Garnet crystal plasticity in the continental crust,new example from south Madagascar

Garnet (10 vol.%; pyrope contents 34–44 mol.%) hosted in quartzofeldspathic rocks within a large vertical shear zone of south Madagascar shows a strong grain‐size reduction (from a few cm to ～300 μm). Electron back‐scattered diffraction, transmission electron microscopy and scanning electron microscope imaging coupled with quantitative analysis of digitized images (PolyLX software) have been used in order to understand the deformation mechanisms associated with this grain‐size evolution. The garnet grain‐size reduction trend has been summarized in a typological evolution (from Type I to Type IV). Type I, the original porphyroblasts, form cm‐sized elongated grains that crystallized upon multiple nucleation and coalescence following biotite breakdown: biotite + sillimanite + quartz = garnet + alkali feldspar + rutile + melt. These large garnet grains contain quartz ribbons and sillimanite inclusions. Type I garnet is sheared along preferential planes (sillimanite layers, quartz ribbons and/or suitably oriented garnet crystallographic planes) producing highly elongated Type II garnet grains marked by a single crystallographic orientation. Further deformation leads to the development of a crystallographic misorientation, subgrains and new grains resulting in Type III garnet. Associated grain‐size reduction occurs via subgrain rotation recrystallization accompanied by fast diffusion‐assisted dislocation glide. This plastic deformation of garnet is associated with efficient recovery as shown by the very low dislocation densities (10¹⁰ m^?3 or lower). The rounded Type III garnet experiences rigid body rotation in fine‐grained matrix. In the highly deformed samples, the deformation mechanisms in garnet are grain‐size‐ and shape‐dependent: dislocation creep is dominant for the few large grains left (>1 mm; Type II garnet), rigid body rotation is typical for the smaller rounded grains (300 μm or less; Type III garnet) whereas diffusion creep may affect more elliptic garnet (Type IV garnet). The P–T conditions of garnet plasticity in the continental crust (≥950 °C; 11 kbar) have been identified using two‐feldspar thermometry and GASP conventional barometry. The garnet microstructural and deformation mechanisms evolution, coupled with grain‐size decrease in a fine‐grained steady‐state microstructure of quartz, alkali feldspar and plagioclase, suggests a separate mechanical evolution of garnet with respect to felsic minerals within the shear zone.     

Late-Hercynian shearing during crystallization of granitoid magmas (Sila massif,southern Italy): regional implications

Shearing of regional extent, involving granitoids and underlying mid-crustal rocks of the Sila massif (Calabria, Italy), is analysed in this paper. The deformed granitoids are affected by a wide NNW-SSE oriented deformation zone, stretching for about 60 km, from the neighbourhood of Cecita Lake to Cropani village. Meso- and micro-structures in granitoids, close to the boundary with underlying migmatitic paragneiss, indicate that deformation developed from melt-present to solid-state conditions. Simultaneous tectonics and magmatism activated a plutonic accretionary process at mid-crustal levels. This took place at about 300 Ma and involved hybrid magmas with a dominat contribution from a mantle source. The deformation regime remained steady for a long time during magma crystallization and cooling in subsolidus conditions. The regional top-to-the-W sense of shear in the present geographic coordinates, recorded in the deformed granitoids, seems geometrically consistent with the coeval direction of maximum extension found in another sector of the southern Hercynian belt, suggesting the original position of the Sila basement in this context. Magmatic ativity ended with the intrusion of mafic and felsic magams affected by a very weak deformation, ongoing during the final strain increments of the late-Hercynian stage.     

新疆特克斯-昭苏地震断层的发现及有关问题的讨论

1986年作者在特克斯-昭苏盆地首次发现长70公里、最大垂直和水平位移均达8米的地震断裂带和地震形变现象,并认为是1716年地震时形成的。地震断裂带的展布和运动方式,与科博河-昭管处断裂相一致。特克斯断裂带是一条复杂的断裂带,它由多条断裂组成。1716年地震表明该断裂带具有新的活动性     

Structure and subduction processes along the Oregon-Washington margin

Seismic reflection and refraction data off Washington and Oregon are used to determine the style of sediment deformation and to infer the physical properties of accreted sediments on the lower slope. Onshore-offshore seismic refraction data off Washington are used to determine the location of the trench, or where the plate bending starts.We find that off Washington the subduction zone is characterized by a trench whose physiographic expression is buried under several kilometers of sediments and is tens of kilometers landward of the lower slope, which is accreting seaward as the result of the offscraping of sediments.Seismic reflection data support previous observations that offscraping occurs along seaward and landward dipping thrust faults. Refraction data indicate that a sediment package thrust up along a seaward dipping fault (off Washington) was not measurably changed in velocity with respect to a Cascadia basin section. However a package uplifted by thrusting along a landward dipping fault (off Oregon) did have increased velocity. It is suggested that the increased velocities off Oregon could be the result of erosion and exposure of more deeply buried and compacted sediments, rather than the result of dewatering due to tectonic stress. Off Washington the sensitivity of velocity to porosity and resolution of the seismic method does not preclude dewatering due to tectonic stress, but it does limit the degree of dewatering.In the deeper parts of the lower slope section off Washington and Oregon velocities as high as 3 to 4 km/sec are found. Heat flow data indicate that the temperatures in this high velocity regime are greater than 100°C. It is hypothesized that lithification related to clay diagenesis may be partly responsible for the high velocities, rather than simply compaction. It also appears that the high velocity sediments are subducted while the unlithified low velocity sediments are offscraped.     

大别变质地体的构造样式及变形序列

大别山区晚太古代大别群变质岩系,经历了复杂的变形过程。在大别变质地块内部识别出两套大型剪切带,它们在该区构造格架形成过程中起着重要的作用。本文还分析了变质的上壳岩、片麻岩和剪切带内的变形特点。实际资料说明,剪切带内的褶皱是由于剪切的不稳定性及平行面理局部缩短形成的,这些大型地壳剪切作用多伴随有挤压流动或伸展流动。根据褶皱叠加关系以及剪切带、新成体交切关系建立了大别群总体构造序列。该区提供了一个研究中下地壳作用的窗口。     

Organic matter of the Mulhouse Basin, France: a synthesis

The lower Oligocene evaporite sequence of the Mulhouse Basin (France) contains organic matter-rich marl deposits. These marls display an overall cyclic variation of sedimentation rate, organic carbon content, hydrogen index and selected molecular parameters over a 30 m thick stratigraphic interval. The integration of all sedimentological and geochemical parameters has allowed the reconstruction and characterization of the paleoenvironment of deposition. The marls were deposited in a perennial lake that was at times connected to the sea. Two organic facies end members could be assigned to a lake stage with a marine connection and a lake stage that received dominantly continental water input. The overall stratigraphic variation in the organic matter content is interpreted to reflect the adaptation of the Oligocene flora to the changing paleoclimate and environmental conditions.     

非线性弹性模型的改进

本文在邓肯-张模型进行深入探讨的基础上,提出了切线模量实质物理意义是剪切模量的观点,并分别采用应力法和应变法推导了剪切模量和体积模量(或变形模量)公式,还进行了考虑Biot固结非线性弹性油罐地基有限元实例分析。对不同的变形模量计算方法进行了比较,提出了改进的非线性弹性模型。     

井下巷道围岩变形的散斑分析法

通过对散斑计量法原理分析、数学描述及观测实例的论述，证明激光散斑法是研究煤矿地下结构物相似模型变形状态的一种新的无损检测技术，若采用白光作为光源，该项技术可用于二维变形场的实地测试。     

Tectonic evolution of lower crustal rocks in an exposed magmatic arc section in the Hidaka metamorphic belt, Hokkaido, northern Japan

Abstract : The Hidaka metamorphic belt consists of an island-arc assembly of lower to upper crustal rocks formed during early to middle Paleogene time and exhumed during middle Paleogene to Miocene time. The tectonic evolution of the belt is divided into four stages, D₀rs, D₁, D₂rs, and D₃, based on their characteristic deformation, metamorphism, and igneous activity. The premetamorphic and igneous stage (D₀) involves tectonic thickening of an uppermost Cretaceous and earliest Tertiary accretionary complex, including oceanic materials in the lower part of the complex. D₁ is the stage of prograde metamorphism with increasing temperatures at a constant pressure during an early phase, and with a slight decrease of pressure at the peak metamorphic phase, accompanying flattening of metamorphic rocks and intrusions of mafic to intermediate igneous rocks. At the peak, incipient partial melting of pelitic and psammitic gneisses took place in the amphibolite–granulite facies transition zone, the melt and residuals cutting the foliations formed by flattening. In the deep crust, large amounts of S-type tonalite magma formed by crustal anatexis, intruded into the granulite facies gneiss zone and also into the upper levels of the metamorphic sequence during the subsequent stage. During D₁ stage, mafic and intermediate magmas supplied and transported heat to form the arc-type crust and at the same time, the magmatic underplating caused extensional doming of the crust, giving rise to flattening and vertical uplifting of the crustal rocks. D₂ stage is characterized by subhorizontal top-to-the-south displacement and thrusting of lower to upper crustal rocks, forming a basal detachment surface (décollement) and duplex structures associated with intrusions of S-type tonalite. Deformation structures and textures of high-temperature mylonites formed along the décollement, as well as the duplex structures, show that the D₂ stage movement occurred under a N-S trending compressional tectonic regime. The depth of intra-crustal décollement in the Hidaka belt was defined by the effect of multiplication of two factors, the fraction of partial melt which increases downward, and the fluid flux which decreases downward. The crustal décollement, however, might have extended to the crust-mantle boundary and/or to the lithosphere and asthenosphere boundary. The subhorizontal movement was transitional to a dextral-reverse-slip (dextral transpression) movement accompanied by low-temperature mylonitization with retrograde metamorphism, the stage defined as D₃. The crustal rocks from the basal décollement to the upper were tilted eastward on the N–S axis and exhumed during the D₃ stage. During D₂ and D₃ stages, the intrusion of crustal acidic magmas enhanced the crustal deformation and exhumation in the compressional and subsequent transpressional tectonic regime.