible pore fluid, such as air, must be analyzed with the multi‐phase porous mixture theory. However, Terzaghi effective stress is practically applicable when the compressibilities of both the soil particles and the pore fluid are small enough compared to that of the soil skeleton.     

Watershed structural influences on the distributions of stream network water and solute travel times under baseflow conditions

Watershed structure influences the timing, magnitude, and spatial location of water and solute entry to stream networks. In turn, stream reach transport velocities and stream network geometry (travel distances) further influence the timing of export from watersheds. Here, we examine how watershed and stream network organization can affect travel times of water from delivery to the stream network to arrival at the watershed outlet. We analysed watershed structure and network geometry and quantified the relationship between stream discharge and solute velocity across six study watersheds (11.4 to 62.8 km²) located in the Sawtooth Mountains of central Idaho, USA. Based on these analyses, we developed stream network travel time functions for each watershed. We found that watershed structure, stream network geometry, and the variable magnitude of inputs across the network can have a pronounced affect on water travel distances and velocities within a stream network. Accordingly, a sample taken at the watershed outlet is composed of water and solutes sourced from across the watershed that experienced a range of travel times in the stream network. We suggest that understanding and quantifying stream network travel time distributions are valuable for deconvolving signals observed at watershed outlets into their spatial and temporal sources, and separating terrestrial and in‐channel hydrological, biogeochemical, and ecological influences on in‐stream observations. Copyright © 2016 John Wiley & Sons, Ltd.     

On the dependence of the saturated hydraulic conductivity upon the effective porosity through a power law model at different scales

We study the scale dependence of the saturated hydraulic conductivity K_s through the effective porosity n_e by means of a newly developed power‐law model (PLM) which allows to use simultaneously measurements at different scales. The model is expressed as product between a single PLM (capturing the impact of the dominating scale) and a characteristic function κ^? accounting for the correction because of the other scale(s). The simple (closed form) expression of the κ^?‐function enables one to easily identify the scales which are relevant for K_s. The proposed model is then applied to a set of real data taken at the experimental site of Montalto Uffugo (Italy), and we show that in this case two (i.e. laboratory and field) scales appear to be the main ones. The implications toward an important application (solute transport) in Hydrology are finally discussed. Copyright © 2016 John Wiley & Sons, Ltd.     

A GLUE‐based uncertainty assessment framework for tritium‐inferred transit time estimations under baseflow conditions

The last decade has seen major technical and scientific improvements in the study of water transfer time through catchments. Nevertheless, it has been argued that most of these developments used conservative tracers that may disregard the oldest component of water transfer, which often has transit times greater than 5 years. Indeed, although the analytical reproducibility of tracers limits the detection of the older flow components associated with the most dampened seasonal fluctuations, this is very rarely taken into account in modelling applications. Tritium is the only environmental tracer at hand to investigate transfer times in the 5‐ to 50‐year range in surface waters, as dissolved gases are not suitable due to the degassing process. Water dating with tritium has often been difficult because of the complex history of its atmospheric concentration, but its current stabilization together with recent analytical improvements open promising perspectives. In this context, the innovative contribution of this study lies in the development of a generalized likelihood uncertainty estimation‐based approach for analysing the uncertainties associated with the modelling of transit time due to both parameter identification and tracer analytical precision issues. A coupled resampling procedure allows assessment of the statistical significance of the transfer time differences found in diverse waters. This approach was developed for tritium and the exponential‐piston model but can be implemented for virtually any tracer and model. Stream baseflow, spring and shallow aquifer waters from the Vallcebre research catchments, analysed for tritium in different years with different analytical precisions, were investigated by using this approach and taking into account other sources of uncertainty. The results showed three groups of waters of different mean transit times, with all the stream baseflow and spring waters older than the 5‐year threshold needing tritium. Low sensitivity of the results to the model structure was also demonstrated. Dual solutions were found for the waters sampled in 2013, but these results may be disambiguated when additional analyses will be made in a few years. Copyright © 2016 John Wiley & Sons, Ltd.     

联合GPS和GRACE数据分析陕甘宁地区地表垂直形变

采用甘肃省CORS网和中国大陆构造环境监测网络中共48个台站的GPS观测数据，解算得到观测台站的垂直位移，并与GRACE时变重力场Mascon模型解CSR RL05M数据计算得到的垂直形变进行比较，分析区域地表垂直形变特征。结果表明，研究区内台站垂直形变存在局部特征，甘肃庆阳和平凉地区垂直形变与其他地区存在明显差异，相关系数、均方根减少量和周年信号减少量均高于其他地区；扣除趋势项后，观测台站GPS垂直位移与GRACE垂直形变时间序列相关系数均值为0.72，GPS和GRACE周年信号振幅均值分别为6.00 mm和3.70 mm，周年信号减少量和均方根误差减少量均值分别为0.51和0.29；研究区内GPS垂直位移和GRACE垂直形变时间序列一致性较强，GRACE垂直形变能有效解释50%以上的GPS垂直位移周年信号，GPS垂直位移时间序列包含的非构造形变中平均约29%来源于环境负载变化所引起的负荷形变。     

The exponential decline in saturated hydraulic conductivity with depth: a novel method for exploring its effect on water flow paths and transit time distribution

The strong vertical gradient in soil and subsoil saturated hydraulic conductivity is characteristic feature of the hydrology of catchments. Despite the potential importance of these strong gradients, they have proven difficult to model using robust physically based schemes. This has hampered the testing of hypotheses about the implications of such vertical gradients for subsurface flow paths, residence times and transit time distribution. Here we present a general semi‐analytical solution for the simulation of 2D steady‐state saturated‐unsaturated flow in hillslopes with saturated hydraulic conductivity that declines exponentially with depth. The grid‐free solution satisfies mass balance exactly over the entire saturated and unsaturated zones. The new method provides continuous solutions for head, flow and velocity in both saturated and unsaturated zones without any interpolation process as is common in discrete numerical schemes. This solution efficiently generates flow pathlines and transit time distributions in hillslopes with the assumption of depth‐varying saturated hydraulic conductivity. The model outputs reveal the pronounced effect that changing the strength of the exponential decline in saturated hydraulic conductivity has on the flow pathlines, residence time and transit time distribution. This new steady‐state model may be useful to others for posing hypotheses about how different depth functions for hydraulic conductivity influence catchment hydrological response. Copyright © 2016 John Wiley & Sons, Ltd.     

A smoothed cap model for variably saturated soils and its robust numerical implementation

This paper deals with the numerical implementation of a cap model for unsaturated soils. It provides a brief review of existing cap model approaches, based on which an improved model formulated in terms of generalised effective stress and matric suction is derived and described in detail. Although the proposed model is a multisurface plasticity model, it can efficiently be implemented using only single‐surface projections because of the smoothness of the model, which is obtained by construction. Numerical algorithms are provided for these single‐surface stress projections, using a single‐equation approach whenever possible. The robustness of the utilised single‐equation approaches is enhanced by proposing problem‐fitted start‐up procedures based on investigations of the nonlinear projection equations. A comparison of the model response with extensive material test data is used to validate the model and to demonstrate the robust application of the approach to silty sands and low to medium plasticity clays. Copyright © 2015 John Wiley & Sons, Ltd.     

Improved spatial delineation of streambed properties and water fluxes using distributed temperature sensing

A new method was developed for analysing and delineating streambed water fluxes, flow conditions and hydraulic properties using coiled fibre‐optic distributed temperature sensing or closely spaced discrete temperature sensors. This method allows for a thorough treatment of the spatial information embedded in temperature data by creating a matrix visualization of all possible sensor pairs. Application of the method to a 5‐day field dataset reveals the complexity of shallow streambed thermal regimes. To understand how velocity estimates are affected by violations of assumptions of one‐dimensional, saturated, homogeneous flow and to aid in the interpretation of field observations, the method was also applied to temperature data generated by numerical models of common field conditions: horizontal layering, presence of lateral flow and variable streambed saturation. The results show that each condition creates a distinct signature visible in the triangular matrices. The matrices are used to perform a comparison of the behaviour of one‐dimensional analytical heat‐tracing models. The results show that the amplitude ratio‐based method of velocity calculation leads to the most reliable estimates. The minimum sensor spacing required to obtain reliable velocity estimates with discrete sensors is also investigated using field data. The developed method will aid future heat‐tracing studies by providing a technique for visualizing and comparing results from fibre‐optic distributed temperature sensing installations and testing the robustness of analytical heat‐tracing models. Copyright © 2016 John Wiley & Sons, Ltd.     

Frequency analysis of nonstationary annual maximum flood series using the time‐varying two‐component mixture distributions

The most popular practice for analysing nonstationarity of flood series is to use a fixed single‐type probability distribution incorporated with the time‐varying moments. However, the type of probability distribution could be both complex because of distinct flood populations and time‐varying under changing environments. To allow the investigation of this complex nature, the time‐varying two‐component mixture distributions (TTMD) method is proposed in this study by considering the time variations of not only the moments of its component distributions but also the weighting coefficients. Having identified the existence of mixed flood populations based on circular statistics, the proposed TTMD was applied to model the annual maximum flood series of two stations in the Weihe River basin, with the model parameters calibrated by the meta‐heuristic maximum likelihood method. The performance of TTMD was evaluated by different diagnostic plots and indexes and compared with stationary single‐type distributions, stationary mixture distributions and time‐varying single‐type distributions. The results highlighted the advantages of TTMD with physically‐based covariates for both stations. Besides, the optimal TTMD models were considered to be capable of settling the issue of nonstationarity and capturing the mixed flood populations satisfactorily. Copyright © 2016 John Wiley & Sons, Ltd.