三种红层岩石常规三轴压缩下的强度与变形特性研究

利用MTS815Teststar程控伺服岩石力学试验系统研究了川东地区一红层边坡中的砂岩、粉砂岩和泥岩围压为03MPa的应力-应变全过程曲线,建立了峰值强度、峰值强度前弹性模量以及峰值强度后的弹性模量和围压的关系。将低围压下红层的全应力-应变曲线概化成5个阶段,分别为压密段、弹性段、屈服段、应变软化段和塑性流动阶段。试验结果得出,红层弹性模量随围压的增加而提高且变化明显,砂岩和粉砂岩在此围压内为脆性破坏,泥岩为塑性破坏的规律。     

Logistic regression versus artificial neural networks: landslide susceptibility evaluation in a sample area of the Serchio River valley,Italy

This article presents a multidisciplinary approach to landslide susceptibility mapping by means of logistic regression, artificial neural network, and geographic information system (GIS) techniques. The methodology applied in ranking slope instability developed through statistical models (conditional analysis and logistic regression), and neural network application, in order to better understand the relationship between the geological/geomorphological landforms and processes and landslide occurrence, and to increase the performance of landslide susceptibility models. The proposed experimental study concerns with a wide research project, promoted by the Tuscany Region Administration and APAT-Italian Geological Survey, aimed at defining the landslide hazard in the area of the Sheet 250 “Castelnuovo di Garfagnana” (1:50,000 scale). The study area is located in the middle part of the Serchio River basin and is characterized by high landslide susceptibility due to its geological, geomorphological, and climatic features, among the most severe in Italy. Terrain susceptibility to slope failure has been approached by means of indirect-quantitative statistical methods and neural network software application. Experimental results from different methods and the potentials and pitfalls of this methodological approach have been presented and discussed. Applying multivariate statistical analyses made it possible a better understanding of the phenomena and quantification of the relationship between the instability factors and landslide occurrence. In particular, the application of a multilayer neural network, equipped for supervised learning and error control, has improved the performance of the model. Finally, a first attempt to evaluate the classification efficiency of the multivariate models has been performed by means of the receiver operating characteristic (ROC) curves analysis approach.     

The seasonal range of sea temperature on the New Zealand shelf

Sea water temperatures measured over the New Zealand continental shelf in summer and winter 1967 are compared and discussed.     

A System for Fast Cartographic Sounding Selection

Soundings on nautical charts provide information about the shape of the ocean bottom between chart depth curves. A single chart may have thousands of soundings posted on it. This article describes a system for automatic cartographic sounding selection. In this system, a new algorithm for automated selecting soundings is developed. The algorithm is employed in such a way that it can guarantee (a) fast and accurate selecting sounding, (b) processing the circular depth curves, (c) solving the overplotting problems between depth curves and soundings, and (d) keeping selected soundings “prettier.” The system was intensively tested using real data sets, and its superiority has been revealed by the testing results.     

考虑双轴水平力耦合效应的RPC箱型桥墩恢复力模型试验研究

通过3个施加常轴力的RPC箱型桥墩试件的水平反复荷载试验,考虑水平荷载作用方向对RPC箱型墩抗震性能的影响,分析各试件滞回特性和骨架曲线的特点,对影响RPC箱型桥墩恢复力模型的主要因素进行数值回归分析,建立了计入双轴水平力耦合效应的RPC箱型桥墩恢复力模型。利用基于平截面假定的纤维模型法编制考虑轴力二阶效应的双轴压弯构件非线性分析程序,并对RPC箱型桥墩试件的骨架曲线和滞回曲线进行数值模拟。通过与试验结果进行分析对比表明:所提出的恢复力模型具有较好的精确性,能够较好地模拟和反映RPC箱型桥墩的抗震性能。     

大亚湾浮游植物光合作用特征

利用Phyto-PAM测量大亚湾浮游植物的光合作用能力、非化学淬灭并建立快速光曲线,同时研究浮游植物群落结构、组成、丰度和相应的环境因素,分析光合作用特征与浮游植物生长和分布的耦合关系。本次调查期间大亚湾浮游植物以集群化硅藻为优势物种,各站位最大光量子收益达到0.72。大亚湾浮游植物适应高光强,当光照达到1000μE/(m2.s)时电子传递速率逐渐达到饱和;光照达到1500μE/(m2.s)浮游植物依然可进行光合作用,叶黄素循环保护光合器官使其免受高光强损伤;当光照达到1700μE/(m2.s)时,光合器官可能受到损伤,此时电子传递速率下降,实际光量子收益接近于0。集群化硅藻能够耐受较广的光照范围及其活跃的光合特征有利于它们在全球海区的广泛分布。     

Construction of a ‘global standardised growth curve’ (gSGC) for infrared stimulated luminescence dating of K-feldspar

We investigated the infrared stimulated luminescence (IRSL) and post-infrared IRSL (pIRIR) signals emitted by K-feldspars from sedimentary samples from Asia, Europe and Africa using a single-aliquot multiple elevated temperature (MET) stimulation procedure. For separate aliquots of the same sample, we show that variation among the dose response curves (DRCs), or growth curves, constructed from the regenerative dose signal (L_x), the test dose signal (T_x, an indicator of luminescence sensitivity) and the sensitivity-corrected signal (L_x/T_x) can be largely eliminated by normalising the DRCs using one of the regenerative dose signals; we call this procedure ‘regenerative-dose normalisation’ or re-normalisation. Furthermore, for the MET-pIRIR signals measured at 250 °C, we find that different samples have re-normalised DRCs that follow the same growth function, despite the samples differing significantly in terms of their geological provenance, sedimentary context, equivalent dose (D_e) and luminescence sensitivity. This common feature offers the potential to establish a ‘global standardised growth curve’ (gSGC) for different samples of K-feldspar, and thereby enable D_e values to be estimated for a large number of single aliquots by projecting the re-normalised natural signals on to the gSGC. For the 18 samples investigated in this study, we find that D_e estimates obtained from the gSGC are consistent with those obtained using full single-aliquot regenerative dose (SAR) procedures for doses of up to ∼1600 Gy. The establishment of a gSGC would greatly reduce the time required to date older samples using K-feldspar, as regenerative doses of several hundreds to a few thousands of Gy are typically delivered to each aliquot in each SAR cycle.     

Assessment of various CPT based liquefaction severity index frameworks relative to the Ishihara (1985) H1–H2 boundary curves

The objective of the study presented herein is to develop an understanding of the predictive trends of four different liquefaction severity index frameworks, with emphasis on the utility of the frameworks for assessing liquefaction vulnerability in Christchurch, New Zealand. Liquefaction induced land damage was widespread following the four major earthquakes in Christchurch (M_w 5.9–7.1) between 4 September 2010 and 23 December 2011. As part of the rebuilding effort, a major focus, to date, has been on assessing/developing approaches for evaluating vulnerability to liquefaction induced damage in future events. The four liquefaction severity index frameworks that are evaluated herein are: the one-dimensional volumetric reconsolidation settlement (S_V1D), the Liquefaction Potential Index (LPI), and two new liquefaction severity indices developed following the major earthquakes in Christchurch, namely the Ishihara inspired LPI (LPI_ISH) and the Liquefaction Severity Number (LSN). To assess the predictive trends of the four severity index frameworks, the H₁–H₂ boundary curves developed by Ishihara (1985) are used as a reference of comparison. In large part, the severity index frameworks serve the same purpose as the Ishihara boundary curves, but they alleviate some of the difficulties in implementing the Ishihara boundary curves for assessing the highly stratified soil profiles that underlie much of Christchurch. A parametric study was performed wherein relatively simple soil profiles are evaluated using all the procedures and contour plots of calculated S_V1D, LPI, LPI_ISH, and LSN values were superimposed onto the Ishihara boundary curves. The results indicate that the LPI_ISH and LSN indices yield similar trends as the Ishihara boundary curves, whereas the S_V1D and LPI indices do not. Furthermore, little field data is available to assess the severity indices for the scenarios where the trends in the LPI_ISH and LSN indices differ.     

Framework for the derivation of analytical fragility curves and life cycle cost analysis for non-seismically designed buildings

The quantification of the devastating effects of earthquakes on buildings can be achieved with the use of earthquake risk assessment. The formulation of strategies to minimise this risk is a complex task which relies on data regarding mainly the hazard, vulnerability and remaining life of the building. In this paper, the case study of Limassol municipality is presented. Initially, the building inventory and categorisation is defined followed by the selection of hazard scenarios and the development of analytical vulnerability curves. In the final part, risk assessment is performed leading to the formulation of retrofitting strategies for long term use.     

Seismic performance of an unreinforced masonry building: An experimental investigation

This paper presents the results of an experimental investigation carried out to investigate the seismic performance of a two storey brick masonry house with one room in each floor. A half‐scale building constructed using single wythe clay brick masonry laid in cement sand mortar and a conventional timber floor and timber roof clad with clay tiles was tested under earthquake ground motions on a shaking table, first in the longitudinal direction and then in the transverse direction. In each direction, the building was subjected to different ground motions with gradually increasing intensity. Dynamic properties of the system were assessed through white‐noise tests after each ground motion. The building suffered increasing levels of damage as the excitations became more severe. The damage ranged from cracking to global/local rocking of different piers and partial out‐of‐plane failure of the walls. Nevertheless, the building did not collapse under base excitations with peak ground acceleration up to 0.8g. General behaviour of the tested building model during the tests is discussed, and fragility curves are developed for unreinforced masonry buildings based on the experimental results. Copyright © 2009 John Wiley & Sons, Ltd.