基于弹性薄板的地表沉陷预计模型

在分析地表沉陷基本规律的基础上,依据弹性薄板理论,建立非充分采动条件下岩层和地表沉陷预计的一类新模型,并推导出地表任意点倾斜、曲率、水平移动以及水平变形的计算公式。该模型充分考虑到地质采矿因素（煤层倾角）及煤层上方各岩层的影响,克服传统预测方法的缺陷,特别是概率积分法关于拐点反对称要求。最后,应用实例证明该方法的应用效果。     

黄土台缘滑坡地表水入渗问题分析

黄土塬区提灌工程保证了农业生产,却造成了地下水位大幅抬升,使得近年来黄土台缘滑坡不断发生。黄土滑坡一个普遍特征就是后缘发育地裂缝以及落水洞,使地表水（灌溉水以及降雨）直接灌入坡体,诱发了大量黄土滑坡。因此,地表水入渗对于黄土滑坡机理研究以及滑坡防治具有重要意义。文章基于对陕西泾阳南塬黄土滑坡的现场调查,对黄土台缘滑坡地表水入渗工程地质问题进行了初步分析,包括：①地表水入渗与落水洞形成机制;②地表水入渗途径及其与黄土滑坡发育过程的关系;③降雨因素对于黄土滑坡的影响程度。     

框架预应力锚杆边坡支护结构的稳定性分析方法及其 应用

以边坡极限平衡理论及框架预应力锚杆边坡支护结构的圆弧滑动破坏模式为基础,在考虑框架、锚杆对土体边坡稳定性影响的情况下,基于圆弧滑动条分法的思想利用积分法建立了内部稳定性安全系数计算模型和最危险滑移面搜索模型。确定滑移面圆心坐标为几何控制参数,推导了安全系数计算模型中各变量与滑移面圆心坐标之间的函数关系式,从而获得了滑移面几何控制参数与内部稳定性安全系数之间的函数关系。利用网格法对框架预应力锚杆支护结构最危险滑移面的圆心坐标进行动态搜索和求解。最后采用Matlab语言编制了框架预应力锚杆边坡支护结构的稳定性分析程序,并结合工程实例进行了验算,讨论了此种方法的适用条件,结果表明该方法简明适用,较传统的经验分析方法更加合理。     

土地调查中有关城镇与农村土地面积问题的研究

第二次全国土地调查工作中,城镇与农村地区的土地面积在计算方法上有所不同：农村地区的土地面积是以椭球面为基准的面积,即球面面积;城镇地区的土地面积是以平面为基准的面积,即平面面积。二者之间存在差异并按一定规律变化,当调查区处于投影带边缘附近时,同一图斑的球面面积与平面面积之间的差异达到最大。由于采用不同的计算方法而导致面积数量的差异,在进行农村与城镇有关土地数据整合时会出现矛盾。为了建立城乡统一的土地管理信息系统,保证土地面积的一致性,应当采取相应措施消除二者之间的差异。     

Time-dependent stress change during failure of rocks

The energy balance of a solid subject to fracture has been explored using heat and mass transfer equations with regard to the volumetric and superficial components. In the suggested model, brittle fracture of a cracked solid considered as a heterogeneous two-phase medium is described by an equation analogous to the Griffith’s criterion for propagation of a single crack. The derived equation is used, together with estimates of relative change in specific interface area, to study the respective change of free strain energy and pressure in rocks associated with failure.     

浅谈工程测量学的发展

对工程测量学的地位和应用领域,通用和专用仪器的发展,在理论和实践上进行了归纳和总结。简要地叙述了工程测量在国内外的发展情况及其发展趋势。     

Estimation of hydraulic permeability considering the micro morphology of rocks of the borehole YAXCOPOIL-1 (Impact crater Chicxulub,Mexico)

Internal surface, formation factor, Nuclear Magnetic Resonance (NMR)-T2 relaxation times and pore radius distributions were measured on representative core samples for the estimation of hydraulic permeability. Permeability is estimated using various versions of the classic Kozeny–Carman-equation (K–C) and a further development of K–C, the fractal PaRiS-model, taking into account the internal surface. In addition to grain and pore size distribution, directly connected to permeability, internal surface reflects the internal structure (“micro morphology”). Lithologies could be grouped with respect to differences in internal surface. Most melt rich impact breccia lithologies exhibit large internal surfaces, while Tertiary post-impact sediments and Cretaceous lithologies in displaced megablocks display smaller internal surfaces. Investigations with scanning electron microscopy confirm the correlation between internal surface and micro morphology. In addition to different versions of K–C, estimations by means of NMR, pore radius distributions and some gas permeability measurements serve for cross-checking and calibration. In general, the different estimations from the independent methods and the measurements are in satisfactory accordance. For Tertiary limestones and Suevites bulk with very high porosities (up to 35%) permeabilites between 10⁻¹⁴ and 10⁻¹⁶ m² are found, whereas in lower Suevite, Cretaceous anhydrites and dolomites, bulk permeabilites are between 10⁻¹⁵ and 10⁻²³ m².     

Slope inclinometers for landslides

Slope inclinometers/indicators are used to determine the magnitude, rate, direction, depth, and type of landslide movement. This information is usually vitally important for understanding the cause, behavior, and remediation of a landslide. However, many inclinometer measurements fail to achieve these intended aims because of lack of appreciation of the many factors that need to be correctly implemented during installation, monitoring, and data reduction to yield useful data. This paper presents some guidelines for understanding, installing, and interpreting slope inclinometers and presents three case histories that illustrate some of the pitfalls that can develop if these guidelines are not followed.     

地面核磁共振模型约束反演含水层参数

导电模型的地面核磁共振感应电动势是含水量的非线性函数.引入模型约束的迭代反演方法求解该非线性问题的反演.在反演过程中,根据理论公式计算迭代过程中灵敏度矩阵,并采用平坦模型和光滑模型两种约束.对均匀半空间、层状导电模型和实际数据进行了反演模拟,结果表明,模型约束迭代反演方法能从地面核磁共振感应电动势获得含水层较为合理的含水量及分布,且该结果可以从作为初始模型的均匀含水量分布反演得到.对无噪音数据,平坦模型和光滑模型约束对反演的含水量分布影响不大;但当数据存在一定的噪音时,平坦模型约束将比光滑模型约束获得更为精确的含水层参数.     

人工边坡潜在滑动面研究——以广州科学城某人工高边坡为例

运用强度参数的改变对边坡破坏面形迹影响不明显这一特点,在数值模拟过程中通过改变岩体强度参数,有效地获取潜在滑动面的位置和形态,较好地解决了滑动面搜索的难题。将该法应用于广州科学城某人工高边坡稳定性的研究,在三维数值模拟过程中,将强度参数大幅度折减,计算后获得各剖面的剪应变增量图,从这些图中可获得潜在滑动面。这与人们通常将此类边坡的中风化面作为滑动面存在较大差别。将该滑动面运用极限平衡法进行计算,计算结果显示各剖面的安全系数基本都大于1.2,边坡稳定但仍需要加固处理,与三维数值模拟结果相一致。由此认为用这种分析法确定出的潜在滑动面合理、计算结果可靠,可作为搜索边坡潜在滑动面并计算安全系数的方法之一。