Numerical modeling for analyzing thermal surface anomalies induced by underground coal fires

Coal seams burning underneath the surface are recognized all over the world and have drawn increasing public attention in the past years. Frequently, such fires are analyzed by detecting anomalies like increased exhaust gas concentrations and soil temperatures at the surface. A proper analysis presumes the understanding of involved processes, which determine the spatial distribution and dynamic behavior of the anomalies.In this paper, we explain the relevance of mechanical and energy transport processes with respect to the occurrence of temperature anomalies at the surface. Two approaches are presented, aiming to obtain insight into the underground coal fire situation: In-situ temperature mapping and numerical simulation. In 2000 to 2005, annual temperature mapping in the Wuda (Inner Mongolia, PR China) coal fire area showed that most thermal anomalies on the surface are closely related to fractures, where hot exhaust gases from the coal fire are released. Those fractures develop due to rock mechanical failure after volume reduction in the seams. The measured signals at the surface are therefore strongly affected by mechanical processes.More insight into causes and effects of involved energy transport processes is obtained by numerical simulation of the dynamic behavior of coal fires. Simulations show the inter-relation between release and transport of thermal energy in and around underground coal fires. Our simulation results show a time delay between the coal fire propagation and the observed appearance of the surface temperature signal. Additionally, the overall energy flux away from the burning coal seam into the surrounding bedrock is about 30-times higher than the flux through the surface. This is of particular importance for an estimation of the energy released based on surface temperature measurements. Finally, the simulation results also prove that a fire propagation rate estimated from the interpretation of surface anomalies can differ from the actual rate in the seam.     

流体包裹体成分测定的低温相变和显微拉曼光谱分析技术研究进展

论述了包裹体低温分析技术的原理以及进展。传统的流体包裹体低温分析技术是以显微冷冻测温测定无机盐体系为主,目前已发展到应用低温原位拉曼光谱技术对包裹体中的阳离子和阴离子进行定量-半定量分析。油气包裹体原位低温分析技术也取得了较大的突破,对不同成分油气包裹体低温下的相变过程取得了一定的认识,据此对油气包裹体进行分类,推测其主要成分,为油气包裹体计算提供基础参数。     

藏南白垩系黑-红层沉积岩有机质组成分布特征

对藏南江孜县床得剖面白垩系黑层和红层沉积岩进行的有机地球化学研究表明,黑层有机碳含量高于红层5～10倍,红层和黑层饱和烃主峰碳数分别为nC25和nC23;黑层和红层沉积有机质的母质来源都以水生植物和菌藻类等低等生物为主,陆源有机质的输入非常有限;但饱和烃的分布和主峰碳数的差异可能反映了有机母源物质在种群方面的差异,而这种差异可能主要是水体温度存在差异造成的,即红层发育时期水体温度可能高于黑层沉积时期.而在高温度条件下,水生生物和陆生植物的生长发育受到限制,造成原始有机质产率和有机质沉积保存量低可能是红层沉积岩形成的主要原因.     

Delineation of groundwater protection zones by the backward particle tracking method: theoretical background and GIS-based stochastic analysis

The backward particle tracking method, an effective and powerful tool that can be used to delineate groundwater protection zones, is presented. The theoretical background and insights on the applicability of this method are provided. Moreover, the present work enriches the backward particle tracking method with an uncertainty analysis concerning the porosity values, applying a Monte Carlo (MC) approach, coupled with the use of geographical information systems (GIS). As an application example, a wellfield in the Komotini area, Greece, is investigated. The present study may serve as a potential guideline for wellfield delineation, particularly in areas like Greece where lack of data related to the hydrogeological system is often a problem.     

On CO<Subscript>2</Subscript> fluid flow and heat transfer behavior in the subsurface,following leakage from a geologic storage reservoir

Geologic storage of CO₂ is expected to produce plumes of large areal extent, and some leakage may occur along fractures, fault zones, or improperly plugged pre-existing wellbores. A review of physical and chemical processes accompanying leakage suggests a potential for self-enhancement. The numerical simulations presented here confirm this expectation, but reveal self-limiting features as well. It seems unlikely that CO₂ leakage could trigger a high-energy run-away discharge, a so-called “pneumatic eruption,” but present understanding is insufficient to rule out this possibility. The most promising avenue for increasing understanding of CO₂ leakage behavior is the study of natural analogues.     

Ground motion estimation during the Kashmir earthquake of 8th October 2005

In this article, analytical methods have been used to estimate ground motion during the 8 October 2005, Kashmir earthquake. Peak ground acceleration (PGA) values at several stations in the epicentral region have been estimated by empirical analytical source mechanism models. As an alternate analysis, PGA estimates have also been obtained using the stochastic finite fault seismological model. The estimated PGAs are compared with that obtained from damage values. A PGA contour map in the near-source region is provided. It is found that very near to the epicenter, PGA would have reached more than 1 g. It is demonstrated that empirical analytical models can be effectively used to estimate ground motion due to rupture of active faults.     

陆面过程中稳定水同位素逐日变化的数学模拟——引入稳定同位素效应的CLM实例分析

将稳定同位素效应引入CLM(Community Land Model),并对巴西马瑙斯站在平衡年的稳定水同位素的逐日变化进行模拟和分析.结果表明: 降水、水汽和地表径流中δ18O存在明显的季节变化,并与相应的水量存在显著的负相关关系,但凝结物中δ18O与地面凝结量存在显著的正相关关系,蒸发水汽中δ18O与蒸发量之间无显著的相关关系.受土壤贮水削峰功能的影响,表层土壤和根区水中δ18O的季节变化全无.植被层蒸发水汽中稳定同位素的丰度与大气的干湿程度存在密切联系: 当降水量少时,大气干燥,植被层的蒸发较少,植被蒸发中δ18O较高;当降水量较大时,空气湿润,植被层的蒸发量较大,蒸发中δ18O则较低.植被蒸腾中δ18O的变化与源区水体中δ18O的变化保持一致,尤其是与根区水中的δ18O.由于地下径流直接源自根区水的补充,因此,地下径流中δ18O等于根区水中的δ18O.模拟结果还显示,降水MWL (大气水线)的梯度项和常数项均比全球平均MWL略偏小.尽管主要来自降水的贡献,但地表径流和植被层水体的MWLs与降水MWL存在较大的差异,这一方面与两类水体在蒸发过程中的稳定同位素的富集作用有关,另一方面与CLM模拟的水量有关.大气水汽线与降水的MWL的梯度值相近,说明大气水汽与降水近似处于稳定同位素平衡状态.另外,模拟的地面的凝结线与植被层的凝结线均与全球大气水线相近,且具有非常高相关程度,说明CLM的模拟是合理的.     

旋流除砂机理研究及自动旋流除砂器的开发

旋流除砂技术是利用离心力从泥浆中分离固相成分的技术,可广泛应用在地质钻探、有色、冶金工业及石油天然气工业领域。研制开发的自动旋流除砂器弥补了传统除砂器固相成分分离效果不佳、排砂口易堵的缺陷,显著提高泥浆或矿浆的净化质量与除砂效率,且能自动排堵,降低了除砂工作的时间消耗和成本。     

手掘式顶管在市政排水工程中的应用

从混凝土管材的选定、工作坑的设计及施工、顶管顶进中若干关键问题入手,介绍了手掘式顶管施工技术在成都市中心城水环境综合整治工程G标段管道排水工程中的应用。     

旋挖钻机与转盘钻机组合施工法的应用

对旋挖钻机、转盘钻机各自特点和施工成本进行对比分析,提出组合施工方法设想,并通过工程实例得到成功实践,为以后类似工程提供借鉴。客观地提出了旋挖钻机的使用条件和面临的问题。