太行山东麓北拒马河冲积扇结构探测及地震砂土液化判别

北拒马河冲积扇及邻近地区位于太行山东麓,地表覆盖全新世(Qh)松散砂土与粉土,该区域地下水埋深较浅,潜在地震最大震级达6.5级,在地震作用下存在发生砂土液化危险性.通过野外地质调查、工程地质钻探和高密度电阻率法勘探揭示北拒马河冲积扇地层结构特征.在此基础上,采用原位标准贯入试验和室内动三轴试验评价北拒马河冲积扇饱和砂土...     

Estimating economic losses of midrise reinforced concrete shear wall buildings in sedimentary basins by combining empirical and simulated seismic hazard characterizations

Studies of recorded ground motions and simulations have shown that deep sedimentary basins can greatly increase the intensity of earthquake ground motions within a period range of approximately 1–4 s, but the economic impacts of basin effects are uncertain. This paper estimates key economic indicators of seismic performance, expressed in terms of earthquake‐induced repair costs, using empirical and simulated seismic hazard characterizations that account for the effects of basins. The methodology used is general, but the estimates are made for a series of eight‐ to 24‐story residential reinforced concrete shear wall archetype buildings in Seattle, WA, whose design neglects basin effects. All buildings are designed to comply with code‐minimum requirements (i.e., reference archetypes), as well as a series of design enhancements, which include (a) increasing design forces, (b) decreasing drift limits, and (c) a combination of these strategies. As an additional reference point, a performance‐based design is also assessed. The performance of the archetype buildings is evaluated for the seismic hazard level in Seattle according to the 2018 National Seismic Hazard Model (2018 NSHM), which explicitly considers basin effects. Inclusion of basin effects results in an average threefold increase in annualized losses for all archetypes. Incorporating physics‐based ground motion simulations to represent the large‐magnitude Cascadia subduction interface earthquake contribution to the hazard results in a further increase of 22% relative to the 2018 NSHM. The most effective of the design strategies considered combines a 25% increase in strength with a reduction in drift limits to 1.5%.     

混凝土单桩对瑞利波的阻隔机理试验研究

通过室外试验的方法绘制相对加速度的二维等值线图,并依据桩周土体的振动情况进行区域划分,进一步研究单桩几何尺寸变化时其周围土体振动区域的变化情况。结果表明:单桩桩前、桩两侧存在振动加强区,桩前的振动加强现象更强,以桩角处尤为明显;当桩长与波长的比值在0.109～0.840时,隔振区、反射区的面积增长幅度较大,而绕射区的面积则迅速减小,当比值在0.840～0.962时,隔振区、反射区以及绕射区的面积变化很小,数据趋于缓和;桩径与波长的比值对桩周振动区域的影响较大,随着比值在0.013～0.163之间增大,隔振区与反射区的面积分别增加了0.249 m~2、0.129 m~2,增长的速率均较快,而绕射区的面积以较快的速率降低了0.088 m~2;振源距与波长的比值对隔振区与反射区的面积影响较大,当比值在0.163～0.961时,隔振区与反射区的面积急速下降,当比值在0.961～1.068时,变化趋势趋于缓和,对于绕射区面积,随着比值的增加,绕射区的面积仅仅增加了0.037 m~2。     

A new portable in situ flume for measuring critical shear stress on river beds

A new portable in situ flume(PISF)for measuring critical bed shear stress(CBSS)was developed in this study.The PISF consists of an open bottom sediment erosion chamber and an electrically-driven pump.Unlike most existing in situ flumes with similar designs,the new PISF does not rely on monitoring the flow conditions or particle density in the sediment erosion chamber;instead,it is a pre-calibrated flume.The calibration was performed by first determining CBSS of various selected sediment samples of known particle size and density(using the law of the wall),based on flow velocity-depth profiles measured in a 6 m straight open-channel flume using a Particle Image Velocimetry(PIV)system.These same particles of known CBSS were then used in the new in-situ flume under controlled lab conditions to obtain a series of calibration curves of CBSS vs.pump electrical power.A wide variety of particle types and sizes(simulated sediments)were used in this two-step calibration procedure to widen CBSS measurement range and simulate cohesive force effects.The size of the PISF is much smaller and more practical than other similar devices as lamellar flow conditions are not required and it can be applied to a wide range of sediment types including cohesive sediments.     

CFRP加固一字形竖缝耗能预制剪力墙抗震性能研究

以一字形竖缝耗能预制剪力墙作为研究对象,设计了3个装配式剪力墙试件及1个现浇剪力墙对比试件,进行低周往复荷载试验,并对破坏墙体进行CFRP加固,再次进行拟静力试验。试件变化参数包括轴压比、混凝土强度等级及配筋率,对比分析加固前后试件滞回性能、刚度退化、承载力和耗能能力等性能。试验结果表明,与现浇剪力墙相比,一字形竖缝耗能预制剪力墙工作性能良好,阻尼器屈服耗能提高了试件整体工作性能;CFRP加固可有效抑制墙体斜裂缝的发展,对墙体承载力及耗能能力均有显著改善作用;各试件均满足剪力墙弹塑性层间位移角限值要求,延性较好;试件整体表现出良好的抗震性能。     

金属矿床的同位素直接定年方法

矿床的直接定年就是直接对成矿流体或矿石矿物进行同位素定年 ,这样确定的年龄就直接代表了成矿年龄。目前主要有石英和闪锌矿中流体包裹体的Rb Sr同位素定年、黄铁矿和石英中包裹体的Ar Ar同位素定年、金属硫化物的Rb Sr同位素定年、金属硫化物和氧化物的Sm Nd同位素定年、金属硫化物的Re Os同位素定年 ,以及单个矿石矿物的Pb逐步淋滤法定年     

铧厂沟金矿床区域韧性剪切带特征

首次对铧厂沟金矿床区域韧性剪切带进行了较为系统的研究。根据野外地质调查和室内显微构造分析 ,区内发育一条较大区域韧性剪切带 ,无论沿走向还是顺倾向均呈舒缓波状 ,强变形带和弱变形域呈镶嵌形式。区域韧性剪切带经历了右行—左行—右行多期 (次 )活动 ,剪切方位也多次变化 ;早期形成温度约 5 0 0℃ ,以右行剪切为主 ,古应力值大于 0 .0 75GPa。控矿韧脆性剪切带是区域韧性剪切带演化的产物 ,最终形成脆性断裂。区域韧性剪切作用控制矿床、矿带的分布 ,并使部分金从矿源层分溢出来 ,产生第一阶段金的富集。次级韧脆性剪切带 (控矿剪切带 )控制富矿体的分布。因此 ,铧厂沟金矿床可称为韧性剪切带型金矿床。另外 ,中 -下泥盆统三河口群第一岩段第一岩层 (D1 -2 SH1a)部分原岩有明显海底热水同沉积特征 ;在矿床之西万家山—张家山应注意寻找硅化石英粗糜棱岩型金矿石。     

土钉支护现场测试及三维数值模拟分析

在进行土钉轴力和边坡位移测试的基础上 ,进行了土钉支护的三维数值模拟研究 ,对边坡位移、土钉轴力、塑性区分布等分别作了较为深入的探讨 ,认识到土钉与土体相互作用形成了一个完整的支护体系 ;基坑失稳破坏并非传统意义上的土体和土钉的破坏 ,而是土钉支护体系的整体性破坏 ;土钉支护体系的形成正是通过土钉的分担作用、应力传递与扩散作用来实现的 ,这是土钉支护作用的实质.     

城市空间框架数据研究

该文基于地理空间概念和地理信息数字化表达与共享的特点,探讨了框架数据的作用、确定原则,推导出城市空间框架数据体系,即建立城市直接空间参照体系和间接空间参照体系。后者中,基于地块的多尺度无缝不规则网格是整合城市社会经济数据的关键,也是当前城市空间数据基础设施框架数据体系建设中的薄弱环节。