川藏公路二郎山隧道和平沟泥石流特征研究与治理设计

泥石流作为地质环境较差的山区的主要自然灾害之一,对于泥石流的研究思路的进一步发展和完善,在很大程度上将对山区的工程建设有很重要的指导意义。从工程地质研究思路的角度出发,对位于川藏公路二郎山隧道西口和平沟泥石流进行了研究。采用工程地质分析的方法对和平沟泥石流的形成环境(地层岩性条件、构造条件、地貌条件、气象条件、植被发育及人类活动)、基本特征(泥石流沟的基本特征、泥石流的堆积特征)进行了系统的研究,并在此基础上对泥石流沟沿岸的岸坡稳定性(可能泥石流的物源)等进行了评价分析。对泥石流的活动趋势以及可能泥石流的方量做出了较为科学的评价预测。经过这样的系统分析对工程建设中的泥石流防治提出了治理设计方案。     

大渡河次级支流斯合沟泥石流特征研究

泥石流作为地质环境较差、的山区的主要自然灾害之一，对它的研究尤其是泥石流规律方面的研究已取得了较大的成绩。但是对于泥石流的研究思路却有待进一步发展和完善，这在很大程度上将对山区的工程建设有很重要的指导意义。论文从工程地质研究思路的角度出发，对位于大渡河支流官料河上某水电站下闸址区的斯合沟泥石流进行了研究。文中采用工程地质分析的方法对大渡河次级支流斯台沟泥石流的形成环境(地层岩性条件、构造条件、地貌条件、气象条件、植被发育及人类活动)、基本特征(泥石流沟的基本特征、泥石流的堆积特征)进行了系统的研究，提出了该泥石流的形成演化过程及其机制模型(初期是堰塞式沟谷型泥石流，后期逐渐转向汇聚式沟谷型泥石流)。并在此基础上对泥石流沟沿岸的岸坡稳定性(可能泥石流的物源)等进行了评价分析。将定性分析和定量分析相结合，对泥石流的活动趋势以及可能泥石流的体积(未来泥石流形成将主要是在面蚀和沟蚀作用下的坡面泥石流。泥石流规模较小，且由于沟谷中下游坡降的进一步减缓，形成的泥石流物质一般将沿途停积．实际进入官料河内的体积很小)做出了较为科学的评价预测。经过这样的系统分析对工程建设中的泥石流防治有着积极的指导意义。     

澜沧江中游某崩塌堆积体变形空间效应研究

某崩塌堆积体范围内布置有公路、缆机平台、电站进水口等重要建筑物。其变形稳定性直接影响到治理工程设计、施工安全以及电站的运行。因此，文章在对其环境地质条件、物质结构、形成机制分析的基础上，对其变形空间效应作系统的地质分析；并建立了相应的三维地质力学模型，应用FLAC-3D快速拉各朗日差分程序对其空间变形特征进行了详细的分析。结果表明：收口转向及变形收敛特征使得堆积体下部形成一个“支撑拱”，从而阻碍了上部堆积体向下部的变形与位移，利于堆积体的稳定；同时，三维数值模拟结果也表明：堆积体的变形具有明显的空间效应。其位移矢量表现出一定的收敛性，且变形主要分布在1360～1650m高程；变形方式表现出一定的分区特征，表现出后缘压缩固结，中部滑移，前缘受阻压缩的位移特征。纵向具有明显的收口效应；横向上比较来看，也存在变形受阻的收口特征；收口范围主要集中在1330～1440m高程范围。     

Wood storage in a wide mountain river: case study of the Czarny Dunajec,Polish Carpathians

Storage of large woody debris in the wide, mountain, Czarny Dunajec River, southern Poland, was investigated following two floods of June and July 2001 with a seven‐year frequency. Within a reach, to which wood was delivered only by bank erosion and transport from upstream, wood quantities were estimated for eighty‐nine, 100 m long, channel segments grouped into nine sections of similar morphology. Results from regression analysis indicated the quantity of stored wood to be directly related to the length of eroded, wooded banks and river width, and inversely related to unit stream power at the flood peak. The largest quantities of wood (up to 33 t ha^?1) were stored in wide, multi‐thread river sections. Here, the relatively low transporting ability of the river facilitated deposition of transported wood while a considerable length of eroded channel and island banks resulted in a large number of trees delivered from the local riparian forest. In these sections, a few morphological and ecological situations led to the accumulation of especially large quantities of wood within a small river area. Very low amounts of wood were stored in narrow, single‐thread sections of regulated or bedrock channel. High stream power facilitated transport of wood through these sections while the high strength of the banks and low channel sinuosity prevented bank retreat and delivery of trees to the channel. Considerable differences in the character of deposited wood existed between wide, multi‐thread channel sections located at different distances below a narrow, 7 km long, channellized reach of the river. Wood deposited close to the downstream end of the channellized reach was highly disintegrated and structured into jams, whereas further downstream well preserved shrubs and trees prevailed. This apparently reflects differences in the distance of wood transport and shows that in a mountain river wider than the height of trees growing on its banks, wood can be transported long distances along relatively narrow, single‐thread reaches but is preferentially deposited in wide, multi‐thread reaches. Copyright © 2005 John Wiley & Sons, Ltd.     

Prediction of ground displacements and velocities from groundwater level changes at the Vallcebre landslide (Eastern Pyrenees, Spain)

In active landslides, the prediction of acceleration of movement is a crucial issue for the design and performance of warning systems. The landslide of Vallcebre in the Eastern Pyreenes, Spain, has been monitored since 1996 and data on rainfall, groundwater levels and ground displacements are measured on a regular basis. Displacements observed in borehole wire extensometers have shown an immediate response of the landslide to rainfall episodes. This rapid response is likely due to the presence of preferential drainage ways. The occurrence of nearly constant rates of displacement in coincidence with steady groundwater levels suggests the presence of viscous forces developed during the movement. An attempt to predict both landslide displacements and velocities was performed at Vallcebre by solving the momentum equation in which a viscous term (Bingham and power law) was added. Results show that, using similar rheological parameters for the entire landslide, computed displacements reproduce quite accurately the displacements observed at three selected wire extensometers. These results indicate that prediction of displacements from groundwater level changes is feasible.     

泥石流运动衰减动力学初步研究

我国公路泥石流病害严重，泥石流淤埋公路构建筑物是一类常见的公路泥石流病害类型。泥石流衰减动力学是防治泥石流淤埋病害的重要关键技术，也是泥石流运动学、动力学研究的核心问题之一。本文作者运用泥沙运动力学及流体力学原理，初步建立了泥石流固相颗粒和液相浆体的能量衰减条件，把泥石流衰减模式概化为两类，即能量抑制衰减和能量自由衰减；通过泥石流沉积模型试验，得到了不同粘度泥石流体的沉积扇变化形态，随着泥石流体粘度的增大，沉积扇边缘变陡、扩展范围变小、纵轴线长度减小等结论与实际情况吻合；初步建立了泥石流能量衰减速率计算方法。研究成果为防治公路泥石流病害奠定了基础。     

Autogenic avulsion,channelization and backfilling dynamics of debris‐flow fans

Alluvial fans develop their semi‐conical shape by quasi‐cyclic avulsions of their geomorphologically active sector from a fixed fan apex. On debris‐flow fans, these quasi‐cyclic avulsions are poorly understood, partly because physical scale experiments on the formation of fans have been limited largely to turbidite and fluvial fans and deltas. In this study, debris‐flow fans were experimentally created under constant extrinsic forcing, and autogenic sequences of backfilling, avulsion and channelization were observed. Backfilling, avulsion and channelization were gradual processes that required multiple successive debris‐flow events. Debris flows avulsed along preferential flow paths given by the balance between steepest descent and flow inertia. In the channelization phase, debris flows became progressively longer and narrower because momentum increasingly focused on the flow front as flow narrowed, resulting in longer run‐out and deeper channels. Backfilling commenced when debris flows reached their maximum possible length and channel depth, as defined by channel slope and debris‐flow volume and composition, after which they progressively shortened and widened until the entire channel was filled and avulsion was initiated. The terminus of deposition moved upstream because the frontal lobe deposits of previous debris flows created a low‐gradient zone forcing deposition. Consequently, the next debris flow was shorter which led to more in‐channel sedimentation, causing more overbank flow in the next debris flow and resulting in reduced momentum to the flow front and shorter runout. This topographic feedback is similar to the interaction between flow and mouth bars forcing backfilling and transitions from channelized to sheet flow in turbidite and fluvial fans and deltas. Debris‐flow avulsion cycles are governed by the same large‐scale topographic compensation that drives avulsion cycles on fluvial and turbidite fans, although the detailed processes are unique to debris‐flow fans. This novel result provides a basis for modelling of debris‐flow fans with applications in hazards and stratigraphy.