拜城县黑英山霞石正长岩矿物学特征研究

霞石正长岩是重要的炼铝资源和陶瓷、玻璃原料。文中利用扫描电镜、X衍射、红外线、电子探针等,综合分析方法对黑英山霞石正长岩的矿物学特征作了详细研究。着重描述了岩石的矿物组合、矿物生成及变化特征。对主要矿物进行了化学成分及X衍射分析,测得霞石成分:SiO_243.66％,Al_2O_330.97％,K_2O4.23％,Na_2O18.46％(Na_2O高于其它地区的霞石)。根据霞石单矿物实测成分计算出其晶体化学分子式为:(K_(0.525)Na_(3.528)Ca_(0.012))_(4.065)[Cr_(0.010)Al-(3.559)Mg_(0.009)Fe_(0.054)Mn_(0.012)Ti_(0.008)Si_(4.258)O_(16)];测得霞石的主要X衍射d值为:0.302～0.303,0.386～0.389,0.1388～0.1391(nm)。测得微斜长石的成分:SiO_264.82％,Al_2O_319.68％,K_2O11.77％,Na_2O2.30％,求得其三斜度△=0.83～1.00,属低微斜长石。通过霞石正长岩中钾长石与霞石矿物中对K原子分配值计算和作图,解得矿物生成温度为400～500℃。测得岩石中的钠长石主要为低钠长石,属后期交代矿物。     

用路径积分法求解电子的衍射态

本文用费曼的路径积分方法求解出自由电子经狭缝衍射后的量子态及在观察屏处的几率分布，所得结果与光子的夫琅和费衍射相同。     

High-temperature X-ray investigation of natural columbites

Structural investigations at high temperature were carried out on natural columbite samples across the join Fe(Nb_0.95Ta_0.05)₂O₆–Mn(Nb_0.95Ta_0.05)₂O₆. The samples were preliminarily annealed to attain the complete cation-ordered state and avoid the superimposition of the effects of cation ordering during high-temperature studies. Unit-cell parameters of three columbites with different X_Fe content were measured at regular intervals in the temperature range 25–900 °C using single-crystal X-ray diffraction techniques. The crystal structures of completely ordered ferrocolumbite and manganocolumbite were also refined from intensity data collected at room temperature, 300 and 600 °C. Structural thermal expansion coefficients show positive, linear expansion of a, b, c lattice constants and cell volume. In general, slightly higher expansion occurs along a and c directions. However, anisotropy decreases sharply with decreasing Fe content. Reversibility of thermal expansion in the investigated temperature range was checked by high-temperature diffraction studies under heating-up and cooling-down conditions. Impurities do not play an important role in thermal expansion of columbites; expansion coefficients measured on two crystals of the same sample characterized by different Ti content are in fact almost identical. Structural changes with temperature essentially affect bond lengths: volumes of both A and B octahedral sites increase linearly with temperature, whereas interpolyhedral geometrical parameters do not vary significantly.     

共反射面叠加在实际地震资料处理中的应用

共反射面叠加方法运用3个地震波场参数来描述地下反射面元时距关系,不对地下反射界面形状做任何假设,并且是一种不依赖于宏观速度模型的反射波成像方法。共反射面叠加利用了邻近多个共反射点道集的相似性,提高了资料的覆盖次数,从而压制了随机噪声,增强反射波同相轴的连续性,大幅提高了地震资料的信噪比。通过在实际地震资料处理中的应用,证明了该方法的这些特性。     

CGP叠加柱面波偏移成像方法

针对松辽盆地薄砂层油藏的地震勘探问题,提出了一种共检波器接收点(CGP)叠加柱面波偏移成像方法。该方法对小炮点距、小检波器点距、中间放炮观测系统采集地震资料,经CGP道集叠加组合成柱面波剖面;采用下行波射线法向下延拓和上行波波动方程向下延拓的方法,使柱面波剖面偏移成像。通过模型分析和对松辽盆地TK8157测线资料进行处理证明该方法的地震分辨率和保真度较高,在发现小砂体、小断层、地层尖灭等方面有较好的效果。     

从高铝粉煤灰中提取非晶态SiO2的实验研究

为了有效提高高铝粉煤灰的Al/Si比,为提取氧化铝奠定基础,研究了用NaOH从高铝粉煤灰中提取非晶态SiO2的最佳工艺条件,并对提硅反应的机理进行了探讨。首先根据高铝粉煤灰的化学与物相组成特点,确立了利用NaOH提取非晶态SiO2的基本技术路线;然后用正交实验法确定了提硅的最佳条件:NaOH的浓度25%,灰碱质量比1∶0.5,反应温度95℃,反应时间4 h。经最佳条件反应之后,SiO2的提取率达到了41.8%,灰中Al2O3的含量由48.5%增加到了57.38%,Al2O3/SiO2质量比由1.29提高到了2.39。     

土壤、大气尘中晶体的组成及其物源指示意义——以长沙、株洲和湘潭地区为例

基于长沙、株洲和湘潭地区大气尘(可吸入颗粒和近地表积尘)和表层土壤的X-射线衍射(XRD)分析数据,采用微量相鉴定方法获得的结果显示,大气尘和表层土壤中包含石英、石膏、方解石、白云石、硫酸镉等自然矿物及SiS_2、NiTi、Cd_3As_2、FeOCl等非自然源晶体。比较了长沙、株洲、湘潭地区大气尘与表层土壤的晶体组成,分析了大气尘矿物及非自然源晶体的空间分布,探讨了其环境指示意义。     

Thermal alteration of coal in the Khasyn coalfield, Magadan region, Russia

The Early Cretaceous coal deposits of the Khasyn coalfield are intruded by Palaeogene diabase dikes. The coal has vitrinite reflectance values of 2.0–2.5% R_o, and characteristics of normal anthracite at some distance from the dikes, but at direct contact with the dike two morphological coal varieties occur: coal inclusions in the diabase dike and dispersed carbonaceous matter within the dike rock. Both types of coaly matter have properties typical of anthracites: strong anisotropy, altered internal structure and high vitrinite reflectance values ranging from 3.8 to 5.5% R_o. The X-ray diffraction measurements of the interplanar spacing d(002) and the crystallite sizes Lc and La show rather similar values for coal inclusions in the dike and dispersed carbonaceous matter. The additional reflection at 3.37 Å, corresponding to semi-graphite admixture, occurs in the coal and carbonaceous matter inside the dike and is absent in the natural coal outside the dike.     

Simulating coseismic deformation of quartz in the middle crust and fabric evolution during postseismic stress relaxation — An experimental study

Non-steady state deformation and annealing experiments on vein quartz are designed to simulate earthquake-driven episodic deformation in the middle crust. Three types of experiments were carried out using a modified Griggs-type solid medium deformation apparatus. All three start with high stress deformation at a temperature of 400 °C and a constant strain rate of 10^− 4 s^− 1 (type A), some are followed by annealing in the stability field of α-quartz for 14–15 h at zero nominal differential stress and temperatures of 800–1000 °C (type A + B), or by annealing for 15 h at 900 °C and at a residual stress (type A + C).The quartz samples reveal a very high strength > 2 GPa at a few percent of permanent strain. The microstructures after short-term high stress deformation (type A) record localized brittle and plastic deformation. Statisc annealing (type A + B) results in recrystallisation restricted to the highly damaged zones. The new grains aligned in strings and without crystallographic preferred orientation, indicate nucleation and growth. Annealing at non-hydrostatic conditions (type A + C) results in shear zones that also develop from deformation bands or cracks that formed during the preceding high stress deformation. In this case, however, the recrystallised zone is several grain diameters wide, the grains are elongate, and a marked crystallographic preferred orientation indicates flow by dislocation creep with dynamic recrystallisation. Quartz microstructures identical to those produced in type A + B experiments are observed in cores recovered from Long Valley Exploratory Well in the Quaternary Long Valley Caldera, California, with considerable seismic activity.The experiments demonstrate the behaviour of quartz at coseismic loading (type A) and subsequent static annealing (type A + B) or creep at decaying stress (type A + C) in the middle crust. The experimentally produced microfabrics allow to identify similar processes and conditions in exhumed rocks.     

Some remarks on the Gaussian beam summation method

Summary. Recently, a method using superposition of Gaussian beams has been proposed for the solution of high-frequency wave problems. The method is a potentially useful approach when the more usual techniques of ray theory fail: it gives answers which are finite at caustics, computes a nonzero field in shadow zones, and exhibits critical angle phenomena, including head waves. Subsequent tests by several authors have been encouraging, although some reported solutions show an unexplained dependence on the 'free' complex parameter ε which specifies the initial widths and phases of the Gaussian beams.
We use methods of uniform asymptotic expansions to explain the behaviour of the Gaussian beam method. We show how it computes correctly the entire caustic boundary layer of a caustic of arbitrary complexity, and computes correctly in a region of critical reflection. However, the beam solution for head waves and in edge-diffracted shadow zones are shown to have the correct asymptotic form, but with governing parameters that are explicitly ε-dependent. We also explain the mechanism by which the beam solution degrades when there are strong lateral inhomogeneities. We compare numerically our predictions for some representative, model problems, with exact solutions obtained by other means.