深海6000 m拖曳式瞬变电磁系统及其应用

针对我国西南印度洋合同区热液硫化物矿快速、有效以及便捷地质勘探装备的要求,研发了由甲板控制系统、万米光电复合缆、仪器舱拖体和天线拖体组成的深海6000 m拖曳式瞬变电磁系统.为了便于拖体布放和快速发现异常,选择重叠回线收发装置类型;采用理论数值计算确定了在拖曳高度不大于50 m的前提下,观测1~100 ms窗范围内的二次场响应,可以发现近海底深海热液硫化物矿堆;另外,通过不同拖延深度海上试验,研究了拖曳深度对瞬变电磁的影响规律及仪器性能.大洋第30航次第二航段在西南印度洋脊热液区,应用该系统发现了明显的瞬变电磁异常.印证了系统的有效性.

     

野外组装可移动式防直击雷装置的研究

通过对9m×9m的实际接地网进行计算,对于二类和三类防雷建筑物,可以应用当环形接地网的等效面积大于78.5m2后,采取不计接地网接地电阻的设计方法来实现野外可移动式接地网设计,并将避雷针和避雷线组合的接闪器设计成标构件,方便组装,实现野外组装可移动式防直击雷装置.     

同心补偿式直升机时间域航空电磁法吊舱校准装置研究

直升机时间域航空电磁法(Helicopter-borne time-domain electromagnetic method,HTEM)的多次空中仪器校准可消除飞行过程中仪器系统受外界环境的时变影响.吊舱校准装置可解决地面环线方式无法实现的空中飞行过程中仪器校准问题.本文从研究同心补偿吊舱装置模型出发,提出了吊舱装置空间模型和线圈电路模型,分析了发射磁场的空间分布、补偿环作用及其与接收线圈的关系、校准装置的空间信息和信号的检测方法,得到结论如下:(1)以损失发射面积0.89%的补偿环可提高信号44.5 dB的动态范围;(2)校准装置水平安置在补偿环与发射线圈之间,其匝数越多、半径越大、离补偿环越近,信号响应越强;(3)校准线圈电感越大、电阻越小,其e指数衰减越慢;信号检测起点由含匹配电阻接收线圈的阻尼特性决定.通过校准线圈的曲线特性和装置位移实验,得出反映装置特性的时间常数实测误差小于1.3%,验证了线圈电路模型和装置空间模型.本文提出的模型和方法同样适用于偏心补偿式HTEM系统校准的研究和高阻地层上已知环线的静态检测.     

电涌保护器级间退耦元件的选型分析

针对电涌保护器（SPD）级间能量配合试验中配合失效的问题,主要利用波的传输理论与基尔霍夫定律进行分析,结合JB/T 10618-2006（组合式电涌保护器）的规定假设一套组合型SPD,通过基础理论分析与精确计算得出：当被保护装置属于低频（直流）设备时,在不影响信号强度的情况下,退耦元件采用电感或电阻型元件均可;当被保护装置属于高频设备时,退耦元件只能选用低电感量的电阻型退耦元件.退耦元件的参数值均可按照波的传输理论与基尔霍夫定律进行理论计算.这在组合型SPD退耦元件的选型过程中,具有重要的指导意义.     

冰层取心回转钻进模拟实验台的设计与测试

极地钻探实践表明,冰盖底部冰岩交界附近地质情况异常复杂,不但可能存在暖冰、基底融水,甚至还存在厚度不等的冰岩夹层,取心钻探异常困难,而优选钻头类型、确定合理的钻进参数是保证其安全、快速钻进的重要因素。本文设计了一套能够模拟冰层回转钻进的实验台,其技术参数为：钻压、转速分别可在0～10 kN、0～300 r/min范围内调节,最大扭矩约100 N·m。该实验台能够测量钻头切削具温度、钻孔深度及钻进速度等参数,为深入研究钻头类型及结构参数、钻进参数对扭矩、钻速和切削温度的影响规律提供了手段。采用PDC复合片钻头进行了冰钻实验,结果表明,实验台能够准确调节钻压和转速,可满足实验要求。     

3500m岩心钻探装备在油气井勘查中的示范应用

3500 m岩心钻探装备（YDX—6型钻机）是我国自主研发的深部矿产资源勘查技术装备,采用N级口径钻深可达3500 m,其最大特点是采用长油缸钻进和起下钻。本文主要介绍了该钻机在油气井勘查中生产试验情况,同时对矿区地层、钻孔结构、钻进过程、钻进效果、遇到的主要问题及解决办法等进行了介绍。     

Loss of energy dissipation capacity from the deadzone in linear and nonlinear viscous damping devices

In a viscous damping device under cyclic loading, after the piston reaches a peak stroke, the reserve movement that follows may sometimes experience a short period of delayed or significantly reduced device force output. A similar delay or reduced device force output may also occur at the damper’s initial stroke as it moves away from its neutral position. This phenomenon is referred to as the effect of “deadzone”. The deadzone can cause a loss of energy dissipation capacity and less efficient vibration control. It is prominent in small amplitude vibrations. Although there are many potential causes of deadzone such as environmental factors, construction, material aging, and manufacture quality, in this paper, its general effect in linear and nonlinear viscous damping devices is analyzed. Based on classical dynamics and damping theory, a simple model is developed to capture the effect of deadzone in terms of the loss of energy dissipation capacity. The model provides several methods to estimate the loss of energy dissipation within the deadzone in linear and sublinear viscous fluid dampers. An empirical equation of loss of energy dissipation capacity versus deadzone size is formulated, and the equivalent reduction of effective damping in SDOF systems has been obtained. A laboratory experimental evaluation is carried out to verify the effect of deadzone and its numerical approximation. Based on the analysis, a modification is suggested to the corresponding formulas in FEMA 356 for calculation of equivalent damping if a deadzone is to be considered.     

Estimation of peak relative velocity and peak absolute acceleration of linear SDOF systems

In the seismic analysis and design of structures, the true velocity and absolute acceleration are usually approximated by their corresponding pseudo-values. This approach is simple and works well for structures with small damping (say, less than 15%). When the damping of a structure is enhanced for the purpose of response reduction, it may result in large analysis and design errors. Based on theory of random vibration and the established mechanism of seismic response spectra analysis, a method is developed (1) to predict the relative velocity spectra with any damping ratio level directly from the 5% standard pseudo-acceleration spectrum; and (2) to estimate the peak absolute acceleration. The accuracy of both is validated by using two selected ensembles of ground motion records.     

浮力装置触发深海管道水平向整体屈曲效果的数值模拟研究

海洋油气资源的运输主要通过海底管道进行,管道在工作时受到较大的温度荷载,会产生整体屈曲变形。深海管道设计中常采用人为装置触发一定程度的水平向整体屈曲变形,来释放轴向的温度应力,浮力装置是常用的触发方式之一。本文通过数值模拟研究,分析了不同浮力大小和不同浮力施加范围下,管道水平向整体屈曲的临界屈曲力,得出临界屈曲力随浮力大小和施加范围变化的情况;并研究了不同土体阻力下,浮力装置触发整体屈曲的效果。研究表明,水平向土体阻力较大时,浮力装置触发水平向整体屈曲的效果较好。浮力装置的触发效果对轴向土体阻力不敏感。     

Parametric study on performance of bridge retrofitted by unseating prevention devices

1 Introduction Structural retro?t techniques (Roberts, 2005), such as restrainers, concrete shear keys, steel jackets, CFRPshells, base isolators, or dampers have been widely studied and implemented in actual structures based on the experiences learned from past earthquakes. In the Chi-Chi earthquake (EERI, 2001), the damage to simply-supported PCI girder bridges provided a different view from which to examine the function of a rubber bearing system for simply- supported bridges (NCREE,…