中国大陆速度场模型建立方法研究

将中国大陆划分成东北、华北、华南、青藏、西北5个块体,基于克里金插值法、最小二乘配置法、最小二乘配置移动拟合推估法等3种方法及速度场数据研究中国大陆速度场模型建立方法。利用外检点分析不同建模方法的精度情况,最小二乘配置法在大部分块体（华北、华南、东北块体）的拟合精度都较高,表现稳定|克里金插值法在青藏、华北块体的拟合精度较高。利用克里金插值法与最小二乘配置法获取中国大陆1°×1°格网中心点速度场成果,两种方法成果差异较小。     

南海南、北大陆边缘盆地烃源岩热演化差异及成因分析

对横跨南海南、北共轭大陆边缘的两条骨干剖面所经过的沉积盆地烃源岩热演化进行模拟,分析了南、北陆缘盆地烃源岩热演化差异。结果表明,南海南部陆缘盆地生烃门限整体比北部陆缘盆地的生烃门限浅,南部陆缘盆地生烃门限整体在2 200~2 300 m之间,中新统烃源岩基本已进入生烃门限;北部陆缘盆地生烃门限整体位于2 500~2 600 m之间,渐新统及其以下烃源岩进入生烃门限。南海南、北陆缘盆地生烃门限的规律性与南海现今热流分布南高北低、西高东低的整体趋势相对应,高热流有利于烃源岩的成熟与生烃,因此热流值高的区域对应生烃门限较浅。造成南、北陆缘主力烃源岩的热演化程度差异的主要原因可能是由南海扩张及古南海俯冲引起的地温场变化所引起。     

2013年甘肃岷县漳县6.6级地震前后重力场动态变化

利用青藏高原东北缘2011-2013年期间的流动重力观测资料,系统分析了区域重力场动态变化及其与2013年7月22 H岷县漳县6.6级地震发生的关系.结果表明:1)测区内重力场异常变化与主要断裂带在空间上关系密切,反映沿主要断裂带(段)在2011-2013年期间发生了引起地表重力变化效应的构造活动或变形.2)岷县漳县6.6级地震前,测区内先出现了较大空间范围的区域性重力异常,后在震源区附近产生了局部重力异常及重力变化高梯度带,其中,甘肃临夏与岷县一带重力差异变化达150×10 8ms-2以上;这些可能反映岷县漳县地震前,区域及震源区附近均产生与该地震孕育、发生有关的构造运动或应力增强作用.3)重力场1a尺度动态变化图像和差分动态演化图像均反映岷县漳县6.6级地震孕育过程的最后2a出现较显著的流动重力异常变化,地震发生在NE向重力变化高梯度带上、重力变化零值线附近和等值线的拐弯部位.4)基于流动重力异常变化在岷县漳县6.6级地震前做过一定程度的中期预测,尤其是地点判定.     

云南地区中小震分布的活动构造意义

利用2000年1月至2010年11年间云南地震台网有定位结果的19 737个中小地震和从公元前20年至2009年11月共567次破坏地震震中,探讨云南地区地震空间分布与构造活动的关系,结果表明:地震震中密集分布地带是现今活动构造主要位置,地震震中的空间分布具有明显的活动构造意义。     

黑龙江及邻区地壳应力场初步研究

采用综合震源机制方法,利用5 002条P波极性数据反演黑龙江地区二维应力结构,求得该区0.5°×0.5°综合震源机制解.初步研究表明：21世纪以来,构造应力场总特征基本一致,具有明显的继承性,主压应力和主张应力的优势方向明显,与板块运动关系具有成因上的联系.     

江西相山铀矿田邹—石断裂新解

邹—石断裂分布在江西相山铀矿田西部,前人认为是一条重要的成矿构造.本次研究发现矿体并不产于邹—石断裂本身,断裂没有控制矿体几何形态,不是矿质直接充填或交代的地质构造单元,不具成矿构造的特点.由于邹石断裂在地形上呈现线性沟谷,遥感影像图上呈现清晰的线性影像,切错了花岗斑岩.构造岩主要是围岩的破碎角砾、构造透镜体和断层泥,以脆性变形为主,温热水与之关系密切,故认为,邹—石断裂具有新构造活动的踪迹,可能形成于新近纪—第四纪,属矿后构造.     

Chronology and petrogenesis of the Hejiazhuang granitoid pluton and its constraints on the Early Triassic tectonic evolution of the South Qinling Belt

The Hejiazhuang pluton is located in the South Qinling Tectonic Belt(SQTB)in the north side of the Mianxian-Lueyang Suture Zone,and consists dominantly of granodiorites.LA-ICP-MS zircon U-Pb dating and Lu-Hf isotopic analyses reveal that these granodiorites of the Hejiazhaung pluton emplaced at~248 Ma,and show a large variation in zirconεHf(t)values from4.8 to 8.8.These granodiorite samples are attributed to high-K to mid-K calc-alkaline series,and characterized by high SiO2(66.6%–70.0%),Al2O3(15.04%–16.10%)and Na2O(3.74%–4.33%)concentrations,with high Mg#(54.2–61.7).All samples have high Sr(627–751 ppm),Cr(55–373 ppm)and Ni(17.2–182 ppm),but low Y(5.42–8.41 ppm)and Yb(0.59–0.74 ppm)concentrations with high Sr/Y ratios(84.90–120.66).They also display highly fractionated REE patterns with(La/Yb)N ratios of 18.9–34.0 and positive Eu anomalies(δEu=1.10–2.22)in the chondrite-normalized REE patterns.In the primitive mantle normalized spidergrams,these samples exhibit enrichment in LILEs but depletion in Nb,Ta,P and Ti.These geochemical features indicate that the granodioritic magma of the Hejiazhuang pluton was derived from the partial melting of hybrid sources comprising the subducted oceanic slab and sediments,and the melts were polluted by the mantle wedge materials during their ascent.The emplacement ages and petrogenesis of the Hejiazhuang pluton prove that the initial subduction of the Mianlue oceanic crust occurred at~248 Ma ago,and the SQTB was still under subduction tectonic setting in the Early Triassic.     

Evolution of the ductile shear zone of the Paishanlou gold deposits,western Liaoning,China

The combination of field surveys with analysis of microstructure of tectonite and Electron Backscatter Diffraction (EBSD) on quartz fabric indicated that three periods of ductile shear events developed in the Paishanlou gold deposits and the E-W and NE-striking ductile shear zones were formed during each event. The E-W-striking ductile shear zone, accompanied by compressional and dextral shear slip, was shear-cut by the NE-striking shear zones, accompanied by compressional-sinistral shear slip and sinistral-normal shear slip, successively. An E-W-striking ductile shear zone developed at a deeper tectonic level and at middle- to high-temperatures, accompanied by abundant microstructures, including microlayering between a polycrystal quartz belt and mica, and quartz deformation was depended on cylinder (10-10) 〈a〉 or 〈c〉 glide. The development of an E-W-striking shear zone can be seen as a tectonic pattern in the region of the Paishanlou gold deposits of the collision between the Mongolian tectonic belt and the North Archean Craton from Suolun to the Linxi suture zone during the Indosinian. The NE-striking ductile shear zone developed approximately 160 Ma during the early Yianshanian at middle to shallow tectonic levels and at middle- to low-temperatures, accompanied by typical microstructures, including polycrystal quartz aggregation and quartz subgrain rotation recrystallization, etc., and quartz deformation was depended on prismatic (1011) 〈a〉 glide. The last ductile shear event around the NE-striking shear zone developed at low temperatures and shallow tectonic levels, yielding to a pre-existing NE-striking shear zone, accompanied by abundant microstructures, including low-temperature quartz grain boundary migration and bulging recrystallization. The last ductile shear movement may be related to lithosphere thinning and the destruction of the North China Craton from approximately 130-120 Ma, and this shear event resulted directly in the mineralization in the Paishanlou region.     

Mesozoic tectono-magmatic activities in South China:Retrospect and prospect

The South China Block was formed through the collisional orogeny between the Cathaysia Block and the Yangtze Block in the Early Neoproterozoic.The northern,western and southern sides of the South China Block were affected by disappearance of the Paleo-Tethyan Ocean during the Paleozoic.The southern and northern sides of the South China Block were respectively collided with the Indo-China Block and North China Block in the latest Paleozoic to form the basic framework of the Eastern China.The Eastern China has been affected by the westward subduction of the Pacific Plate since the Mesozoic.Therefore,the South China Block was influenced by the three major tectonic systems,leading to a superposed compound tectonics.The comparative study of the Mesozoic geology between the South China Block and its surrounding areas suggests that although the Mesozoic South China Block was adjacent to the subduction zone of the western Pacific,no juvenile arc-type crust has been found in the eastern margin.The main Mesozoic geology in South China is characterized by reworking of ancient continental margins to intracontinental tectonics,lacking oceanic arc basalts and continental arc andesites.Therefore,a key to understanding of the Mesozoic geology in South China is to determine the temporal-spatial distribution and tectonic evolution of Mesozoic magmatic rocks in this region.This paper presents a review on the tectonic evolution of the South China Block through summarizing the magmatic rock records from the compressional to extensional tectonic process with the transition at the three juncture zones and using the deformation and geophysic data from the deep part of the South China continental lithosphere.Our attempt is to promote the study of South China’s geology and to make it as a typical target for development of plate tectonic theory.     

叠加褶皱研究进展综述

叠加褶皱作为地壳构造变形中一种常见的地质现象, 对于确定多期变形和构造运动期次, 探讨构造演化历史以及内外生矿床的空间分布、形成与变形特征均有重要研究意义。在回顾叠加褶皱研究历史与近年来取得的主要进展基础上, 系统地总结了叠加褶皱几何学与运动学特征, 指出叠加褶皱主要有纵弯褶皱作用、横弯褶皱作用及剪切褶皱作用3种成因机制。在此基础上, 选取典型的叠加褶皱, 剖析了其构造样式及形成机制, 并探讨了叠加褶皱研究的难点与可行研究方法。