南京市首级高程控制网的建立及跨江水准的研究

本文首先介绍了南京市首级高程控制网的概况,接着重点讨论了跨江水准测量方法的选择,并全面分析了测距三角高程法影响精度的三个因素,结合南京市首级高程控制网全面介绍了数据处理的有关问题。     

内蒙古桌子山煤田火区特征及灭火方法探讨

内蒙古自治区桌子山煤田赋存着较为稀缺的煤种一焦煤,煤田内存在的火区不仪烧掉了宝贵的焦性煤炭资源,给煤矿生产带来严重的事故隐患,对当地生态环境也造成极大的破坏。经查明区内有26处子火区,分布面积约760万m^2,通过煤田地质特征、煤质特征、地表指示特征、同位素氡气的浓度相对分布特征、物性特征分析了区内煤层发火原因,根据桌子山煤田火区特点,建议采用浅剥、深灌与覆盖相结合的灭火方法,并对火区进行动态监测。     

热液成矿作用的地质地球化学动力学——以胶东牟平-乳山金矿带为例

通过对胶东牟平—乳山热液脉状金,铅锌矿床成矿动力学控制规律的研究,说明了建立热液成矿反应体系的方法,并得出以下认识:（1）区域断裂构造活动,通过影响成矿反应体系的热力学性质和条件,控制元素的富集和分散。（2）热液成矿过程中容矿断裂活动可划分为两种作用方式:脆性破裂和韧—脆性张开,构成热液成矿的两种构造动力学环境。（3）热液成矿反应体系是一种开放的动态的热力学体系。断裂的脆性破裂阶段,使体系处于强烈的过饱和状态,矿质在远离平衡状态下快速结晶,加剧物质分异;在脆—韧性张开阶段,矿质在接近平衡态体系中缓慢晶出。（4）热液演化晚期,金在残余溶液中富集;当断裂再次发生构造脉动震颤时,早期形成的块状黄铁矿矿石碎裂,富金溶液充填其中,形成含裂隙金和晶隙金的富矿石。成矿体系热力学演化与构造动力学条件有利的匹配控制着富矿石的形成。     

地铁施工对济南白泉泉群流量的影响

为研究地铁建设对济南白泉泉群的影响，在综合分析白泉泉域地质、水文地质条件的基础上，假定研究区岩溶强径流带位置及水力性质，利用FEFLOW软件建立地下水流数值模型。以规划地铁M1号线为研究对象，分析了济南东站、梁王站、梁王东站分别施工及3个站同时施工4种情景下，采用施工降水或施工降水+人工回灌两种施工方式对白泉泉群流量的影响。结果表明：单独采用施工降水的施工方式使得白泉泉群流量衰减，其中3个站同时施工对泉流量的影响最大，泉流量最大衰减达5.48%；各站分别施工时，济南东站对泉流量影响最大，泉流量较未施工时减少了0.043×10⁴ m³/d。采用施工降水+人工回灌的施工方式，能够有效缓解泉流量的衰减，各车站施工时的泉流量衰减由仅施工降水时的2.26%~5.48%降低至0.08%~1.21%。岩溶强径流带有利于地下水形成优势径流，促进白泉泉群补给，一定程度上缓解因地铁施工引起的泉流量衰减。     

地下连续墙治理地下水污染

介绍一种治理已被严重污染的地下水的方法。即修建一道底部深入到不透水岩层的地下墙,把污染物封闭在由底部不透水岩层和周围地下防渗墙组成的“地下盆”中,降低周围地下水中有害物质的浓度,然后再治理封闭圈内的污染物,以达到彻底根治地下水污染的目的。     

Numerical analysis of the symmetric methods

Aimed at the initial value problem of the particular second-order ordinary differential equations,y =f(x, y), the symmetric methods (Quinlan and Tremaine, 1990) and our methods (Xu and Zhang, 1994) have been compared in detail by integrating the artificial earth satellite orbits in this paper. In the end, we point out clearly that the integral accuracy of numerical integration of the satellite orbits by applying our methods is obviously higher than that by applying the same order formula of the symmetric methods when the integration time-interval is not greater than 12000 periods.     

Comparison of two methods for seismic hazard assessment in a low-seismicity area

The EGO method, developed by Egozcue et al. and the SRAMSC method, originally developed by Cornell and later programmed by McGuire, to assess the seismic hazard, are compared for the low seismicity area Belgium, The Netherlands, and NW Germany. Using the same input data, the results of the EGO method without the majority criterion and the SRAMSC method with upper bound XII agree very well. The influence of the zoning is investigated for the EGO method. It is not necessary to define the zones for the EGO method so strictly as for the SRAMSC method, but too wide zones can give bad results.     

近50 a渭河流域洪水成因分析及防治对策

 通过对近50 a渭河流域洪水的年际变化、月际变化和潼关高程变化的综合分析得出，造成该流域洪水灾害的原因有降水量年内分配不均和年际变化大，滩面淤积加重，支流河口淤塞以及河势、流态的恶化等。针对这些原因，根据渭河流域洪水灾害的特点，提出了相应的防治措施，即降低下游高程，减少河道的淤积，增大河道泄洪能力；利用水库进行调水调沙，引进客水冲刷渭河下游；防洪工程要除险加固，提高防洪标准与抗洪能力；恢复林草植被，遏止水土流失，从源头上控制泥沙入河等。     

Geophysical methods applied to fault characterization and earthquake potential assessment in the Lower Tagus Valley, Portugal

The study region is located in the Lower Tagus Valley, central Portugal, and includes a large portion of the densely populated area of Lisbon. It is characterized by a moderate seismicity with a diffuse pattern, with historical earthquakes causing many casualties, serious damage and economic losses. Occurrence of earthquakes in the area indicates the presence of seismogenic structures at depth that are deficiently known due to a thick Cenozoic sedimentary cover. The hidden character of many of the faults in the Lower Tagus Valley requires the use of indirect methodologies for their study. This paper focuses on the application of high-resolution seismic reflection method for the detection of near-surface faulting on two major tectonic structures that are hidden under the recent alluvial cover of the Tagus Valley, and that have been recognized on deep oil-industry seismic reflection profiles and/or inferred from the surface geology. These are a WNW–ESE-trending fault zone located within the Lower Tagus Cenozoic basin, across the Tagus River estuary (Porto Alto fault), and a NNE–SSW-trending reverse fault zone that borders the Cenozoic Basin at the W (Vila Franca de Xira–Lisbon fault). Vertical electrical soundings were also acquired over the seismic profiles and the refraction interpretation of the reflection data was carried out. According to the interpretation of the collected data, a complex fault pattern disrupts the near surface (first 400 m) at Porto Alto, affecting the Upper Neogene and (at least for one fault) the Quaternary, with a normal offset component. The consistency with the previous oil-industry profiles interpretation supports the location and geometry of this fault zone. Concerning the second structure, two major faults were detected north of Vila Franca de Xira, supporting the extension of the Vila Franca de Xira–Lisbon fault zone northwards. One of these faults presents a reverse geometry apparently displacing Holocene alluvium. Vertical offsets of the Holocene sediments detected in the studied geophysical data of Porto Alto and Vila Franca de Xira–Lisbon faults imply minimum slip rates of 0.15–0.30 mm/year, three times larger than previously inferred for active faults in the Lower Tagus Valley and maximum estimates of average return periods of 2000–5000 years for M 6.5–7 co-seismic ruptures.     

Discrete numerical modelling of rockfill dams

The aim of this study is to obtain quantitative information on the behaviour of rockfill used in embankment dams, and particularly on the influence of block breakage on the displacement field, from a numerical analysis using the Distinct element method. A methodology is set up to define the resistance of the 2D particles so that the same probability of breaking blocks may be reproduced as in a 3D material. The model uses the discrete element code PFC^2D (Itasca Consulting Group Inc., PFC2D (Particle Flow Code in Two Dimensions), Version 3.0, 2002) and considers breakable clusters of 2D balls. The different parameters are determined from experimental data obtained from laboratory tests performed on rock blocks. The model is validated by comparing the results of the simulation of shearing tests with actual triaxial tests on rockfill material published in the literature. The numerical analysis of block crushing in an actual dam is proposed in the last part of this paper. Copyright © 2006 John Wiley & Sons, Ltd.