Field and Theoretical Analysis on the Response of Destructive Pile Subjected to Tension Load

Most field tests are carried out using working piles for verification purposes in China, and loading tests are terminated before achieving true pile capacity. In this work, two full-scale destructive loading tests on tension piles instrumented with strain gauges were conducted to capture true pile capacity. The load-displacement response, load transfer, and threshold of the pile-soil relative displacement for fully mobilizing skin resistance in the uplift case were discussed. It was found that the shaft resistance degradation is observed to be along the pile depth with a reduction factor of 0.905 to 0.931, and the thresholds of pile-soil relative displacement for fully mobilizing skin resistance of the tension pile in different soils are found to be in the range 0.67% to 1.34% of the pile diameter. Based on the field test results, a simple softening model was proposed to describe the degradation behavior of skin friction along the pile-soil interface. Further study was conducted to assess the influence of the threshold of pile-soil relative displacement for fully mobilizing skin friction and the reduction factor on the skin friction. As to the analysis of the response of single pile subjected to tension load, a highly effective iterative computer program was developed using the proposed skin friction softening model. Comparisons of the load-settlement response for the well-instrumented tests were given to demonstrate the effectiveness and accuracy of the proposed simple method.     

Critical Top Tension for Static Equilibrium Configuration of A Steel Catenary Riser

This paper aims to present the critical top tension for static equilibrium configurations of a steel catenary riser（SCR） by using the finite element method. The critical top tension is the minimum top tension that can maintain the equilibrium of the SCR. If the top tension is smaller than the critical value, the equilibrium of the SCR does not exist. If the top tension is larger than the critical value, there are two possible equilibrium configurations. These two configurations exhibit the nonlinear large displacement. The configuration with the smaller displacement is stable, while the one with larger displacement is unstable. The numerical results show that the increases in the riser＇s vertical distances, horizontal offsets, riser＇s weights, internal flow velocities, and current velocities increase the critical top tensions of the SCR. In addition, the parametric studies are also performed in order to investigate the limit states for the analysis and design of the SCR.     

法向承力锚拖曳安装过程的整体模拟

法向承力锚(Vertically Loaded Plate Anchor,VLA)是一种适用于深水的新型系泊基础,它的拖曳安装过程直接决定了其系泊定位的精度和锚体的最终承载能力。综合考虑VLA锚体、锚泊线和上部船体的运动,建立了一种新的准静力整体分析模型。模型包括不断贯入海床的锚体、锚泊线(土中反悬链段和水中悬链段)和安装船体三部分,针对确定的锚泊线长度,安装船运动张紧锚泊线进行安装的过程,计算了此过程中锚体的运动轨迹、锚泊线形态和作用在船体上的锚泊线张力矢量的变化,重点分析了不同抛链长度和海床土体的参数对安装过程控制的影响,发现链长与水深之比达到5时,接近极限贯入深度。     

Marine reserve establishment and on-going management costs: A case study from New Zealand

While there is considerable international research focused on the conservation outcomes of marine protected areas (MPAs) and marine reserves (MRs) there is little information on the economic cost to establish and manage these protected areas. This study estimated the MR pre-establishment and establishment costs for the Taputeranga Marine Reserve (TMR) in New Zealand (NZ) and determined the annual management costs for this reserve and four further NZ MRs. Finally, the cost to local rock lobster fishers resulting from the displaced fishing effort once the TMR had been established was estimated. This research found that the TMR pre-establishment cost was approximately NZ$508,000, and the establishment process cost was approximately NZ$353,000. The annual management costs across the five reserves ranged between NZ$43,200 and NZ$112,500 between 2008/09 and 2010/11. The annual fishers displacement cost at TMR was approximately NZ$22,000 per annum. This research showed that on a unit area basis, small MRs in NZ are just as expensive to maintain as large MRs. This study also highlighted how volunteer effort helped to considerably reduce the monetary cost of the MR pre-establishment process. This research increases our understanding of establishment and management costs, and supports future planning of MRs both within NZ and internationally.     

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.     

Effect of different registration methods on precision of orientation based on RTK registration/georeferencing mode

Abstract

Compared with traditional methods, the three-dimensional laser-scanning (3D-LS) technique can efficiently acquire many high-quality geometric properties of rock discontinuities. In practice, engineers usually prefer to simplify the processing by using single-station point data and roughly orienting owing to the complexity of registration/georeferencing multi-station point data. However, prior published studies have paid little attention to the accuracy and reliability when determining discontinuity orientations using 3D-LS. We propose a reliable and accurate method with robust on-site applicability. As part of an ongoing effort, we are evaluating the precision of the commonly used coarse registration method and the fine registration method, and promoted the optimized coarse- and fine-registration methods and evaluated their precision. It is found that: (1) the common and the optimized registration method can meet our project’s engineering requirements, and the optimized registration method improved accuracy in the dip direction by approximately 1°; (2) fine registration using an iterative closest point (ICP) algorithm can correct both dip direction and dip angle; and (3) the orientation is of high precision with commonly used coarse and fine registration, whereas the optimization effect to correct the orientation is slightly limited.     

长江口沙波统计特征及输移规律

利用多波束测深系统对长江口南港、北槽、横沙通道和北港水下地貌进行测量,对沙波波高、波长、迎流倾角、背流倾角、水深和沉积物特征进行统计,并根据流速、沉积物粒径及水深估算其潮周期内净位移。结果表明:长江口沙波基本都为大型沙波,且沙波大小与其所在区域沉积物粒径呈正比关系;长江口各个区域沙波的对称性不同,涨、落潮优势流越明显,则沙波对称性越差,净位移越大;沙波对称性能反映此区域水动力强弱及潮周期内沙波净位移大小。     

框架剪力墙结构模态静力非线性抗震分析方法研究

本文在模态pushover分析方法基础上推导建立了模态静力非线性分析方法,对一栋10层框架剪力墙结构进行了静力非线性分析,提出了目标位移求解的等效单自由度体系弹塑性时程分析迭代法,计算结果与相应时程分析结果进行了比较,表明两者吻合较好,验证了本文计算方法的有效性。另外,对同一结构,计算分析了在不同水平荷载模式下的静力非线性分析结果,比较不同荷载模式对计算结果的影响,为静力非线性分析方法的推广使用提供参考。     

既有基坑延深开挖稳定性评价与支护方案确定

以北京市某特殊基坑工程为背景,采用FLAC3D软件,选用Mohr-Coulomb准则,对基坑在现有支护方案条件下进行延深开挖,计算分析桩锚支护体系的变形、受力情况。结果表明,基坑在现有支护方案条件下进行延深开挖将导致护坡桩抗弯性能不足、支护结构水平位移过大、锚固体系失效等问题,要保证基坑延深开挖后的安全稳定,必须对护坡桩增设支点,增加支护力。根据设计变更要求及施工现场实际条件,对多种加固支护方案进行比选,最终选用对护坡桩增设锚索的方案进行延深基坑的预加固。采用数值方法模拟分析上述加固方案后的基坑延深开挖力学行为,预测基坑及支护结构的变形情况,并与现场监测数据进行对比分析。结果表明,基坑延深开挖预加固支护方案合理有效,表明该方法对于类似工程的设计优化及现场施工具有重要的参考意义。     

A note on the useable dynamic range of accelerographs recording translation

Since the late 1970s, the dynamic range and resolution of strong motion digital recorders have leaped from 65 to 135 dB, opening new possibilities for advanced data processing and interpretation. One of these new possibilities is the calculation of permanent displacement of the ground or of structures, associated with faulting or with non-linear response. Proposals on how permanent displacements could be recovered from recorded strong motion have been published since 1976. The analysis in this paper concludes that permanent displacements of the ground and of structures in the near-field can be calculated provided all six components of strong motion (three translations and three rotations) have been recorded, and the records are corrected for transducer rotation, misalignment and cross-axis sensitivity.